N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 100 Search: Posts Made By: Terry @ BMS
Forum: Support & Log Review Today, 02:21 PM
Replies: 3
Views: 23
Posted By Terry @ BMS
Email me a log and I can look in to it further,...

Email me a log and I can look in to it further, terry@burgertuning.com
Forum: B58, B48 Today, 11:44 AM
Replies: 4
Views: 136
Posted By Terry @ BMS
Issue looks to be due to over boosting from...

Issue looks to be due to over boosting from exhaust mods, with EWG we can dial that in. I think I'm already helping you via email. :burnrubber:
Forum: B58, B48 Today, 11:43 AM
Replies: 4
Views: 136
Posted By Terry @ BMS
Do not make that change, BMS support requires...

Do not make that change, BMS support requires logs to be combined if you want us to look at them for tuning advice. :drinking:
Forum: Support & Log Review Today, 10:53 AM
Replies: 3
Views: 23
Posted By Terry @ BMS
Is it a V1 PWG board? We made some changes to the...

Is it a V1 PWG board? We made some changes to the latest firmware that may only work on V2 boards.
Forum: N63, N63TU Today, 10:53 AM
Replies: 15
Views: 243
Posted By Terry @ BMS
We have the updated connectors required but have...

We have the updated connectors required but have not made adapters yet for them.
Forum: Support & Log Review Yesterday, 11:34 AM
Replies: 1
Views: 39
Posted By Terry @ BMS
The log is clean but I think there is another...

The log is clean but I think there is another 15-20hp in here with our RACE BEF. :)
Forum: B58, B48 Yesterday, 09:49 AM
Replies: 5
Views: 267
Posted By Terry @ BMS
Maybe damaged the 2580 on the board? We have...

Maybe damaged the 2580 on the board? We have those on our site for $25, just plugs in. Handles communications for the board.
Forum: Kia & Hyundai Turbo 01-25-2021, 06:31 PM
Replies: 2
Views: 57
Posted By Terry @ BMS
No need, 0.022 is fine for the factory tuning.

No need, 0.022 is fine for the factory tuning.
Forum: Infiniti Q50 Q60 VR30DDTT 01-25-2021, 06:17 PM
Replies: 5,845
Views: 763,939
Posted By Terry @ BMS
Sounds good. If you need more just get the...

Sounds good. If you need more just get the Stage1->JB4 upgrade kit on our site. :)
Forum: N63, N63TU 01-25-2021, 02:07 PM
Replies: 10
Views: 177
Posted By Terry @ BMS
Email me a log and reminder to go through the...

Email me a log and reminder to go through the firmware. terry@burgertuning.com
Forum: Support & Log Review 01-25-2021, 01:59 PM
Replies: 2
Views: 29
Posted By Terry @ BMS
Was it working before then stopped? Or new...

Was it working before then stopped? Or new install that has never worked?
Forum: Infiniti Q50 Q60 VR30DDTT 01-25-2021, 10:41 AM
Replies: 5,845
Views: 763,939
Posted By Terry @ BMS
Not a lot of full throttle in the logs but I...

Not a lot of full throttle in the logs but I didn't spot any issues either. :burnrubber:
Forum: Infiniti Q50 Q60 VR30DDTT 01-25-2021, 10:40 AM
Replies: 5,845
Views: 763,939
Posted By Terry @ BMS
There are no firmware updates for Stage1, just...

There are no firmware updates for Stage1, just those two settings you can play with. With more boost peak torque is shifted higher on the power band, but at no point do you ever make less torque than...
Forum: B58, B48 01-25-2021, 10:19 AM
Replies: 1,939
Views: 659,202
Posted By Terry @ BMS
It's a test feature added to the latest firmware...

It's a test feature added to the latest firmware for testing purposes. We have not published what it does intentionally. But directions for use are provided in the notes for those who want to test it...
Forum: N63, N63TU 01-25-2021, 09:58 AM
Replies: 10
Views: 177
Posted By Terry @ BMS
Once we confirm it's OBDII related I'll start...

Once we confirm it's OBDII related I'll start digging around for possible causes.
Forum: B58, B48 01-24-2021, 06:20 PM
Replies: 234
Views: 6,787
Posted By Terry @ BMS
You could lower duty bias at 5000rpm and below to...

You could lower duty bias at 5000rpm and below to try to avoid that over boost you get at the start of your run. Maybe subtract 5 per 500rpm from 5000 down.

In the future set app to combine runs...
Forum: Mercedes C250, C300, C43, AMG 01-24-2021, 06:06 PM
Replies: 3
Views: 51
Posted By Terry @ BMS
Sorry to hear about the headaches! Have some...

Sorry to hear about the headaches! Have some photos of your engine bay so we can locate the right sensors for you? Looking at your reference it appears to be 150 and 40.
Forum: N55 01-24-2021, 04:44 PM
Replies: 7
Views: 157
Posted By Terry @ BMS
It takes a few minutes for the baro to be...

It takes a few minutes for the baro to be recalculated at startup so perhaps you're just looking at it before the algorithm kicks in, if it later goes to 0? In any event we can always check it out...
Forum: N55 01-24-2021, 10:45 AM
Replies: 3,878
Views: 1,509,135
Posted By Terry @ BMS
Relog once EWG is on, and also log map5 which is...

Relog once EWG is on, and also log map5 which is an absolute boost target, so we can compare. With EWG on we should see more boost here especially on map5.
Forum: N55 01-24-2021, 10:43 AM
Replies: 7
Views: 157
Posted By Terry @ BMS
Sensor is absolute but PSI reading is not, it's...

Sensor is absolute but PSI reading is not, it's based off a starting point. The JB4's base barometric pressure.

Doesn't look like anything is actually wrong to me.

What is your elevation?
Forum: //M 01-24-2021, 10:41 AM
Replies: 803
Views: 128,443
Posted By Terry @ BMS
The BMS intake will add some top end power. Not...

The BMS intake will add some top end power. Not huge gains, but worth the low cost and easy install. Plus they sound and look great!
Forum: N54 01-23-2021, 03:36 PM
Replies: 3
Views: 95
Posted By Terry @ BMS
A board itself without a harness is not worth...

A board itself without a harness is not worth much. We sell those for $175 on our site for a brand new one.
Forum: Infiniti Q50 Q60 VR30DDTT 01-23-2021, 01:06 PM
Replies: 386
Views: 19,060
Posted By Terry @ BMS
We tested it for awhile in our development car...

We tested it for awhile in our development car and it didn't really do what we expected, and is just so hard to reach I don't think it's practical for customers to install. So we're currently...
Forum: Kia & Hyundai Turbo 01-23-2021, 10:50 AM
Replies: 3,973
Views: 448,565
Posted By Terry @ BMS
v22 is production firmware now. lagfix is...

v22 is production firmware now. lagfix is disabled by default but remains a user adjustable option. To enable you'll need to manually raise the DWP setting above 0.

We left it that way as a few...
Forum: Kia & Hyundai Turbo 01-22-2021, 05:56 PM
Replies: 332
Views: 33,010
Posted By Terry @ BMS
EWG Connector 1: Blue wire: Pin 19 Purple...

EWG Connector 1:
Blue wire: Pin 19
Purple Wire: Pin 9

EWG Connector 2:
Blue wire: Pin 14
Purple wire: Pin 8
Search took 0.02 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2020, N54tech.com