 |
|
||||
| |||||
|
||||||
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
(#1)
|
|
||||
Results from 1/2 mile NFZ 2016 Infiniti Q50 Silver Sport -
11-11-2018, 02:50 PM
Another fun day for me at No Fly Zone. Was driving the Q50 this time around.
Was pretty consistent and zero issues. 145mph was best run  . Mods are JB4, BMS intake, BMS heat exchanger and e30 fuel. 413 wheel hp and 412 wheel torque. Stock run was 131mph. Did few back to back runs trying to heatsoak the car and only difference was around 1mph. BMS heat exchanger works awesome! Only 28 degree increase after 5 gears of full throttle from dead stop. From 100 to 128 at the end of the run. All of the runs had around 20min of wait time in the line and some runs where back to back without letting the car cool down. Home of the Worlds fastest N20s, N54s, N55s, N63s, and S63s! It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts. 
|
|
(#2)
|
|
||||
|
11-13-2018, 12:46 PM
Has this car not been dynoed since the three BMS intakes? Tnr dyno says it made that same power before you installed them. No gains from the intake?
Ecutek tuned Infiniti Sport Mufflers
|
|
(#3)
|
|
||||
|
11-13-2018, 01:10 PM
I think the most we've made with this car is around 420whp, have not dyno tested since adding inlets which were also installed. On our to-do list though!
Home of the JB4 the worlds most popular turbocharged tuning system! It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.
|
|
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
Linear Mode
|
|
Copyright © 2007 - 2022, JB4tech.com