 |
|
||||
| |||||
|
|
|
(#1)
|
|
|||
Will this work on N20 EWG? -
09-20-2019, 08:48 AM
Picked this up from a F10 520i owner. I have a few questions which I hope someone could help with:
1. Will this work on my F30 328i N20 with EWG? 2. Can this use the latest firmware? If yes, which one should I flash to? N20_OBDII_PWG_6.hex or N20_OBDII_EWG_6.hex? 3. Can this work with the latest revision of the JB4 connect kit? 4. The harness comes with 4 pairs of connector: rainbow, brown, black and blue. I know for EWG I can skip the blue connectors. How about the black wire connectors? 5. The harness also comes with a ground cable (and I think also a red power cable). Do I need to hook them up? If yes, I assume black to shock tower nut and red to +ve terminal? 6. Anything else I need to make it work? Attached is a picture my JB4 for reference. Sorry for all these questions. Really want this to work for my car. 
|
|
(#2)
|
|
||||
|
09-20-2019, 11:35 AM
No, this is PWG.
Home of the Worlds fastest N20s, N54s, N55s, S55s, N63s, and S63s! It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.
|
|
(#3)
|
|
|||
|
09-20-2019, 02:56 PM
Deleted
|
|
(#4)
|
|
||||
|
09-23-2019, 02:56 PM
DON'T load the EWG firmware as the JB4 is PWG.
You can install as-is and use map 1 and 2 with the PWG firmware on it. You will just skip the boost solenoid connector and install the rest Home of the Worlds fastest N20s, N54s, N55s, N63s, and S63s! It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
Hybrid Mode
|
|
Copyright © 2007 - 2020, N54tech.com