N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 100 Search: Posts Made By: ajsalida
Forum: N54 06-25-2018, 08:56 AM
Replies: 4
Views: 274
Posted By ajsalida
e9x 335XI AT 3.46, MT 3.08. F&R obviously.

e9x 335XI AT 3.46, MT 3.08. F&R obviously.
Forum: N54 03-19-2018, 12:50 PM
Replies: 8
Views: 678
Posted By ajsalida
Looking over old logs of mine, winter when...

Looking over old logs of mine, winter when exterior temps are low (mid 30's) meth only dropped IAT's 10-12 deg but could not cool down to ambient (eg IAT went from 65 to 53). Summer with exterior...
Forum: N54 09-24-2017, 04:46 PM
Replies: 43
Views: 6,928
Posted By ajsalida
Ooops you're right.

Ooops you're right.
Forum: N54 09-24-2017, 12:48 PM
Replies: 43
Views: 6,928
Posted By ajsalida
There's now a stage 3 v 1.5 out, or was when I...

There's now a stage 3 v 1.5 out, or was when I checked this AM. Notes say only change is it stays in 6th in sport mode longer without downshifting. Going to try it here in a but.
Forum: N54 09-18-2017, 07:20 AM
Replies: 43
Views: 6,928
Posted By ajsalida
I never said you were lying, I have no doubt you...

I never said you were lying, I have no doubt you are having problems but I doubt it is due to your car being IJEOS. If it is not due to some issue with JB4 single turbo firmware itself perhaps it is...
Forum: N54 09-18-2017, 03:39 AM
Replies: 43
Views: 6,928
Posted By ajsalida
Not true. My car has IJEOS also and had no...

Not true. My car has IJEOS also and had no issues flashing xHP (recent) or various JB4 BEF's (a few years). Some have indicated problems might be related to using older JB4 firmware, mine is most...
Forum: N54 07-15-2017, 05:12 AM
Replies: 14
Views: 3,631
Posted By ajsalida
http://www.bimmerboost.com/showthread.php?83739-Ar...

http://www.bimmerboost.com/showthread.php?83739-Article-Pump-gas-power-E82-135i-w-DocRace-6266-N54-turbo-kit-makes-559-rear-wheel-horsepower
Forum: N54 06-18-2017, 09:33 AM
Replies: 502
Views: 89,641
Posted By ajsalida
From scratch: 2009 335xi, w/ IJEOS ECU, 32.8 JB4...

From scratch: 2009 335xi, w/ IJEOS ECU, 32.8 JB4 firmware. Note with latest/recent firmware JB4 automatically goes into bypass mode when an OBD2 cable is detected, you don't even have to set it at...
Forum: N54 06-17-2017, 05:41 PM
Replies: 502
Views: 89,641
Posted By ajsalida
OK just flashed OTS map 3, version 1.3, 2009...

OK just flashed OTS map 3, version 1.3, 2009 335xi. Zero issues flashing thru JB4, later firmware automatically sets to map 0 when cable is connected. I did have a small issue I think was battery...
Forum: N54 06-17-2017, 02:51 PM
Replies: 502
Views: 89,641
Posted By ajsalida
Excellent, thanks guys.

Excellent, thanks guys.
Forum: N54 06-17-2017, 01:35 PM
Replies: 502
Views: 89,641
Posted By ajsalida
Good to know, thanks. Anyone with 335i/xi IJEOS...

Good to know, thanks. Anyone with 335i/xi IJEOS ECU and JB4 firmware 32.8? I really don't want to have to disconnect JB4 every time I flash a new xhp version or whatever.
Forum: N54 06-17-2017, 10:00 AM
Replies: 502
Views: 89,641
Posted By ajsalida
Has the req to completely disconnect JB4 prior to...

Has the req to completely disconnect JB4 prior to install been fixed, or if not has it been linked to a specific ECU or JB4 version? IJEOS running latest JB4 firmware, 32.8. Anyone with this combo...
Forum: N54 05-31-2017, 05:55 AM
Replies: 4
Views: 1,071
Posted By ajsalida
Well HP is a derived (calculated) quantity, from...

Well HP is a derived (calculated) quantity, from TQ (twisting force) is what is measured on a dyno. 500 HP @ 3500 rpm is twice the TQ as 500 HP @ 7000 rpm. So much more TQ @ lower rpm than higher...
Forum: N54 02-17-2017, 10:38 AM
Replies: 37
Views: 4,719
Posted By ajsalida
Cool. Just a word of caution to anybody doing...

Cool. Just a word of caution to anybody doing this, if the wheels/tires are still on, and you spin them up this way (on jack stands) do not apply brakes suddenly. There is a lot of angular momentum...
Forum: N54 02-17-2017, 09:33 AM
Replies: 37
Views: 4,719
Posted By ajsalida
So you had car on jack stands, no front...

So you had car on jack stands, no front driveshaft, spinning rears in the air up to 50 MPH? If so this is good to know.
Forum: N54 02-13-2017, 05:27 PM
Replies: 37
Views: 4,719
Posted By ajsalida
No, you just remove front driveshaft, between TC...

No, you just remove front driveshaft, between TC and front diff. In order to remove TC you've need a RWD transmission and rear driveshaft, and a bunch of other stuff. Note this doesn't really do...
Forum: N54 02-13-2017, 03:43 PM
Replies: 37
Views: 4,719
Posted By ajsalida
Taking out the driveshaft is a 15 min job and...

Taking out the driveshaft is a 15 min job and reversible. Taking apart the CV joints and remove front axles is more permanent and far more complicated. If you throw codes with the driveshaft out...
Forum: N54 01-30-2017, 11:48 AM
Replies: 37
Views: 4,719
Posted By ajsalida
That is a good idea.

That is a good idea.
Forum: N54 01-30-2017, 08:09 AM
Replies: 37
Views: 4,719
Posted By ajsalida
You might have a problem with the AWD electronics...

You might have a problem with the AWD electronics running the rears at 120 MPH (or whatever) on a dyno with the fronts stationary. IIRC somebody tried this for drifting and had issues. Many people...
Forum: N54 06-21-2016, 03:39 AM
Replies: 6
Views: 1,474
Posted By ajsalida
See boost curve table here ...

See boost curve table here

http://www.n54tech.com/forums/showthread.php?t=22272
Forum: DIY Modification 04-01-2016, 11:54 AM
Replies: 180
Views: 125,456
Posted By ajsalida
Sorry, got an N54. Another guy over on e90post...

Sorry, got an N54. Another guy over on e90post had same issue as you, and fixed it with the DME update. I'd see if you can confirm whether you have an older version or not, and if you do update it...
Forum: DIY Modification 04-01-2016, 09:23 AM
Replies: 180
Views: 125,456
Posted By ajsalida
From the very first post in this thread: "...

From the very first post in this thread:

" (some N55 engines which are rare, exhibit the rpms jumping down to zero on each shift but acts normal in every other way..This can be addressed if you...
Forum: N54 12-17-2015, 03:43 AM
Replies: 456
Views: 101,605
Posted By ajsalida
RB, please put me down for a 3" angled set,...

RB, please put me down for a 3" angled set, assuming this is what 7" VRSF FMIC requires. Thx.
Forum: N54 12-14-2015, 07:28 AM
Replies: 117
Views: 30,478
Posted By ajsalida
Excessive carbone deposits building up in this...

Excessive carbone deposits building up in this thread.
Forum: N54 12-08-2015, 03:20 AM
Replies: 24
Views: 3,498
Posted By ajsalida
Then I guess it's probably not one of those bolts.

Then I guess it's probably not one of those bolts.
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2018, N54tech.com