N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 19 of 19 Search: Posts Made By: zomski101
Forum: N54 10-22-2020, 05:07 PM
Replies: 2
Views: 105
Posted By zomski101
They are not that important. Sounds like you need...

They are not that important. Sounds like you need a new engine and transmission from BMW. I'll buy the car off you for 1k.
Forum: Support & Log Review 06-23-2020, 08:39 PM
Replies: 6
Views: 399
Posted By zomski101
What was the solution to this? I have the same...

What was the solution to this? I have the same codes and symptoms but had this setup for a couple months. My car died while on the highway. Everytime I start it up lpfp pressure is at around 32 psi...
Forum: N54 05-16-2020, 02:05 PM
Replies: 3
Views: 514
Posted By zomski101
Mmp stage 3 70k miles at 18-21psi, stage 2 lpfp...

Mmp stage 3
70k miles at 18-21psi, stage 2 lpfp e50 mix
15k miles at 22-26psi, stage 3 lpfp and helix 3x, motiv flex fuel, e70
Supporting mods:
Vrsf 7.5 intercooler, cp and dp
Whp idk
Forum: N54 04-02-2020, 08:44 AM
Replies: 3
Views: 416
Posted By zomski101
It was 37f at night and 50f this morning. Live in...

It was 37f at night and 50f this morning. Live in Chicago.
Forum: N54 04-02-2020, 08:14 AM
Replies: 3
Views: 416
Posted By zomski101
Disgusting gooey stuff in low side catch can.

After driving 500 miles I go to check what my catch can caught this morning and I see this....

Should I be concerned? The car has 160k miles, making 500whp and driven hard. No coolant or oil leaks.
Forum: Support & Log Review 09-12-2019, 05:34 PM
Replies: 4
Views: 716
Posted By zomski101
Just spitting ideas from my somewhat similar but...

Just spitting ideas from my somewhat similar but different experience, might be irrelevant tho. My trusted mechanic said because he didn't hear any ticking noise it was unlikely the camshaft bearings...
Forum: N54 05-11-2019, 09:01 PM
Replies: 7
Views: 803
Posted By zomski101
sc300 with a gte swap or a mustang gt

sc300 with a gte swap or a mustang gt
Forum: N54 04-10-2019, 08:59 PM
Replies: 8
Views: 1,919
Posted By zomski101
I would like to see an oil analysis of the amount...

I would like to see an oil analysis of the amount of additives after the testing. Then we can truly see what's the best oil.
Forum: Support & Log Review 04-08-2019, 04:25 PM
Replies: 1
Views: 308
Posted By zomski101
Car running slightly lean w/ codes

Hello, I got an e92 n54 with 110k miles running an e50 tune. I'm getting a 29e0 and 29e1 mixture control codes but the car is performing normally with no misfires or loss of power. If I clear the...
Forum: N54 02-02-2019, 03:29 PM
Replies: 3
Views: 794
Posted By zomski101
I got 10k on mmp stage 3. Took 3 weeks from...

I got 10k on mmp stage 3. Took 3 weeks from placing order to receiving them at the door. Running 18psi on e50, so I'm not pushing them at all.
Forum: N54 01-10-2019, 11:18 AM
Replies: 70
Views: 10,035
Posted By zomski101
I put 1000 miles on the car and haven't noticed...

I put 1000 miles on the car and haven't noticed any extra noise, it's as if it was never there.
Forum: N54 01-05-2019, 02:34 PM
Replies: 7
Views: 1,547
Posted By zomski101
I'd recommend getting the ecs tuning installation...

I'd recommend getting the ecs tuning installation kit. It has ALL the hardware that you need while other companies include just enough.
Forum: N54 12-29-2018, 04:37 PM
Replies: 105
Views: 17,769
Posted By zomski101
Damn, if only I hadn't installed the evolution...

Damn, if only I hadn't installed the evolution racewerks oil cooler. Will the trans be able to warm up in colder climates?
Forum: N54 12-19-2018, 10:49 PM
Replies: 10
Views: 2,533
Posted By zomski101
Update 2 (hopefully final): After putting 1000...

Update 2 (hopefully final): After putting 1000 miles on the car, timing slipped again, car went into limp mode, codes were 2a98, 2a99, 3100. Took it back to the shop and they said the crank hub...
Forum: N54 12-14-2018, 05:54 PM
Replies: 5
Views: 1,053
Posted By zomski101
Be prepared to dump 5k for maintenance and ****...

Be prepared to dump 5k for maintenance and **** that breaks. It's priced pretty low, has me wondering if the turbos are on there way out. Take it for a test drive and see if you or the owner can data...
Forum: N54 12-03-2018, 04:57 PM
Replies: 10
Views: 2,533
Posted By zomski101
UPDATE: After going to 3 different bmw indy...

UPDATE:
After going to 3 different bmw indy mechanics, everyone seems to be busy, it turned out to be both cam bearing ledges. Since the car is an early 2009 model, built in late 2008, it has the...
Forum: N54 11-09-2018, 04:23 PM
Replies: 29
Views: 2,604
Posted By zomski101
Switch from e50 to 93 oct tune and changed to...

Switch from e50 to 93 oct tune and changed to winter tires. I start work late in the morning so the streets are mostly plowed in the suburbs of Chicago. Don't have any interested in driving a boring...
Forum: N54 10-31-2018, 10:29 PM
Replies: 10
Views: 2,533
Posted By zomski101
Car is tuned by Ken to run 18.5 psi, timing idk....

Car is tuned by Ken to run 18.5 psi, timing idk. After looking into crank hub slipping, some people have experienced the same problem after hitting the kickdown switch. I have an auto with xhp stage...
Forum: N54 10-30-2018, 08:49 PM
Replies: 10
Views: 2,533
Posted By zomski101
Timing slipped?

I got a 2009 335i 95k miles with mmp stage 3 turbos, inlets and outlets, fbo and stage 2 lpfp. After filling up on e50 I did a WOT pull from top of 2nd gear all the way to 4th gear. 30 seconds after,...
Search took 0.00 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2020, N54tech.com