[JCB]

Recently added fuel wires and EWG control to my JB4. Car is a 2018 Luxe AWD. Weather was cool this morning in St. Louis - about 65F so I made a couple of runs. Car has never run so well - especially the 2nd run. Unfortunately I ran into traffic and had to cut it short! This is Map 5 with EWG wires set to the suggested default of 50 Duty Cycle, 50FF and 60 AutoShift. 1st run was in Drive, 2nd run I shifted manually between 6000-6500RPM.

Any comments on the log would be appreciated and suggestions for tweaking for further improvement - WG settings, more boost, custom boost map? I have had best results so far on Map 5. I have not tried any custom boost maps since installing the fuel and EWG controls.