View Single Post
(#2)
Old
Payam @ BMS's Avatar
Payam @ BMS Payam @ BMS is offline
Super Moderator
 
Posts: 6,172
Join Date: Oct 2013
Car: e90 335i
Default 10-08-2018, 07:54 AM

Quote:
Originally Posted by naoaki
Hey, guys I have installed jb4 PWG for F10 535i. The condition of the engine is bad and you can not control BC. Of course I followed the installation procedure. As I was investigating, this JB 4 should have a red power line, but it is not. I mailed to BMS support but it seems like a holiday on Sunday and I have no reply. Can anyone give me a complete picture of F10 535i jb4 PWG type A wiring? I am very confused. Thank you in advance for all the responses.
You more than likely have V2 if you have no power wire which is actually better.

BC controls need to be enabled on the 5 series. FUD Bit 1 needs to be enabled.


Burger Motorsports
Home of the Worlds fastest N20s, N54s, N55s, S55s, N63s, and S63s!

It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.
Reply With Quote