N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 100 Search: Posts Made By: JBoe
Forum: Support & Log Review Yesterday, 08:16 AM
Replies: 4
Views: 29
Posted By JBoe
Looks like a similar fault some get after install...

Looks like a similar fault some get after install while the DME is adapting to the JB4s modifications. Just reset and try again in similar conditions. The DME should learn around it and be fine. If...
Forum: B58, B48 Yesterday, 08:10 AM
Replies: 5
Views: 940
Posted By JBoe
You need the OBD connection to get the full...

You need the OBD connection to get the full benefits of the JB4. That includes the sensor readings/logs for better diagnostics. Get that installed asap.
Forum: Support & Log Review 10-13-2019, 11:13 PM
Replies: 1
Views: 21
Posted By JBoe
Yeup... IATs are getting high and will negate...

Yeup... IATs are getting high and will negate power. Look at your timing. It's low, which takes power out. Test/Compare in cooler outside temps to see the real difference. In 90 plus, for me, 3rd...
Forum: B58, B48 10-13-2019, 11:03 PM
Replies: 5
Views: 940
Posted By JBoe
V14 has the update for accurately logging HPFP...

V14 has the update for accurately logging HPFP levels. I don't think they were accurate prior to it.

AFR varies a lot on the B58. If you're comparing AFRs, you'll need to look at trims, IAT, ...
Forum: B58, B48 10-13-2019, 09:31 AM
Replies: 71
Views: 20,679
Posted By JBoe
Lots of requests for updates now that BEF is...

Lots of requests for updates now that BEF is available, but no answers. Either their deep in tuning mode or still figuring out how to tune this setup. Hope for answers soon as this was my next path...
Forum: B58, B48 10-07-2019, 05:45 PM
Replies: 364
Views: 32,305
Posted By JBoe
Have you been working with Terry? You should be...

Have you been working with Terry? You should be emailing him your maps. Also, from my knowledge, you should be on race/meth map if you are using the BEF with meth. Get in touch with Terry and he...
Forum: Support & Log Review 10-05-2019, 11:35 PM
Replies: 4
Views: 87
Posted By JBoe
Post some logs with psi back to low and RPM high...

Post some logs with psi back to low and RPM high to show that it's not working. Terry or Payam can review and provide feedback. There may be a setting off that's causing the issue.
Forum: Support & Log Review 09-30-2019, 10:34 PM
Replies: 4
Views: 87
Posted By JBoe
I'm not an expert on what you're attempting, but...

I'm not an expert on what you're attempting, but have some thoughts/questions. I see you are changing maps, did you enable meth on all maps? If you want progressive disabled, but only active above...
Forum: B58, B48 09-30-2019, 07:55 PM
Replies: 12
Views: 649
Posted By JBoe
Really want to see some longer pulls in 3rd and...

Really want to see some longer pulls in 3rd and 4th gear from 2k-redline/shift.
Forum: B58, B48 09-24-2019, 10:58 PM
Replies: 5
Views: 319
Posted By JBoe
Try upgrading firmware as well. I haven't...

Try upgrading firmware as well. I haven't checked, but BMS is working on the gauge issues through the latest firmware.
Forum: B58, B48 09-24-2019, 10:55 PM
Replies: 12
Views: 649
Posted By JBoe
Second that... I'd definitely be interested in...

Second that... I'd definitely be interested in the logs prior to your turbo going out. It's good to see such things and establish limits. Unfortunately... Someone always has to be first in discovery.
Forum: B58, B48 09-21-2019, 08:52 PM
Replies: 12
Views: 649
Posted By JBoe
Good info as I've been curious about turbo...

Good info as I've been curious about turbo upgrades. How did you blow out the stock turbo? What boost level were you at when it went out?
Forum: B58, B48 09-20-2019, 06:48 AM
Replies: 12
Views: 867
Posted By JBoe
It's on first page/post in the BEF thread. B58...

It's on first page/post in the BEF thread. B58 MHD Back End Flash Maps - N54Tech.com - International Turbo Racing Discussion (https://www.n54tech.com/forums/showthread.php?t=57432)

Map 7 uses...
Forum: B58, B48 09-19-2019, 06:28 PM
Replies: 12
Views: 867
Posted By JBoe
You should wait for Payam to respond/assist, but...

You should wait for Payam to respond/assist, but I see no reason to use the Auto boost reduction or to have adjusted FF. I see that you bias settings are driving down boost. 50= stock(no...
Forum: Support & Log Review 09-13-2019, 10:54 PM
Replies: 9
Views: 1,044
Posted By JBoe
I stand corrected... Lol.

I stand corrected... Lol.
Forum: Support & Log Review 09-10-2019, 03:04 PM
Replies: 9
Views: 1,044
Posted By JBoe
Not in a posted firmware. Terry supplied him with...

Not in a posted firmware. Terry supplied him with a custom firmware to meet his request. BMS rocks it like that. Great support!
Forum: Support & Log Review 09-10-2019, 03:00 PM
Replies: 11
Views: 502
Posted By JBoe
Our cars need Octane for sure. To me, the cooling...

Our cars need Octane for sure. To me, the cooling system/intercooler can't handle higher boost's heat load very well either. That's another reason why chose to go with both an Octane booster and WMI....
Forum: Support & Log Review 09-09-2019, 11:09 PM
Replies: 11
Views: 502
Posted By JBoe
You're timing is low and FOL is high at 60. Our...

You're timing is low and FOL is high at 60. Our cars like fuel, but they need Octane. Looks like map 2 is it for you right now and even that looks a little on edge. Some have been able to get map 3...
Forum: Support & Log Review 09-04-2019, 08:16 PM
Replies: 1
Views: 268
Posted By JBoe
Wrong support section... Post in the one below...

Wrong support section... Post in the one below and you're more likely to get good feedback.

N54 - N54Tech.com - International Turbo Racing Discussion...
Forum: B58, B48 08-31-2019, 08:11 PM
Replies: 14
Views: 1,381
Posted By JBoe
Your posting questions in a forum that isn't...

Your posting questions in a forum that isn't monitored by XHP. It's also relatively new, so fee members have experience with it. Best option would be to contact manufacturer (XHP) directly. Please...
Forum: Support & Log Review 08-20-2019, 08:57 PM
Replies: 2
Views: 883
Posted By JBoe
Need to post logs... Otherwise we can't help much.

Need to post logs... Otherwise we can't help much.
Forum: Support & Log Review 08-08-2019, 07:17 AM
Replies: 3
Views: 331
Posted By JBoe
That's correct. I recently asked this in the BEF,...

That's correct. I recently asked this in the BEF, or Firmware/Settings thread and Terry confirmed. It was just a week or so ago. If you want, search my post history and you'll find it.
Forum: Support & Log Review 08-07-2019, 11:44 PM
Replies: 3
Views: 331
Posted By JBoe
If you don't have BEF and FUD 6 enabled, the...

If you don't have BEF and FUD 6 enabled, the mapping is the same as V11. It only changes when you have V13+ and FUD 6 enabled. Stick with map 2... Same as before. Hope this helps to clarify.
Forum: B58, B48 08-05-2019, 06:30 PM
Replies: 1
Views: 1,416
Posted By JBoe
I'd say map 2... +4psi.

I'd say map 2... +4psi.
Forum: Kia & Hyundai Turbo 08-05-2019, 07:37 AM
Replies: 7
Views: 896
Posted By JBoe
It's easy to spark an argument with such a topic....

It's easy to spark an argument with such a topic. I'm definitely not going to do so and I don't read any posts, such as these, with ill will. I just shared my experience and thoughts as that was...
Search took 0.02 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2018, N54tech.com