N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 100 Search: Posts Made By: Tony@VargasTurboTech
Forum: N54 09-26-2018, 07:40 PM
Replies: 19
Views: 2,301
I can answer that. I actually assembled the...

I can answer that. I actually assembled the motor, and got it back into the car with our stock location inlets on it. Front, and rear. I forgot terry had moved coolant tank to driver side to make...
Forum: N54 04-21-2018, 09:57 AM
Replies: 3
Views: 997
That is normal, the secondary HPFP is adding...

That is normal, the secondary HPFP is adding extra fuel, and the DME controlled pump sees it, and is adjusting for it. You can see oscillations at times. You can fine tune AIC map to lessen or get...
Forum: N54 04-21-2018, 09:54 AM
Replies: 18
Views: 2,273
When running hard expect exhaust temps from...

When running hard expect exhaust temps from 1400-1850F. You can only get accurate EGT's pre-turbo, using race grade thermocouples. Using the laser thermometer is a waste of time.

This is our set...
Forum: N54 04-12-2018, 09:30 AM
Replies: 35
Views: 4,896
Again, that's a cool story, Rob, you are full of...

Again, that's a cool story, Rob, you are full of suggestions. Here is mine to you. Worry about our own products, why you are literally in EVERY single VTT thread at this point is a little...
Forum: N54 04-12-2018, 07:42 AM
Replies: 35
Views: 4,896
We have sold over 250 sets of GC's, and GC Lites....

We have sold over 250 sets of GC's, and GC Lites. Take that number, and go search every forum, and facebook group for failure posts, and do the math to find a percentage. Its extremely small, other...
Forum: N54 04-10-2018, 12:24 PM
Replies: 35
Views: 4,896
Not at all. Just find his posts hilarious. Go...

Not at all. Just find his posts hilarious. Go check any post in the past 3 months about VTT turbos. You will find Rob in it, not go find any RB threads in the past year, you will never find us in...
Forum: N54 04-10-2018, 11:54 AM
Replies: 35
Views: 4,896
Another Cool Story Rob, except that rating was...

Another Cool Story Rob, except that rating was referring to a cast wheel 12 blade TD04HL-19T, very inefficient old school design. It's like comparing an old cast Garrett T-series compressor map that...
Forum: N54 04-05-2018, 07:53 AM
Replies: 32
Views: 3,402
Cool Story Rob, did they send you photos of RB...

Cool Story Rob, did they send you photos of RB logos on the car? How about results, did they win?

Using our turbos, the car won its series and had not a single issue the entire season. But "Real"...
Forum: N54 04-04-2018, 07:10 AM
Replies: 32
Views: 3,402
Cool, where are the photos of this race car, we...

Cool, where are the photos of this race car, we would love to see it? You literally cannot let anyone post anything without being right there with a response. It's like the friend who cannot wait for...
Forum: N54 04-04-2018, 07:00 AM
Replies: 32
Views: 3,402
Yeah, there is no dedicated track cars running...

Yeah, there is no dedicated track cars running twins. None... This is only about 1 of 4 dedicated track cars we sponsor. Serious race teams don't have time for forums or the BS that comes with it....
Forum: N54 04-04-2018, 06:45 AM
Replies: 10
Views: 1,564
Spool is all in the tune. Lites have been shown...

Spool is all in the tune. Lites have been shown to spool faster than stock turbos with proper vanos, and tune set up. This is how Lites look on a 600WHP customer car, with a single barrel only. No...
Forum: N54 03-13-2018, 06:21 AM
Replies: 109
Views: 13,737
Rob, exactly where would a rear inlet "burn"...

Rob, exactly where would a rear inlet "burn" through? Can you point out to us the place where a rear inlet runs near a heat source hot enough to melt silicone? As for Terry carrying RB knocks offs....
Forum: N54 03-10-2018, 06:57 AM
Replies: 13
Views: 1,726
Didn't know these existed, just ordered two, one...

Didn't know these existed, just ordered two, one for each shop car.
Forum: N54 03-09-2018, 06:59 AM
Replies: 13
Views: 1,726
I know what you mean by crushed. It would seem no...

I know what you mean by crushed. It would seem no one else does. It is fairly common for these cars to suck the oil filter to the center section, making it distort (BMW, MANN they all do it). If you...
Forum: N54 02-15-2018, 07:24 AM
Replies: 7
Views: 1,879
We run the Vibrant race mufflers on the shop car....

We run the Vibrant race mufflers on the shop car. Previously we had dual 3" ********* split into a single 4", with a 4" Bottle style resonator Vibrant 17960 then dump. Honestly, it is still the best...
Forum: N54 02-07-2018, 08:38 AM
Replies: 42
Views: 9,293
Tq Spikes like that don't usually break ring...

Tq Spikes like that don't usually break ring lands which would bring compression down. They do bend rods though. Payam Text me that, I told him he has at least 2-3 bent rods now. LOL. We drove our...
Forum: N54 02-05-2018, 02:59 PM
Replies: 826
Views: 237,179
As stated, we appreciate the feedback! You sir...

As stated, we appreciate the feedback! You sir enjoy the rest of your day!
Forum: N54 02-05-2018, 02:47 PM
Replies: 826
Views: 237,179
No hard feelings on our end, we can’t keep...

No hard feelings on our end, we can’t keep product in stock as it is currently anyway. Have a nice day sir, we appreciate your feedback! Enjoy your Frankenturbos!
Forum: N54 01-12-2018, 08:21 AM
Replies: 42
Views: 9,293
The car was making consistent 700+WHP at multiple...

The car was making consistent 700+WHP at multiple events with the motiv kit on it before the engine went, and it couldn't break 170, 33WHP is gonna pick up 6-7MPH traps?.. :) I guess its possible, we...
Forum: N54 01-03-2018, 06:27 AM
Replies: 42
Views: 9,293
Looking good brother! Glad you got her back up...

Looking good brother! Glad you got her back up and running!
Forum: N54 11-21-2017, 07:35 AM
Replies: 10
Views: 1,305
Stock trunk liner in our out?

Stock trunk liner in our out?
Forum: N54 11-13-2017, 07:51 AM
Replies: 16
Views: 2,382
No way, I can do a head gasket swap in the car in...

No way, I can do a head gasket swap in the car in under 10 hours. Pulling a motor and transferring everything over is a huge hassle. If you are running the right turbos, just two V-bands and the head...
Forum: N54 11-09-2017, 06:52 AM
Replies: 31
Views: 5,434
Seems like he topped out the aero of the 1 series...

Seems like he topped out the aero of the 1 series about 177, just wouldn't pick up that extra 500 RPM to get him over 200. I don't have the balls to stay in it that long
Forum: N54 11-07-2017, 12:57 PM
Replies: 246
Views: 28,825
Looks great T nice work! For all the people...

Looks great T nice work! For all the people whining about full 3". Our intercooler is 2.5" in 3" out, we obviously do not have any issue making power or going fast, so it's not an issue for anyone...
Forum: Track days, timeslips, and kill stories 10-29-2017, 04:55 PM
Replies: 22
Views: 2,928
Sorry I missed you guys, the car is up, and...

Sorry I missed you guys, the car is up, and running making more power than it ever has, but as I mentioned in the email, dealing some wiring gremlins, which I can't stand. Wiring is the worst!...
Search took 0.02 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2019, N54tech.com