N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 100 Search: Posts Made By: Abear
Forum: N55 09-06-2018, 07:41 AM
Replies: 868
Views: 70,795
Posted By Abear
Terry, I updated to the 16 test firmware...

Terry, I updated to the 16 test firmware yesterday and pulled a log, and running the EWG PI BEF.
Forum: N55 08-18-2018, 10:38 AM
Replies: 868
Views: 70,795
Posted By Abear
Terry, if I were to change those 2 parameters,...

Terry, if I were to change those 2 parameters, would there be anything else I need to change? My car is very healthy at 25psi, but when targeting above that I get closures too. I want to try 26-28...
Forum: N55 08-09-2018, 06:23 AM
Replies: 3,585
Views: 1,031,051
Posted By Abear
Pretty sure the answer to this is yes, I think...

Pretty sure the answer to this is yes, I think Terry changed the logic in the newer firmwares. If you update past ewg14 without changing the duty bias, you will be under target boost.
Forum: N55 08-03-2018, 03:08 PM
Replies: 150
Views: 5,513
Posted By Abear
I didnt want you to spend money, just a...

I didnt want you to spend money, just a suggestion of what could be wrong, and what I went through. Seems you found the issue though.
Forum: N55 07-25-2018, 03:24 PM
Replies: 150
Views: 5,513
Posted By Abear
I think the actuator is around $500 dollars, so I...

I think the actuator is around $500 dollars, so I would be pretty skeptical to replace it too, but honestly I think that may be the culprit.

This sounds like what mine was doing. When we ran the...
Forum: N55 07-25-2018, 09:40 AM
Replies: 150
Views: 5,513
Posted By Abear
The part number for your car is the same as the...

The part number for your car is the same as the one for mine. 11-65-8-659-883. I stole your VIN from the picture you posted.

It could be the actuator, or it could be a stuck arm on the turbo. Im...
Forum: N55 07-24-2018, 03:43 PM
Replies: 150
Views: 5,513
Posted By Abear
Is it actually having trouble moving the arm?...

Is it actually having trouble moving the arm? Maybe the arm is too tight and the procedure wont run correctly?

I had trouble with mine at one point as well, ended up replacing the actuator and it...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 06-28-2018, 01:35 PM
Replies: 211
Views: 13,322
Posted By Abear
If you havent had an actual tuner take a look a...

If you havent had an actual tuner take a look a the custom tune in while, I would send a log off to a tuner of your choice. I havent got a custom tune yet, just busy with other things right now. Dont...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 06-28-2018, 10:03 AM
Replies: 211
Views: 13,322
Posted By Abear
Looks good man. No Timing corrections, even with...

Looks good man. No Timing corrections, even with our stupid Houston heat. Ive got the ER Intercooler on mine and my temps are just as high. Crazy to think that even at 7 in the evening its still so...
Forum: N55 06-27-2018, 09:18 AM
Replies: 3,585
Views: 1,031,051
Posted By Abear
Looks like you may have a boost leak somewhere....

Looks like you may have a boost leak somewhere. WGDC is maxed and FF is maxed.
Forum: N55 06-21-2018, 09:24 AM
Replies: 3,585
Views: 1,031,051
Posted By Abear
Pull the negative cable for a minute or so.

Pull the negative cable for a minute or so.
Forum: N55 06-06-2018, 03:25 PM
Replies: 868
Views: 70,795
Posted By Abear
Let me know if you need help or logs. I run with...

Let me know if you need help or logs. I run with the MAF disconnected always. No issues besides the CEL :)
Forum: N55 04-26-2018, 10:29 AM
Replies: 868
Views: 70,795
Posted By Abear
Not sure if this would be a question for you...

Not sure if this would be a question for you Terry, or Martial, but is there a way to code out the MAF sensor for those of us that run with it disconnected. The only reason my CEL light is on is the...
Forum: N55 04-16-2018, 07:10 AM
Replies: 868
Views: 70,795
Posted By Abear
Car feels super strong. To me, the logs look...

Car feels super strong. To me, the logs look pretty good, trims dip for a bit in 4th gear, but honestly, besides doing logs, the car is not really in the rpm range for very long where it dips.
Just...
Forum: N55 04-10-2018, 02:51 PM
Replies: 6
Views: 427
Posted By Abear
I used to run 19psi on e30-e40 before I had meth,...

I used to run 19psi on e30-e40 before I had meth, but I did have the fuel-it stg 2 pump. So not completely stock fuel.
Forum: N55 04-05-2018, 10:49 AM
Replies: 868
Views: 70,795
Posted By Abear
Turning up the boost fixed my trims issue,...

Turning up the boost fixed my trims issue, :burnrubber:
Forum: N55 03-30-2018, 07:25 AM
Replies: 868
Views: 70,795
Posted By Abear
Terry, here is another log at 23psi flat. I have...

Terry, here is another log at 23psi flat. I have no idea what it was in that last log that made it read such a huge dip in to rich, but it looks fine on this log. Trims still bottoming even at 0 FOL,...
Forum: N55 03-29-2018, 01:51 PM
Replies: 868
Views: 70,795
Posted By Abear
Did he email about it? Mine is still on 0.99.

Did he email about it? Mine is still on 0.99.
Forum: N55 03-27-2018, 09:07 AM
Replies: 868
Views: 70,795
Posted By Abear
Have you updated the newest ISO T8 firmware,...

Have you updated the newest ISO T8 firmware, looks like they fixed a fault code bug.
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 03-27-2018, 08:50 AM
Replies: 30
Views: 1,222
Posted By Abear
You more than likely have a small boost leak....

You more than likely have a small boost leak. Even on E-series Im pretty sure PS2 can get to 24psi before maxing itself out. Check this thread out for finding a boost...
Forum: N55 03-27-2018, 08:32 AM
Replies: 868
Views: 70,795
Posted By Abear
I just had to change the rear O2, it was faulty....

I just had to change the rear O2, it was faulty. Dealer changed it out, but that was 2 or 3 weeks ago, does it need to adapt? Also, what is the meth reading, I dont have meth anymore. I didnt even...
Forum: N55 03-27-2018, 08:07 AM
Replies: 868
Views: 70,795
Posted By Abear
Terry, I changed FOL to 0. Looks like afr goes...

Terry, I changed FOL to 0. Looks like afr goes super rich at tip in, figured it would be the opposite with fol lower?
Forum: N55 03-23-2018, 08:57 AM
Replies: 868
Views: 70,795
Posted By Abear
So I finally got around to flashing and doing a...

So I finally got around to flashing and doing a log. I reset my map 6 to a flat boost at 20psi, reset fuel and duty bias to 50. Log looks ok to me, HPFP is dipping, probably need to back off the E a...
Forum: N55 03-13-2018, 02:18 PM
Replies: 868
Views: 70,795
Posted By Abear
The mhd app found my file when I put in the...

The mhd app found my file when I put in the download folder. It was there as soon as clicked back end flash in the mhd app.
Forum: N55 03-07-2018, 04:33 PM
Replies: 868
Views: 70,795
Posted By Abear
Pretty sure if it doesnt burble, its not...

Pretty sure if it doesnt burble, its not considered fast. :shrug



:lol:lol:lol

On a more MHD related note, Terry, for PureStg2 BEF's do we still email you or do the maps posted apply to...
Search took 0.02 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2018, N54tech.com