View Single Post
WaqasRiyami's Avatar
WaqasRiyami WaqasRiyami is offline
Junior Member
Posts: 354
Join Date: Sep 2017
Car: Bmw 535i - 2011
Default 01-16-2018, 03:14 PM

Originally Posted by Marlinman
Waqas....did you keep the slower speed CANbus enabled still? Or did the FW actually make it so that you could disable it and ran fine?
I tried both ways with slow speed and without, and didnt notice any differnce. But i am using the slow speed now since terry told me its better to keep it on in our car's that needed theslow speed befoure the new update.

Terry sent me this: You may still need to keep slow speed on but in the new firmware the slow speed is better than old high speed , Slow speed is 6hz, high speed 10hz, sampling.

And Bit5 also no longer used, its full time all the time now.

2011 F10 535i N55 PWG 8AT | " Tune" + MHD Flasher | xHP Stage 3 transmission Tune | N20 3.5bar TMAP Sensor | Pure Stage 2 Turbo | GFB DV+ | Fuel-It Stage 2 LPFP | 93 Octane Fuel | BMS Intake | ER 4" CLess D/Pipe | ER 3" Charge-Pipe | Wagner-Tuning Competition Intercooler | Custom Turbo Inlet Pipe | |
Reply With Quote