[MusclezMarinara]

Hello all

Trying to install jb4 f95 and I must be losing my mind.

I was following f90 guide and I’m stumped does anyone have guidance or guides to assist in the install?

[Steve @ BMS/Fuel-It!]

If you purchased it new, reach out to the support team with pictures and questions.

[MusclezMarinara]

Yea there support is not that great IMO, they grew lost that personal touch.

I received an email no photos even though via chat they stated they'd send photos videos etc. Again lost the touch.

X5M Tight spaces and I just wish they had a better diagram because there are many connectors that look the same.

Seems also that you cant easily reach the connectors.

https://www.n54tech.com/instructions...b4_install.pdf

Any photos would be appreciated.

Also cant locate a way into the firewall.

[Steve @ BMS/Fuel-It!]

Did you go to the X5M/X6M specific instructions at the bottom of the guide starting on page 27?

https://www.n54tech.com/instructions...b4_install.pdf

Sorry, it is tight which also makes it hard to get good pictures.

[MusclezMarinara]

I ended up figuring out it’s far forward on the X5M as you can see in this photo attached. I just can’t seem to find a location now to push the OBD connector through the firewall which of course burger has not responded on since yesterday morning

[Steve @ BMS/Fuel-It!]

On our X6M, I put it through the door molding, the X's tend to be sealed up a bit better.