View Single Post
Payam @ BMS's Avatar
Payam @ BMS Payam @ BMS is offline
Super Moderator
Posts: 5,573
Join Date: Oct 2013
Car: e90 335i
Default 07-18-2019, 08:39 AM

Originally Posted by TimboBlackkers
I'm just wondering as well, the LOAD as logged by the JB4 seems quite low.

I'm tracing the timing table in the BEF using TunerPro and the load values in my log seem very low.

Load value of 18 at 20psi seems a bit low? Timing is around 8-9 degrees between 4-5000 RPM which would assume load values around 140+ right?

Do I multiply the logged load value by 10 or something? I couldn't see this in the logging parameters guide.

Sorry if I'm way off here.
I'll post my logs once I get some clean pulls in, wet weather has meant no traction recently!
Flash parameters won't change if your pumps are healthy or not

Post a log with the fuel you want to use and start with a lower map.
We'll evaluate and tell you where to go from there.

Burger Motorsports
Home of the Worlds fastest N20s, N54s, N55s, S55s, N63s, and S63s!

It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.
Reply With Quote