N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 95 Search: Posts Made By: suchtragedy
Forum: Support & Log Review 05-15-2019, 10:23 AM
Replies: 7
Views: 280
Posted By suchtragedy
Update: Found my issue. I have a V1 board and...

Update: Found my issue. I have a V1 board and previously running PWG ISO firmware and cut the diode. When I switched back I resoldered the diode but apparently either did a poor job or the...
Forum: Support & Log Review 05-13-2019, 07:16 AM
Replies: 7
Views: 280
Posted By suchtragedy
Log reattached. I think I have something...

Log reattached. I think I have something physical to chase down. My thoughts are vacuum pressure converter, waste gate actuator, vacuum line itself, or bad diverter valve. Anything else I missed? ...
Forum: N55 05-10-2019, 11:30 PM
Replies: 4
Views: 355
Posted By suchtragedy
Terminal fuse block off the positive post. ...

Terminal fuse block off the positive post.
https://encrypted-tbn0.gstatic.com/images?q=tbn%3AANd9GcRLo9IIsa83ppdeAXXqFRlJ0HcRwqrUC3anysiuz9RUjl3Plrcr
Forum: Support & Log Review 05-10-2019, 02:23 PM
Replies: 7
Views: 280
Posted By suchtragedy
New log attached, stuff I changed: 1. Flashed...

New log attached, stuff I changed:
1. Flashed JB4 FW to INT_13_T1 again
2. Flashed to BMS BEF PWG2_Race5 in MHD
3. Lowered default wastegate position and FF values

New log is short but there's...
Forum: Support & Log Review 05-09-2019, 05:35 PM
Replies: 7
Views: 280
Posted By suchtragedy
It's MHD stage 2 flash right now (flashed to...

It's MHD stage 2 flash right now (flashed to enable xHP trans flash) but I can flash the latest BMS BEF and relog and see if that narrows it down to the flash or not.
Forum: Support & Log Review 05-09-2019, 12:50 PM
Replies: 7
Views: 280
Posted By suchtragedy
N55 PWG + BMS PI w/ Meth | Log review please!

Hey guys,

Just got done with install of BMS PI controller for direct port meth setup. I was previously running PWG ISO + CP meth kit but converted back to integrated and flashed to...
Forum: N55 04-22-2019, 08:05 AM
Replies: 3
Views: 718
Posted By suchtragedy
I've done this replacement before on my N55 and...

I've done this replacement before on my N55 and no issues. Same procedure except I did the priming process as well, but that's just weird. I imagine if there was a oil pump/pressure issue it would...
Forum: N55 04-22-2019, 07:38 AM
Replies: 1,055
Views: 171,488
Posted By suchtragedy
+1 for same question because I have done this as...

+1 for same question because I have done this as well since BEF maps here aren't supporting xHP options yet.
Forum: N55 04-12-2019, 07:41 AM
Replies: 71
Views: 5,579
Posted By suchtragedy
Installed an F10 N55 cover on and it's not...

Installed an F10 N55 cover on and it's not perfect but it works. Had to do some minor Dremel trimming but it doesn't look half bad. It's mainly secured in the front with a bolt that goes through it...
Forum: N55 04-02-2019, 11:29 PM
Replies: 71
Views: 5,579
Posted By suchtragedy
Link to pics below. So far this is just physical...

Link to pics below. So far this is just physical manifold installed. I'll have to do the plumbing and wiring this weekend. I will probably have a few install/config/setup questions.
...
Forum: N55 04-02-2019, 07:04 AM
Replies: 71
Views: 5,579
Posted By suchtragedy
I just installed the N55 Phoenix manifold and I...

I just installed the N55 Phoenix manifold and I confirm I also needed these extra bolts and had to go source them myself. Only difference is I went with x4 M8 x 45mm bolts instead because 50mm is...
Forum: Support & Log Review 04-01-2019, 08:11 AM
Replies: 4
Views: 244
Posted By suchtragedy
Here's a log on map2, hopefully this will help...

Here's a log on map2, hopefully this will help your baseline. Let me know what you think.
Forum: Support & Log Review 03-28-2019, 10:42 AM
Replies: 4
Views: 244
Posted By suchtragedy
I will switch to Map2 and relog again just to...

I will switch to Map2 and relog again just to make baselining easier for now. Thanks Terry.
Forum: N55 03-28-2019, 10:06 AM
Replies: 3,742
Views: 1,283,111
Posted By suchtragedy
I just posted a log run using this firmware in...

I just posted a log run using this firmware in the support section :)
Forum: Support & Log Review 03-28-2019, 10:02 AM
Replies: 4
Views: 244
Posted By suchtragedy
N55_F_PWG_INT_13_T1 + MHD BEF log review

Hey Terry/All,

I just resoldered my JB4 board from PWG ISO back to integrated and re-flashed to the latest PWG firmware (N55_F_PWG_INT_13_T1.hex) and this is my first baseline log. Looking for...
Forum: N55 05-16-2018, 09:39 AM
Replies: 1,451
Views: 201,722
Posted By suchtragedy
Emailed log with drivetrain error captured during...

Emailed log with drivetrain error captured during log + BEF file. I can reproduce the malfunction pretty easily so I won't mind testing the potential fix.
Forum: N55 04-18-2018, 05:51 PM
Replies: 1,055
Views: 171,488
Posted By suchtragedy
Got off work today and car started and issue...

Got off work today and car started and issue gone. I still think the double N20 enabled option both in MHD and JB4 caused the error and undoing it in MHD reversed the issue I had but maybe I just...
Forum: N55 04-18-2018, 10:30 AM
Replies: 1,055
Views: 171,488
Posted By suchtragedy
You are correct, however the checkbox is...

You are correct, however the checkbox is available as a flash option for stock flash in 0.993b. I flashed this with N20 TMAP checked, then flashed BEF PWG2 Race4c and the checkbox shows grayed out...
Forum: N55 04-18-2018, 08:39 AM
Replies: 1,055
Views: 171,488
Posted By suchtragedy
Caution, potential bug in MHD 0.993b, see below. ...

Caution, potential bug in MHD 0.993b, see below.

4/18/18: I just loaded MHD 0.993b stock map0 that came out today (update with N20 TMAP flash option) and now getting permanent drivetrain...
Forum: N55 04-10-2018, 11:13 AM
Replies: 61
Views: 11,724
Posted By suchtragedy
Interested in this trans cooler, subbed. FYI...

Interested in this trans cooler, subbed. FYI thank you sir you helped me with something I had been struggling with regarding my plan for an upgraded oil cooler setup. I had been researching options...
Forum: N55 04-10-2018, 10:48 AM
Replies: 1,055
Views: 171,488
Posted By suchtragedy
Hmm weird, only post #2 and forward were showing...

Hmm weird, only post #2 and forward were showing up for me earlier but things look normal. Maybe I am just a derp. Thanks sir.
Forum: N55 04-10-2018, 06:27 AM
Replies: 1,055
Views: 171,488
Posted By suchtragedy
Yayyy! I assume this is why first sticky post...

Yayyy! I assume this is why first sticky post with Terry's MHD F series maps download is no longer posted right now? I assume he's taken it down to rework and repost soon.
Forum: N55 04-05-2018, 08:45 AM
Replies: 1,451
Views: 201,722
Posted By suchtragedy
Rebumping for log review plz :D

Rebumping for log review plz :D
Forum: N55 04-04-2018, 10:53 AM
Replies: 1,451
Views: 201,722
Posted By suchtragedy
I run 90/10 blend. I used to run boost juice but...

I run 90/10 blend. I used to run boost juice but when I got the PS2 my fuel trims were maxing out pretty bad. I swapped to 90/10 blend and after more logging I finally settled on dual CM10/CM10...
Forum: N55 04-04-2018, 09:35 AM
Replies: 1,451
Views: 201,722
Posted By suchtragedy
I've tried E85 blends but since I don't have...

I've tried E85 blends but since I don't have ethanol sensor set up my experience has been inconsistent when compared to just running Meth. The nearest E85 station is 2 hours from me so meth is just...
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2019, N54tech.com