N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 100 Search: Posts Made By: Bimmer_Boost
Forum: N55 09-05-2019, 10:05 PM
Replies: 211
Views: 15,425
Posted By Bimmer_Boost
What do you mean by first ethanol map. You mean...

What do you mean by first ethanol map. You mean V1?
Forum: N55 09-01-2019, 03:52 PM
Replies: 211
Views: 15,425
Posted By Bimmer_Boost
Is your E30 verified or an estimate? Log looks...

Is your E30 verified or an estimate? Log looks pretty good. My 125 mph trap was on 20.5 psi and 10 degrees of timing. This isn't far off from that.
Forum: N55 07-03-2019, 11:08 AM
Replies: 25
Views: 2,460
Posted By Bimmer_Boost
The timing he is running is perfectly fine since...

The timing he is running is perfectly fine since he has the octane to support it.
Forum: Support & Log Review 06-28-2019, 02:51 PM
Replies: 10
Views: 429
Posted By Bimmer_Boost
FF is pinned at 150 so it cannot move the boost...

FF is pinned at 150 so it cannot move the boost curve up anymore. I actually don't know what causes this. Your WGDC looks fine so I wouldn't think it is a boost leak. Aside from that the rest of this...
Forum: Support & Log Review 06-20-2019, 07:33 PM
Replies: 84
Views: 3,851
Posted By Bimmer_Boost
This entire thread is full of people experiencing...

This entire thread is full of people experiencing the same issue. If you want each of them to email in that would be less productive. Understandably you guys are busy but currently you're selling a...
Forum: Support & Log Review 06-10-2019, 11:01 PM
Replies: 2
Views: 149
Posted By Bimmer_Boost
Are you running normal pump gas? These cars run...

Are you running normal pump gas? These cars run lean down low. This log is too short to say if anything is wrong though. I would not be concerned about doing a full 3rd gear pull though. Post up...
Forum: Support & Log Review 06-10-2019, 10:57 PM
Replies: 3
Views: 159
Posted By Bimmer_Boost
Post up what mods you have and your map 6...

Post up what mods you have and your map 6 targets. If your boost target is following the boost you set then change the profile to be flat so we can dial in your boost curve.
Forum: Support & Log Review 06-10-2019, 10:48 PM
Replies: 3
Views: 158
Posted By Bimmer_Boost
You would really benefit from methanol or a...

You would really benefit from methanol or a larger intercooler. Your IATs are really high. Other than that this looks normal for 91 octane. If I were you I would run map 1 though.
Forum: Support & Log Review 05-25-2019, 03:15 PM
Replies: 84
Views: 3,851
Posted By Bimmer_Boost
Stock flash. My DME has since been unlocked but I...

Stock flash. My DME has since been unlocked but I have not loaded MHD yet.
Forum: Support & Log Review 05-25-2019, 08:31 AM
Replies: 84
Views: 3,851
Posted By Bimmer_Boost
I'll be doing the same shortly.

I'll be doing the same shortly.
Forum: Support & Log Review 05-20-2019, 10:53 AM
Replies: 25
Views: 540
Posted By Bimmer_Boost
With the stock turbo you're really limited on how...

With the stock turbo you're really limited on how much boost you can run up top. I ran the stock unit at 100% duty cycle for over a year and it didn't fail on me. Since you have plans to upgrade I...
Forum: Support & Log Review 05-17-2019, 03:13 PM
Replies: 25
Views: 540
Posted By Bimmer_Boost
Methanol isn't that taxing of an install. You can...

Methanol isn't that taxing of an install. You can knock it out in a day at a relaxed pace. You go to the BEF thread and download the bin you want to modify. Download TunerPro and the XDF file that...
Forum: Support & Log Review 05-17-2019, 02:38 PM
Replies: 25
Views: 540
Posted By Bimmer_Boost
I go back and forth between E20ish and 92 pump. I...

I go back and forth between E20ish and 92 pump. I run 16 psi on E20 and 12 psi on pump. I don't have a BEF loaded currently so timing is factory. I would limit timing to 10 or 12 degrees on E20 and I...
Forum: Support & Log Review 05-16-2019, 01:48 PM
Replies: 25
Views: 540
Posted By Bimmer_Boost
I have gone from running the stock plugs to the...

I have gone from running the stock plugs to the N20 plugs. The difference isn't anything you'll notice anywhere unless you have an issue with the current plugs. Since you're limited to 92 octane only...
Forum: Support & Log Review 04-25-2019, 08:34 PM
Replies: 6
Views: 229
Posted By Bimmer_Boost
Your HPFP isn't capable of supporting that high...

Your HPFP isn't capable of supporting that high of boost. You need to either upgrade your HPFP, get port injection, or lower boost.
Forum: N55 04-23-2019, 09:50 AM
Replies: 9
Views: 593
Posted By Bimmer_Boost
I cannot comment on the 7.5 because I have never...

I cannot comment on the 7.5 because I have never installed one. Here are some photos of the same 7 inch intercooler when installed on my e92 Msport.

85820

85819
Forum: N55 04-19-2019, 01:32 PM
Replies: 9
Views: 593
Posted By Bimmer_Boost
Something also to consider is drag racing. If you...

Something also to consider is drag racing. If you are sitting in staging lanes you will get a lot of heat soak before your run. If you don't drag race then I think a larger intercooler will serve you...
Forum: Support & Log Review 04-18-2019, 06:38 PM
Replies: 12
Views: 376
Posted By Bimmer_Boost
With the JB4 out load MHD and try that for awhile.

With the JB4 out load MHD and try that for awhile.
Forum: Support & Log Review 04-18-2019, 11:57 AM
Replies: 9
Views: 259
Posted By Bimmer_Boost
Post up some more CSVs if you need any help....

Post up some more CSVs if you need any help. Thanks for helping back with the menu 12 changes. I was pulling my hair out trying to minimize that horrendous boost dip.
Forum: Support & Log Review 04-18-2019, 10:06 AM
Replies: 9
Views: 259
Posted By Bimmer_Boost
The second photo you posted is an acceptable...

The second photo you posted is an acceptable amount of boost dip. Boost will not be on target 100% of the time but that would be close enough that you shouldn't notice unless you watched a boost...
Forum: N55 04-16-2019, 04:34 PM
Replies: 9
Views: 593
Posted By Bimmer_Boost
Keep in mind you're posting on the BMS owned...

Keep in mind you're posting on the BMS owned forums so their recommendation will be for their own product. I bought the 7 inch VRSF before the HD was an option. I have run up to 25 psi and to 140 mph...
Forum: Support & Log Review 04-12-2019, 02:17 PM
Replies: 9
Views: 259
Posted By Bimmer_Boost
The only point of the TMAP change is to exceed...

The only point of the TMAP change is to exceed the 21 psi the stock unit cannot. Map 6 is your friend if you just want to set boost targets. People are afraid of the idea of using it because they...
Forum: Support & Log Review 04-12-2019, 11:58 AM
Replies: 9
Views: 259
Posted By Bimmer_Boost
At one point I believe they switched that the...

At one point I believe they switched that the TMAP upped boost targets in favor of the BEF. The BEF can actually set timing targets so they can target lower timing which should allow for more boost...
Forum: N55 04-11-2019, 01:15 PM
Replies: 10
Views: 603
Posted By Bimmer_Boost
Actually come to think about it this happened...

Actually come to think about it this happened when I was flashing XHP not MHD. My cable worked for MHD so I didn't think it was bad. I borrowed another from a friend and was able to complete the...
Forum: Support & Log Review 04-10-2019, 03:28 PM
Replies: 5
Views: 280
Posted By Bimmer_Boost
It looks like making the adjustment to menu 12...

It looks like making the adjustment to menu 12 made some positive impacts. I will log a few more times and start making adjustments to my duty bias near redline. I will be installing my methanol kit...
Search took 0.02 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2018, N54tech.com