[anti]

Originally Posted by ucsbwsr

Thanks to the OP for the DIY write up and modified brass connector I used both with great results. The only issue was the hose on the media hopper would frequently get backed up with the shells, the worse part is it wasn't overly apparent when it was not shooting shells.

just pull the blaster nozzle out of the intake port adapter with it still open, if you get shells spraying everywhere your still good to go LOL

also use an inline air dryer and make sure to drain the condensation from the bottom of your compressor, the more wet the shells get the more likley to jam up in the mixing valve

[purin]

Guys,

I followed the DIY and completed the cleaning, however need help putting everything back.

I removed a vacuum/breather line completely and not sure what the other end connects to...
http://www.realoem.com/bmw/enUS/show...79#13907600100

13907600100 goes onto the fuel breather thing that attaches to the throttle body. Where does the other end go?

thanks
-p

[purin]

Sorry, found it. it connected to a line that was aft of the power steering canister thing.