N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 100 Search: Posts Made By: DeepEddy
Forum: N54 12-03-2020, 07:12 PM
Replies: 5
Views: 69
Posted By DeepEddy
For starters

For starters
Forum: N54 12-03-2020, 07:07 PM
Replies: 5
Views: 69
Posted By DeepEddy
E Series N54 JB4 - N54Tech.com - International...

E Series N54 JB4 - N54Tech.com - International Turbo Racing Discussion (https://www.n54tech.com/forums/showthread.php?t=10605)

Start here there is a pic of default settings .
Forum: N54 12-03-2020, 07:06 PM
Replies: 5
Views: 69
Posted By DeepEddy
Now that I looked again you should really stop...

Now that I looked again you should really stop where u are and reset everything to default and go from there . Your settings are out of wack
Forum: N54 12-03-2020, 07:01 PM
Replies: 5
Views: 69
Posted By DeepEddy
tmap should be 0,1or 2 depending on the trap...

tmap should be 0,1or 2 depending on the trap sensor u have installed

and 6-cyl timing settings are wrong that depends on ur dme is it msd80 for i8aos or msd81 for ijeos
Forum: N54 11-18-2020, 02:06 PM
Replies: 7
Views: 338
Posted By DeepEddy
They jb4 harness and factory harness have arrows...

They jb4 harness and factory harness have arrows on them and should be pointing the same direction , but not on the same side when connected. Maybe a pin in u connectors is coming out or not fully...
Forum: N54 11-17-2020, 02:34 PM
Replies: 7
Views: 338
Posted By DeepEddy
Did u mess up the jb4? Or something is no...

Did u mess up the jb4? Or something is no connected correctly , check see arrows on connectors are facing same way
Forum: N54 11-17-2020, 02:32 PM
Replies: 7
Views: 338
Posted By DeepEddy
Did u try reflashing? Are u using correct flash...

Did u try reflashing? Are u using correct flash for dme?
Forum: N54 11-17-2020, 04:37 AM
Replies: 13
Views: 353
Posted By DeepEddy
Well worth it , take ur time disconnect battery...

Well worth it , take ur time disconnect battery and go one wire at a time and get good solid connections. I extended from inside the dme housing outwards so ur wire connections are no where where...
Forum: N54 11-17-2020, 03:45 AM
Replies: 13
Views: 353
Posted By DeepEddy
Clothelectrical tape is what i used like older...

Clothelectrical tape is what i used like older bmw's .ur best bet is ebay or Craigslistor something similar.
I extended my harness 20 inches so only injector wiring is on valve cover while the rest...
Forum: N54 11-17-2020, 03:27 AM
Replies: 13
Views: 353
Posted By DeepEddy
https://www.ecstuning.com/b-genuine-bmw-parts/fuel...

https://www.ecstuning.com/b-genuine-bmw-parts/fuel-injection-harness/12517566507/
Forum: N54 11-16-2020, 06:14 PM
Replies: 13
Views: 353
Posted By DeepEddy
:happy Thats a good start. Post your codes and...

:happy
Thats a good start. Post your codes and let's get it figured out.
Forum: N54 11-16-2020, 05:28 PM
Replies: 13
Views: 353
Posted By DeepEddy
Bentley BMW 3 Series (E90, E91, E92, E93) Service...

Bentley BMW 3 Series (E90, E91, E92, E93) Service Manual: 2006-2010 (http://www.georgebelton.com/335i.tech/bentley.php)

Bentley manula download with wiring might help also
Forum: N54 11-15-2020, 06:07 AM
Replies: 13
Views: 353
Posted By DeepEddy
BMW MSV70 MSV80 MSD80 NOx emulator 30EA 30E9...

BMW MSV70 MSV80 MSD80 NOx emulator 30EA 30E9 catalytic converter (https://bimmerprofs.com/msd80-pinout/)
Forum: N54 11-15-2020, 06:06 AM
Replies: 13
Views: 353
Posted By DeepEddy
https://bimmerprofs.com/msd80-pinout/ DME...

https://bimmerprofs.com/msd80-pinout/

DME pinout is what u need
Forum: Support & Log Review 11-14-2020, 03:43 PM
Replies: 14
Views: 251
Posted By DeepEddy
II know all about being frustratedwith this cars...

II know all about being frustratedwith this cars and there gremlins. FRM go bad if the get shorted and sometimes for no reason . If its cold where ur at maybe a battery problem or alternator. The...
Forum: Support & Log Review 11-13-2020, 04:51 PM
Replies: 14
Views: 251
Posted By DeepEddy
what codes do you get after clear them . The ...

what codes do you get after clear them . The whole list u mentioned up top or something different, maybe less or more?
Forum: Support & Log Review 11-13-2020, 04:48 PM
Replies: 14
Views: 251
Posted By DeepEddy
looks good .

looks good .
Forum: Support & Log Review 11-11-2020, 04:56 PM
Replies: 14
Views: 251
Posted By DeepEddy
there is a recall on batt + cable to fuse box...

there is a recall on batt + cable to fuse box because of corrosion. Mine melted my fuse box and had to be replaced. I replaced it again two months ago because the dealership reinstalled all the old...
Forum: Support & Log Review 11-11-2020, 04:15 PM
Replies: 14
Views: 251
Posted By DeepEddy
Wipers have a relay and 30amp fuse in the fuse...

Wipers have a relay and 30amp fuse in the fuse box next to each other but would not cause wipers to stay on more likely they would not turn on at all.
I know from experience that if you disconnect...
Forum: Support & Log Review 11-11-2020, 04:05 PM
Replies: 14
Views: 251
Posted By DeepEddy
[B]Ground strap is underneath the car were...

[B]Ground strap is underneath the car were transmissionand engine mate driver side . Are you clearing cel after repairs with anything ? You need to be able to read and delete codes. Removing the fuse...
Forum: Support & Log Review 11-11-2020, 07:22 AM
Replies: 14
Views: 251
Posted By DeepEddy
Ground strap from frame to right side engine...

Ground strap from frame to right side engine mount is the one u need to check, its a braided steel strap. JB4 ground wire? Fuse box connections or corrosion. I'm on third fuse box , first one...
Forum: Support & Log Review 11-11-2020, 05:55 AM
Replies: 23
Views: 301
Posted By DeepEddy
Did u check ground strap thats frame to engine...

Did u check ground strap thats frame to engine mount? JB4 ground wire connection? Reset dme , cas, dsc or power distribution with ProTool?
Corroded fuse box connections? I'm on my 3rd fuse box at...
Forum: N54 11-02-2020, 04:31 PM
Replies: 9
Views: 6,168
Posted By DeepEddy
After being dead in my driveway for over two...

After being dead in my driveway for over two weeks. This thread got me up and running. Glad I found it .
Forum: N54 09-04-2020, 05:30 PM
Replies: 9
Views: 721
Posted By DeepEddy
U probably have to bite the bullet and buy new...

U probably have to bite the bullet and buy new injectors, preferably from fcp euro for a lifetime guarantee. U can buy just three run then in either bank 1 or 2 and see if that condition ...
Forum: N54 09-04-2020, 12:29 PM
Replies: 5
Views: 425
Posted By DeepEddy
google My Bimmer Brain for all his contact info,...

google My Bimmer Brain for all his contact info, coded my buddies frm for 100$ remotely
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2020, N54tech.com