View Single Post
(#1)
Old
FuelTuner's Avatar
FuelTuner FuelTuner is offline
New Member
 
Posts: 1
Join Date: Jan 2008
Car: E90 335i
Default JB4 Kicking out of Map 3 - 05-23-2019, 11:03 AM

Hey everyone,
Whats the parameters that dictate Map 3 kicking out into failsafe condition ?
I have the genaric map 3 settings , except boost cut set to 20 psi
2008 N54 335i
Pure Turbos
JB4 Meth
Intake / ********* , Exhaust , BOV, Intercooler, newplugs
MHD BEF ( pump gas usa )
JB4 meth w/ twin nozzles 70/30 mix
91 oct

I personally dont see anything in the log that would show an issue .... but again I do not know what ultimately causes the map to swap over to map 4 . I did not put this car together , install any parts . So I am assuming that the meth system is funtioning correctly as it shows flow and the system was purged and working .
Car was smoke tested intake and exhaust .
Log is attached.
Boost failsafe 20 psi
Default wg position 60
PID gain 25
Auto shift boost redux 60
FF WG adapt 72
Open Loop 70
Meth safe mode 0
Meth trigger mode 0
Max boost 1st 12
Max boost 2nd 0
Max boost 3rd 0
Attached Files
File Type: csv 2019-05-18 13_23_40_Map-3.csv (8.7 KB, 19 views)


2008 E90 Auto
- JB4
- Code 3 Intercooler
- Ultimate Racing *********
- VK Oil Cooler
- MagnaFlow Exhaust
- Ultimate Racing Intake
- Tien SS-P Coilovers
- Hotchkis swaybars
- Hawk HP pads
- Quaife LSD
-19'' BBS LM
Reply With Quote