JB4tech.com - International Turbo Tuning Discussion
Go Back   JB4tech.com - International Turbo Tuning Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 55 Search: Posts Made By: GMD
Forum: N54 06-29-2014, 03:01 PM
Replies: 112
Views: 37,270
Posted By GMD
I increased my Auto shift boost reduction to 60...

I increased my Auto shift boost reduction to 60 (it was at 0 because it's a manual), and it helped immensely. I was getting tired of the car because of this problem, but after I changed that setting...
Forum: N54 05-22-2014, 09:24 AM
Replies: 34
Views: 23,865
Posted By GMD
I don't use meth, and run map 3 at a 70 adder. A...

I don't use meth, and run map 3 at a 70 adder. A nice little boost from map 7 :)
Forum: N54 05-15-2014, 04:04 PM
Replies: 4
Views: 2,340
Posted By GMD
My car also had low torque (only 10 more tq than...

My car also had low torque (only 10 more tq than hp). One of my buddies said it was because the dyno operator "rolled on" the throttle instead of just mashing it.
Forum: N54 05-13-2014, 06:44 PM
Replies: 5
Views: 2,414
Posted By GMD
On an unrelated note, try turning your Auto Shift...

On an unrelated note, try turning your Auto Shift Boost Reduction up to 60, and also when you're shifting take your foot COMPLETELY off the pedal. I too went through this and thought it was my BoV...
Forum: N54 05-11-2014, 09:41 PM
Replies: 6
Views: 3,908
Posted By GMD
Max boost on these cars is around 8 psi stock. On...

Max boost on these cars is around 8 psi stock. On the chart is says that your max boost was around 7psi. Something seems wrong, but I don't know what.
Forum: N54 05-11-2014, 09:37 PM
Replies: 3
Views: 2,449
Posted By GMD
I'm no expert but I'll pitch in what I know. The...

I'm no expert but I'll pitch in what I know. The longer the piston compresses upwards towards TDC, the more compressed the mixture of air and fuel becomes (which means a bigger bang and therefore...
Forum: N54 05-06-2014, 08:14 PM
Replies: 17
Views: 4,404
Posted By GMD
You have to look in the .csv file. It is indeed...

You have to look in the .csv file. It is indeed map 5. The low boost is caused by an avg ign value in the 5.xx range. As previously stated this is most likely a firmware issue.
Forum: N54 05-06-2014, 06:16 AM
Replies: 2
Views: 2,150
Posted By GMD
5" intercooler of your choice (I have ETS) I'm...

5" intercooler of your choice (I have ETS)
I'm not sure where you live, but ********* if you can deal w/ the emissions
charge pipe
back end flash (free!)
LSD
tires if you still have runflats...
Forum: N54 05-06-2014, 06:08 AM
Replies: 7
Views: 7,365
Posted By GMD
These motors run hot for emissions reasons. I...

These motors run hot for emissions reasons. I installed my T-Stat bypass and my car runs around 220-230 as previously stated.
Forum: N54 05-03-2014, 08:12 AM
Replies: 4
Views: 3,167
Posted By GMD
Have you looked in to any HPFP solutions yet? I...

Have you looked in to any HPFP solutions yet? I know that's one of the biggest issues we have with fueling right now.
Forum: N54 05-02-2014, 08:46 AM
Replies: 46
Views: 25,853
Posted By GMD
I think you can select multiple items from the...

I think you can select multiple items from the same menu. So you can have your 4/5 and 4/2 at the same time.
Forum: N54 04-28-2014, 12:41 PM
Replies: 18
Views: 10,065
Posted By GMD
Option 4-2 allows you to use any map. It simply...

Option 4-2 allows you to use any map. It simply leaves all the tuning to the flash, except for the boost. The -2 isn't selecting map. To change maps is options 0 - #
Forum: N54 04-28-2014, 12:24 PM
Replies: 18
Views: 10,065
Posted By GMD
Not true :) Read about it here:...

Not true :) Read about it here: http://www.n54tech.com/forums/showthread.php?t=22272

It's what I use, ***** recommended it and it's all I've used since!
Forum: N54 04-28-2014, 12:15 PM
Replies: 18
Views: 10,065
Posted By GMD
Go to settings, it will be G5 ISO W/ BMS Flash....

Go to settings, it will be G5 ISO W/ BMS Flash. Then (I think this is what you're looking for), you need to set setting 4 - 2 (4 on the speedo, 2 on the tach). This allows the flash to control...
Forum: JB4 Mobile 04-21-2014, 05:09 PM
Replies: 4,856
Views: 2,096,009
Posted By GMD
Very good app- I used it today with my S5 and...

Very good app- I used it today with my S5 and it's 100% better than lugging my laptop around. I recommend it.
Forum: N54 04-16-2014, 08:24 AM
Replies: 8
Views: 10,181
Posted By GMD
My car only makes the rattle described in #2 on...

My car only makes the rattle described in #2 on warm starts, but it goes away after a few seconds like you said. If left overnight it makes no rattle on startup. Any ideas?
Forum: N54 04-15-2014, 02:12 PM
Replies: 13
Views: 5,213
Posted By GMD
*** are the single biggest HP Booster after the...

*** are the single biggest HP Booster after the JB4. I can't say how much (Companies estimate 20/30 as LAZ stated), but it will certainly be more than any other mod you do.
Forum: N54 04-11-2014, 07:19 AM
Replies: 58
Views: 12,167
Posted By GMD
In Columbus, Ohio prices have jumped to the high...

In Columbus, Ohio prices have jumped to the high 3$ range as well. I have not tested the blend, but I hope the more expensive stuff is at least not E70
Forum: N54 04-06-2014, 04:05 PM
Replies: 10
Views: 3,632
Posted By GMD
A video might help. Did you change anything or...

A video might help. Did you change anything or did this just happen randomly?
Forum: N54 03-31-2014, 06:35 AM
Replies: 14
Views: 12,185
Posted By GMD
When I installed the BMS oil T-Stat this happened...

When I installed the BMS oil T-Stat this happened to me. Used my 3rd party warranty and had all gaskets replaced. My car had 56,000 miles.
Forum: N54 03-25-2014, 04:27 PM
Replies: 13
Views: 4,446
Posted By GMD
Sweet! Looking forward to updates!

Sweet! Looking forward to updates!
Forum: N55 03-20-2014, 02:43 PM
Replies: 16
Views: 5,577
Posted By GMD
Burger Tuning sells a meth kit. Its at the very...

Burger Tuning sells a meth kit. Its at the very bottom on the page on the N55 section.
Forum: N54 03-17-2014, 10:11 AM
Replies: 12
Views: 3,722
Posted By GMD
Its my understanding that traction control should...

Its my understanding that traction control should be 100% off at the strip.
Forum: DIY Modification 02-25-2014, 06:06 PM
Replies: 712
Views: 295,552
Posted By GMD
I didn't find loosening the ring to be an issue....

I didn't find loosening the ring to be an issue. I had to smack it pretty hard with my trusty BFH, but after maybe 5 minutes it came free. And it was so dusty and gross in there that I'm pretty sure...
Forum: DIY Modification 02-24-2014, 06:56 PM
Replies: 712
Views: 295,552
Posted By GMD
Yeah that makes good sense. I was worried, I...

Yeah that makes good sense. I was worried, I thought something might have been wrong. Good to know its normal :drinking:
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2022, JB4tech.com