View Single Post
(#236)
Old
Terry @ BMS's Avatar
Terry @ BMS Terry @ BMS is online now
Tuner
 
Posts: 29,680
Join Date: Jan 2008
Default 04-08-2015, 12:00 PM

Quote:
Originally Posted by Wedge1967
Be careful with running extra boost without a good supporting DME flash for the DCT. Torque Output is a calculation of load / rpm on the Load To Torque table. LOAD is how the DME calculates power, not just in boost. Running higher boost with the JB4 doesn't allow the DME to see the actual LOAD and your DCT will not have the correct calibrations to hold the power as internal line pressure is increased based on reported Torque Output. I'm not saying your current setup won't work, but I just want to make sure you are using a higher load map which I think Terry has addressed with the newer rom versions.
The trans takes in torque set point and actual torque. You can log it off the trans if you have the right software for a BT cable.

Anyone running a DCT will benefit from our MHD specific back end flash maps though. It's a requirement if using larger than OEM turbos.


Burger Motorsports
Home of the Worlds fastest N20s, N54s, N55s, S55s, N63s, and S63s!

It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.
Reply With Quote