N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 56 Search: Posts Made By: camberadam
Forum: Northeast USA 10-15-2017, 06:13 PM
Replies: 2
Views: 2,127
Posted By camberadam
https://www.facebook.com/events/172088046680139/

https://www.facebook.com/events/172088046680139/
Forum: Northeast USA 10-14-2017, 06:50 PM
Replies: 2
Views: 2,127
Posted By camberadam
Freed Engineering Open House Oct 21

Planning on heading out to this w/ a couple Supra buddies if anyone is looking for something to do...
Forum: DIY Modification 10-09-2017, 09:33 AM
Replies: 28
Views: 6,439
Posted By camberadam
Which is it? One post your say 12v triggers the...

Which is it? One post your say 12v triggers the pump & the next you're saying ground triggers it. I've been guessing at what you're trying to say for most of this post. :banghead:
Forum: DIY Modification 10-09-2017, 09:24 AM
Replies: 28
Views: 6,439
Posted By camberadam
how/where is your meth pump trigger wired? I'd...

how/where is your meth pump trigger wired? I'd try to disconnect it & set the values to what i have. I'm really thinking this is why it is "recommended" not to use meth & ethanol (possibly the reason...
Forum: DIY Modification 10-06-2017, 11:50 AM
Replies: 28
Views: 6,439
Posted By camberadam
Even though min & max rpm have values? If the car...

Even though min & max rpm have values? If the car is just sitting, it's not going to be between those values & shouldn't activate no?

I was thinking it has something to do w/ the meth integration....
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 10-05-2017, 05:24 PM
Replies: 7
Views: 1,329
Posted By camberadam
Yes sir, Fuel-it stage 3. I think you may be on...

Yes sir, Fuel-it stage 3. I think you may be on to something! External trigger is set 2500-7200rpm, 45% min tps. Looks like "map 20" happens under those conditions; never even occurred to me.
...
Forum: DIY Modification 10-05-2017, 08:21 AM
Replies: 28
Views: 6,439
Posted By camberadam
i wasn't concerned about the antilag either, but...

i wasn't concerned about the antilag either, but it has additional programming needed to make the PI integration.

Maybe Trebilla can help w/ your specific configuration. If possible I personally...
Forum: DIY Modification 10-05-2017, 05:58 AM
Replies: 28
Views: 6,439
Posted By camberadam
Only thing other thing I came across was I had an...

Only thing other thing I came across was I had an older slave chip inside that I swapped out. It is upgradeable on the burger website. It was called the antilag chip but has other updated features on...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 10-05-2017, 05:11 AM
Replies: 7
Views: 1,329
Posted By camberadam
latest log actually shows the start at 5, changes...

latest log actually shows the start at 5, changes to 20 & back to 5.
Forum: DIY Modification 10-04-2017, 01:36 PM
Replies: 28
Views: 6,439
Posted By camberadam
I can't say for sure that the ET=1 changes output...

I can't say for sure that the ET=1 changes output from NO to NC. I did not test the output coming out of the JB4 as I didn't want to short anything.

I know in my case, my 2nd pump wasn't turning...
Forum: DIY Modification 10-04-2017, 12:54 PM
Replies: 28
Views: 6,439
Posted By camberadam
My understanding of the logic is that enabled 1...

My understanding of the logic is that enabled 1 turns the external output "on" as long as the other conditions you fill in are met. As in, it puts out 12v+ when you are 2500-7200rpm & above 45%...
Forum: DIY Modification 10-04-2017, 11:18 AM
Replies: 28
Views: 6,439
Posted By camberadam
Yes my pin 7 output is ground until jb4 triggers...

Yes my pin 7 output is ground until jb4 triggers 12v+. Currently tuning 26psi on ethanol. Didn't realize you have a meth pump. These settings may be different due to meth signal scaling (I have no...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 10-04-2017, 10:27 AM
Replies: 7
Views: 1,329
Posted By camberadam
No problem Steve. I went back & confirmed map 4...

No problem Steve. I went back & confirmed map 4 did it as well. Since those 2 maps are over 20psi, I'm thinking something to do w/ the t-map configuration between MHD/BEF & JB4? What's odd also is...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 10-04-2017, 05:57 AM
Replies: 7
Views: 1,329
Posted By camberadam
Single turbo e85 bef map 20???

For single turbo firmware, why would a log show map 20 when set to map 5 (in general)? I have just up'd boost from map 4-5, but the log shows "map 20" in 2 logs. I tried searching, but terms are too...
Forum: DIY Modification 10-03-2017, 12:41 PM
Replies: 28
Views: 6,439
Posted By camberadam
I just got mine setup & working... [stg 3...

I just got mine setup & working...

[stg 3 lpfp / eth analyzer / PI with BMS controller triggered by jb4]

what does your WMI settings tab look like?

also what do you mean by but for some...
Forum: Market Place - For Sale / Trade / Wanted 08-30-2017, 07:43 AM
Replies: 11
Views: 2,162
Posted By camberadam
*sold*

*sold*
Forum: Market Place - For Sale / Trade / Wanted 08-07-2017, 11:49 AM
Replies: 1
Views: 1,255
Posted By camberadam
bumper boats since its pouring right now!

bumper boats since its pouring right now!
Forum: N54 08-03-2017, 02:39 PM
Replies: 19
Views: 4,620
Posted By camberadam
Gorgeous car man.

Gorgeous car man.
Forum: Market Place - For Sale / Trade / Wanted 08-01-2017, 09:41 AM
Replies: 1
Views: 1,255
Posted By camberadam
Febi Upgraded Guibo/Flex Disc [n54/n55] [e90/e91/e92/e93]

Bought this & used for 900 miles before I ended up swapping my diff/driveshaft. $100 shipped.

"OE replacement for vehicles with production date from 10/2010. Heavy duty upgrade for models with...
Forum: N54 06-09-2017, 07:59 AM
Replies: 318
Views: 89,654
Posted By camberadam
I'm noticing this as well; automatically changes...

I'm noticing this as well; automatically changes from 0 > 132. Just switching from bms/mhd off the shelf flash to a custom flash. Having a hell of a time getting Jb & Mhd to play nice...
Forum: N54 05-22-2017, 06:49 AM
Replies: 12
Views: 2,888
Posted By camberadam
Anyone who's built their own manifold is putting...

Anyone who's built their own manifold is putting out "kits" these days trying to make a buck; it doesn't mean they are optimally designed.
Forum: Northeast USA 05-12-2017, 11:19 AM
Replies: 9
Views: 5,059
Posted By camberadam
Balt/Essex here

Balt/Essex here
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 05-10-2017, 06:51 AM
Replies: 2
Views: 1,023
Posted By camberadam
I have the tool & extra pins from an earlier...

I have the tool & extra pins from an earlier hiccup. My main concern was if pin layout changed because you needed to modify something in the programming. Does ethanol still display under dutyc in ST...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 05-05-2017, 12:08 PM
Replies: 2
Views: 1,023
Posted By camberadam
Question switching db9 usb > db9 bluetooth

If I'm switching from the standard db9 usb cable to the bluetooth db9, I just transfer my stage 3 & PI wires to the same pin positions correct?

This post was from sometime last year. Can anyone...
Forum: JB4 Mobile 05-05-2017, 09:29 AM
Replies: 4,856
Views: 1,743,843
Posted By camberadam
Question Can anyone confirm this info is still current?...

Can anyone confirm this info is still current? This comment is a little outdated at this point.

If I'm switching from the standard db9 usb cable to the bluetooth db9, I just transfer my stage 3 &...
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2020, N54tech.com