View Single Post
(#5)
Old
Payam @ BMS's Avatar
Payam @ BMS Payam @ BMS is offline
Super Moderator
 
Posts: 4,593
Join Date: Oct 2013
Car: e90 335i
Default 09-17-2018, 06:21 AM

Quote:
Originally Posted by CapitaineBeaver
And regarding the install, I was more talking on the connector side of things and not on the EWF itsef (since it easily reachable on the B48 engine).
It's pretty easy, just open Jb4 case and remove harness from board. No special firmware needed.

Insert the pins in the locations on the Db25.

The purple wire (going to the male pin on the wastegate harness) connects to position #9 on the DB25 connector.

The blue wire (going to the female pin on the wastegate harness) connects to position #16 on the DB25 connector.


Burger Motorsports
Home of the Worlds fastest N20s, N54s, N55s, S55s, N63s, and S63s!

It is the sole responsibility of the purchaser and installer of any BMS part to employ the correct installation techniques required to ensure the proper operation of BMS parts, and BMS disclaims any and all liability for any part failure due to improper installation or use. It is the sole responsibility of the customer to verify that the use of their vehicle and items purchased comply with federal, state and local regulations. BMS claims no legal federal, state or local certification concerning pollution controlled motor vehicles or mandated emissions requirements. BMS products labeled for use only in competition racing vehicles may only be used on competition racing vehicles operated exclusively on a closed course in conjunction with a sanctioned racing event, in accordance with all federal and state laws, and may never be operated on public roads/highways. Please click here for more information on legal requirements related to use of BMS parts.
Reply With Quote