N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 100 Search: Posts Made By: Terry @ BMS
Forum: Support & Log Review Yesterday, 08:21 PM
Replies: 1
Views: 12
Posted By Terry @ BMS
Intake temps will vary run to run and moment to...

Intake temps will vary run to run and moment to moment!
Forum: Infiniti Q50 Q60 VR30DDTT Yesterday, 08:08 PM
Replies: 4,334
Views: 427,053
Posted By Terry @ BMS
What we're looking for are drops that are not...

What we're looking for are drops that are not mapped out, e.g. in response to early knock. You want to see a smooth slope up as RPM increases. If it looks like a downward staircase instead, you know...
Forum: MINI Cooper N18, B48 Yesterday, 07:50 PM
Replies: 590
Views: 144,639
Posted By Terry @ BMS
Log looks fine, although the flash target is...

Log looks fine, although the flash target is wonky... 22psi across the board? Turbo has no chance of keeping up with that! The flash should have realistic targets IMHO.
Forum: MINI Cooper N18, B48 Yesterday, 07:40 PM
Replies: 590
Views: 144,639
Posted By Terry @ BMS
Sorry forgot to check back here...I see it...

Sorry forgot to check back here...I see it changed to safety in both just took a couple seconds. You want a tighter window?
Forum: Kia & Hyundai Turbo Yesterday, 05:39 PM
Replies: 85
Views: 1,293
Posted By Terry @ BMS
Yes the signal wire (position #1) will be red so...

Yes the signal wire (position #1) will be red so you know which one to posi-tap.
Forum: Kia & Hyundai Turbo Yesterday, 05:38 PM
Replies: 85
Views: 1,293
Posted By Terry @ BMS
Looks like the same 6 position connector the 3.3L...

Looks like the same 6 position connector the 3.3L uses in the photos. We'll have to try one.
Forum: Infiniti Q50 Q60 VR30DDTT Yesterday, 05:37 PM
Replies: 4,334
Views: 427,053
Posted By Terry @ BMS
Looks fine to me! Any issues?

Looks fine to me! Any issues?
Forum: Infiniti Q50 Q60 VR30DDTT Yesterday, 05:36 PM
Replies: 4,334
Views: 427,053
Posted By Terry @ BMS
I like the map2 log better myself too, prefer to...

I like the map2 log better myself too, prefer to see timing rolling up rather than down at peak HP.
Forum: VW/Audi Group Yesterday, 05:32 PM
Replies: 360
Views: 23,455
Posted By Terry @ BMS
Not sure how much seat time you have behind the...

Not sure how much seat time you have behind the wheel but the turbo doesn't spool quickly on these to start with. Don't expect it to move you quickly unless you're in launch mode or already have it...
Forum: VW/Audi Group Yesterday, 05:28 PM
Replies: 567
Views: 93,521
Posted By Terry @ BMS
SENT systems can have rev3 power crimped on a...

SENT systems can have rev3 power crimped on a DSUB pin stuck in position #2 on the blue tooth connector.
Forum: Kia & Hyundai Turbo Yesterday, 03:14 PM
Replies: 85
Views: 1,293
Posted By Terry @ BMS
Maybe, don't have one handy to check the...

Maybe, don't have one handy to check the connector. Have photos of your connector?
Forum: Kia & Hyundai Turbo Yesterday, 03:13 PM
Replies: 85
Views: 1,293
Posted By Terry @ BMS
Yes they are engine bay heat rated. Testing that...

Yes they are engine bay heat rated. Testing that out all in application now of course.
Forum: Kia & Hyundai Turbo Yesterday, 02:32 PM
Replies: 85
Views: 1,293
Posted By Terry @ BMS
Found the connectors and made a couple sample...

Found the connectors and made a couple sample adapters. Ours will look like this. Around 3" long and simply plug in to the o2 sensor harness. Then you add the JB4 posi-tap to the jumper wire. Will...
Forum: Support & Log Review Yesterday, 10:58 AM
Replies: 7
Views: 50
Posted By Terry @ BMS
Looks like a post shift misfire? No codes stored?

Looks like a post shift misfire? No codes stored?
Forum: Support & Log Review Yesterday, 10:57 AM
Replies: 5
Views: 36
Posted By Terry @ BMS
Might be unrelated to JB4. But could be a loose...

Might be unrelated to JB4. But could be a loose wire in the JB4 harness, especially if it's an older system. We have replacement harnesses on our site. Or you can try cleaning the connections with...
Forum: Support & Log Review Yesterday, 10:55 AM
Replies: 7
Views: 45
Posted By Terry @ BMS
Don't see how it would be related but easy to...

Don't see how it would be related but easy to roll back to previous firmware to confirm.
Forum: Lexus, Maserati, Alfa, Diesel, and other new applications Yesterday, 10:14 AM
Replies: 20
Views: 799
Posted By Terry @ BMS
Until I see a JB4 log of it it's hard to...

Until I see a JB4 log of it it's hard to evaluate. If you have any tuning issues with them share the log and lets see what we can work out!
Forum: N63, N63TU Yesterday, 10:11 AM
Replies: 150
Views: 12,347
Posted By Terry @ BMS
OK I'll email you to get that board replaced.

OK I'll email you to get that board replaced.
Forum: Lexus, Maserati, Alfa, Diesel, and other new applications Yesterday, 10:03 AM
Replies: 20
Views: 799
Posted By Terry @ BMS
Passive delete is an option for outside the USA...

Passive delete is an option for outside the USA work, should work but we've not tested it yet on the 718.
Forum: VW/Audi Group Yesterday, 09:52 AM
Replies: 360
Views: 23,455
Posted By Terry @ BMS
Yes we're just not sure yet since it's difficult...

Yes we're just not sure yet since it's difficult to recreate the issue here. I suspect the problem is somehow related to flash versions. Some of the versions from the factory might be more...
Forum: VW/Audi Group Yesterday, 09:48 AM
Replies: 360
Views: 23,455
Posted By Terry @ BMS
Maybe but the 2.5L engines pop often so don't...

Maybe but the 2.5L engines pop often so don't undervalue the potential JB4 safety benefits especially if already flashed. A new engine starts at $15k+.

Also FWIW for the TTRS/RS3 there are not...
Forum: Honda Civic, Accord 1.5L and 2.0L Turbo Yesterday, 09:03 AM
Replies: 431
Views: 18,840
Posted By Terry @ BMS
Just sort of scanning along I can't see anything...

Just sort of scanning along I can't see anything obvious in the logs. One test might be to use map6 to enter say 2.0 across the board and evaluate under similar conditions. Could it just be spark...
Forum: Honda Civic, Accord 1.5L and 2.0L Turbo Yesterday, 09:01 AM
Replies: 431
Views: 18,840
Posted By Terry @ BMS
Our testing with the R showed fuel pressure...

Our testing with the R showed fuel pressure issues even on map1 with enough E85. So I'd have to see your specific logs for tuning advice! Some cars seem to be able to get away with it.
Forum: N63, N63TU 06-24-2019, 08:29 PM
Replies: 150
Views: 12,347
Posted By Terry @ BMS
Sure, what's your email? He should have cleared...

Sure, what's your email? He should have cleared his email box before clocking out for the day!
Forum: Support & Log Review 06-24-2019, 07:59 PM
Replies: 20
Views: 316
Posted By Terry @ BMS
So startup sweep lag issue comes up only on a...

So startup sweep lag issue comes up only on a cold start?
Search took 0.02 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2018, N54tech.com