N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 16 of 16 Search: Posts Made By: Terry @ BMS
Forum: N20, N26 03-07-2017, 06:08 PM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
Yes

Yes
Forum: N20, N26 05-17-2015, 09:41 PM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
It's in the N54 section under 3rd party...

It's in the N54 section under 3rd party interfaces.
Forum: N20, N26 05-17-2015, 09:06 PM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
Stage1 is not upgradable to a JB4, cable is on...

Stage1 is not upgradable to a JB4, cable is on our website, and there is a 3rd party apple interface that is compatible.
Forum: N20, N26 05-17-2015, 08:53 PM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
Just get a BMS DATA cable and datalog it on map 0...

Just get a BMS DATA cable and datalog it on map 0 (stock) and map 1 (tuned) and we can do a basic evaluation based on that.
Forum: N20, N26 04-06-2015, 09:20 AM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
For the S55 you'll need a full JB4 to run higher...

For the S55 you'll need a full JB4 to run higher power levels than Stage1 offers.
Forum: N20, N26 04-04-2015, 08:36 PM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
No none of the N20 tunes can provide any MPG...

No none of the N20 tunes can provide any MPG improvement. Not your current tune, not the Stage1, and not even the JB4. Certainly not the Stage1 tunes.
Forum: N20, N26 04-04-2015, 09:23 AM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
The default on the new Stage1 is 4.0psi. And it...

The default on the new Stage1 is 4.0psi. And it can be adjusted using a BMS DATA cable to as high as 6.5psi if you want. The pump gas was 4.0 and race gas 6.0 in the runs above, IIRC.
Forum: N20, N26 03-31-2015, 12:00 PM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
For those wondering about the EWG vs. pneumatic...

For those wondering about the EWG vs. pneumatic here is an old Stage1 test done some time ago on a 100% stock EWG 328i. We'll test "BRAND X" on the same car down the road as well. And expect similar...
Forum: N20, N26 03-29-2015, 03:15 PM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
Yes in many cases the seals were omitted all...

Yes in many cases the seals were omitted all together. In some cases seals were there but they were the wrong ones. Was an oversight that has been corrected.

The new seals we use can be retrofit...
Forum: N20, N26 03-29-2015, 02:09 PM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
The JB4 can run anywhere from factory boost up to...

The JB4 can run anywhere from factory boost up to 36psi, the maximum possible with the boost sensor, so the peak power output with the JB4 entirely depends on the settings used. The issue with the...
Forum: N20, N26 03-29-2015, 01:22 PM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
FWIW on the topic of connectors, the connectors...

FWIW on the topic of connectors, the connectors used on "BRAND X" are cheap Chinese knock offs of the actual connectors used and not especially high quality. We use authentic connectors from the same...
Forum: N20, N26 03-29-2015, 10:08 AM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
The RC is an analog box like our Stage1. For the...

The RC is an analog box like our Stage1. For the most part anything you can do with the RC you can do with the Stage1. Neither will ever have the JB4 feature set, boost by gear, more robust safety...
Forum: N20, N26 03-28-2015, 06:45 PM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
Looks like some knock there with the high...

Looks like some knock there with the high frequency wobble. Did you log ignition advance? Also must be ewg as those dyno a bit higher under higher settings on stage 1 tunes.

I see one issue. Set...
Forum: N20, N26 03-26-2015, 11:21 AM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
Basically all of these analog only systems...

Basically all of these analog only systems without CANbus control and without direct wastegate control can only attenuate the TMAP and MAP sensors to raise boost. And you can only attenuate them...
Forum: N20, N26 03-26-2015, 11:19 AM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
FWIW with the harness redesign we also redesigned...

FWIW with the harness redesign we also redesigned the connector assembly process and included better seals. So no more issues there. We also have a new aluminum F series enclosure in the works that...
Forum: N20, N26 03-25-2015, 07:08 PM
Replies: 43
Views: 21,675
Posted By Terry @ BMS
328i BMS Stage1 vs. "BRAND X" Dyno Testing

Hey guys,

We've had customers emailing in asking about how our tunes compare with this brand or that brand, so we've decided to do a little in house testing just so we know where we stand. For...
Search took 0.00 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2019, N54tech.com