N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 16 of 16 Search: Posts Made By: Aaronheim
Forum: N54 07-08-2020, 08:57 AM
Replies: 1
Views: 486
Posted By Aaronheim
High boost reading

My JB4 app is showing my boost is 45psi while at idle and my half engine light came on. Any idea what could be causing it? Yesterday it threw a cyl6 misfire but donít know if thatís related. Thanks...
Forum: Suspension and Brakes 01-14-2020, 07:19 AM
Replies: 0
Views: 2,396
Posted By Aaronheim
Maxed out coilovers

I recently got another car that came with Bilstein coilovers, the front seems very low despite the springs perch being maxed out in height. What are my options? Taller springs, add on springs or coil...
Forum: Support & Log Review 01-02-2020, 11:37 AM
Replies: 0
Views: 249
Posted By Aaronheim
Question Can flap help

Can anyone help me with the wiring diagram for the can flap on an e90. The flap works when I add external power to the switch but I get nothing on a volt meter at the plug it self. Iíve checked fuses...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 08-02-2017, 10:19 AM
Replies: 3
Views: 954
Posted By Aaronheim
Thanks terry, the car doesn't want to run after...

Thanks terry, the car doesn't want to run after about 30 seconds, if I clear the codes it stalls out, could the map sensor go bad from being submerged?
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 07-30-2017, 07:59 PM
Replies: 3
Views: 954
Posted By Aaronheim
Exclamation Help with meth staying on after failed flash

So tonight as I was flashing my trans and I disconnected the jb4, my meth pump kicked on and ran for a few minutes before I realized what was happening. Stupid me then started the car and it shut...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 07-02-2017, 12:35 PM
Replies: 3
Views: 1,098
Posted By Aaronheim
Steve is there a way to test the injector? I'm...

Steve is there a way to test the injector? I'm getting a 2E34 code after replacing that MOSFET?
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 06-30-2017, 09:01 AM
Replies: 3
Views: 1,098
Posted By Aaronheim
Exclamation MOSFET help

I need some help, I blew my 2nd MOSFET, after soldering in a new one I'm getting an injector code 2e34 injector input signal. What could be the issue?? Could the injector have been messed up when the...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 05-09-2017, 05:22 AM
Replies: 5
Views: 1,140
Posted By Aaronheim
Sorry, 2EF5 and 2EF7 are the codes I have

Sorry, 2EF5 and 2EF7 are the codes I have
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 05-08-2017, 05:54 PM
Replies: 5
Views: 1,140
Posted By Aaronheim
I replaced all the injectors already but I just...

I replaced all the injectors already but I just swapped in the old coils
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 05-07-2017, 02:09 PM
Replies: 5
Views: 1,140
Posted By Aaronheim
SES light

Well guys I'm having some issues with my N54, I've blown 2 DMEs and it's the same MOSFET both times. I reinstalled the factory coils but haven't pushed it hard yet. On start up I keep getting the SES...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 04-05-2017, 08:26 AM
Replies: 4
Views: 1,203
Posted By Aaronheim
How should I go about getting my ECU flashed to...

How should I go about getting my ECU flashed to match my car? It's up and running now but I still have some dash lights on! Thanks again
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 03-27-2017, 06:27 PM
Replies: 4
Views: 1,203
Posted By Aaronheim
No I just did a swap of the 3 parts, it starts up...

No I just did a swap of the 3 parts, it starts up fine but I have the lights on and can't figure out what I need to do next
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 03-26-2017, 12:30 PM
Replies: 4
Views: 1,203
Posted By Aaronheim
Ecu help

So I just replaced my ECU and all the parts that go with it, the car starts and runs fine but I need to find out how to turn off all the dash lights!! Any able to help out or lend a hand would be...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 03-25-2017, 05:24 AM
Replies: 0
Views: 757
Posted By Aaronheim
Swapped ECU help

Ok I need some help, I swapped my ECU, key switch and the other black box under the dash. The car starts up fine and everything works but I have a couple lights on the dash that I can't turn off...
Forum: N54 01-07-2017, 06:28 PM
Replies: 3,989
Views: 1,605,926
Posted By Aaronheim
Question Help with connections

So as I was flashing my computer I hit the cord and unplugged the phone from the car, now I cannot connect to the car at all to resume or start over . I just removed the jb4 in hopes it might help...
Forum: Northeast USA 11-10-2016, 06:00 PM
Replies: 9
Views: 5,052
Posted By Aaronheim
Subscribed -Hagerstown MD

Subscribed
-Hagerstown MD
Search took 0.00 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright © 2007 - 2020, N54tech.com