N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 100 Search: Posts Made By: blackhat75
Forum: N55 08-07-2019, 08:53 PM
Replies: 2
Views: 1,044
Posted By blackhat75
Does anyone know if the default 1/4" push...

Does anyone know if the default 1/4" push fittings in the 30-3015 pump are removable? Anyone?
Forum: N55 08-05-2019, 11:11 AM
Replies: 1
Views: 1,019
Posted By blackhat75
I think a coolant flush is a good idea. I...

I think a coolant flush is a good idea. I wouldn't pay $200 for it though. I think some oil change places do it for $50. Better yet, do it yourself. I hope it all works out.
Forum: N55 08-05-2019, 11:08 AM
Replies: 2
Views: 1,044
Posted By blackhat75
meth pump head fitting question

Hey guys,
Has anyone tried to remove the default push fittings installed in the AEM/Shurflo 30-3015 water/meth pump? I'm finally switching all my lines over to tight compression fittings. The leaks...
Forum: N55 07-16-2019, 10:32 AM
Replies: 6
Views: 1,424
Posted By blackhat75
Me? I replaced the whole thing cause I didn't...

Me? I replaced the whole thing cause I didn't want to hassle with dissecting the PCV system. Just did the whole thing. Only cost like ~$120
Forum: N55 07-16-2019, 08:03 AM
Replies: 6
Views: 1,424
Posted By blackhat75
I had a belt type squeal not too long ago. I...

I had a belt type squeal not too long ago. I tried belt dressing which didn't do anything. I noticed the squeal was even present after turning off the car. I read the PCV system can cause air to be...
Forum: N55 06-30-2019, 08:35 AM
Replies: 480
Views: 129,120
Posted By blackhat75
6 O-rings for the PI manifold route, 12 O-rings...

6 O-rings for the PI manifold route, 12 O-rings used for sandwiching the PI spacer plate route.
Forum: N55 06-11-2019, 07:35 AM
Replies: 2
Views: 1,780
Posted By blackhat75
I've never had my settings change by...

I've never had my settings change by themselves(minus trims n stuff).
Forum: Support & Log Review 05-25-2019, 03:42 PM
Replies: 3
Views: 266
Posted By blackhat75
It's either air, fuel or spark. Kindof sounds...

It's either air, fuel or spark.
Kindof sounds like fuel cut. Isn't map2 16-18 psi? I don't have MHD. Don't you need to choose your map according to oct fuel rating Variants (US OCT ACN91, 91, 93,...
Forum: DIY Modification 05-25-2019, 03:26 PM
Replies: 1
Views: 679
Posted By blackhat75
This is the hood I want but it's for the early...

This is the hood I want but it's for the early pre-LCI(facelift):
GTR-STYLE CARBON FIBER HOOD FOR 2007-2010 BMW E92 3 SERIES COUPE*...
Forum: Support & Log Review 05-23-2019, 09:07 PM
Replies: 23
Views: 826
Posted By blackhat75
:popcorn

:popcorn
Forum: JB4 Mobile 05-16-2019, 04:51 AM
Replies: 4,809
Views: 1,512,943
Posted By blackhat75
:brokenheart: Don't give up BEAST!! It's...

:brokenheart:
Don't give up BEAST!!

It's probably just a phone setting...
Forum: DIY Modification 05-14-2019, 12:15 PM
Replies: 1
Views: 679
Posted By blackhat75
E92 Pre-LCI/Facelift hood fitment on LCI E92

Due to a lack of options, I'm looking into the possibilities of fitting an early E92 pre facelift 335i hood onto my LCI(2012) E92 335i. I've been searching for months and I'm not finding much...
Forum: JB4 Mobile 05-04-2019, 06:54 PM
Replies: 4,809
Views: 1,512,943
Posted By blackhat75
The JB4's pseudo-boost gauge only displays...

The JB4's pseudo-boost gauge only displays positive pressure. When at idle or just cruising around, it'll read 0.
Forum: N55 05-01-2019, 08:28 PM
Replies: 1,055
Views: 169,466
Posted By blackhat75
Sorry, after dinner I realized I may have been a...

Sorry, after dinner I realized I may have been a bit 'hangry' and slapped unprovoked.
Everyone's cars are different and have different tunes+upgrades. A bef maximizes the tune the best it can for...
Forum: N55 05-01-2019, 07:48 PM
Replies: 1,055
Views: 169,466
Posted By blackhat75
Are you seriously asking this here and now, 39...

Are you seriously asking this here and now, 39 pages deep? Millennial?:slap
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 04-22-2019, 07:36 AM
Replies: 25
Views: 6,224
Posted By blackhat75
Only need to change the charge pipe sensor. Make...

Only need to change the charge pipe sensor. Make sure you the correct sensor. Make sure you wired it correctly. Make sure your JB4 is set correctly to read the sensor you have(N20 TMAP =0 or 1).
...
Forum: N55 04-19-2019, 01:08 PM
Replies: 2
Views: 396
Posted By blackhat75
Hey thomas, I was hoping there wasn't a big...

Hey thomas, I was hoping there wasn't a big difference between intakes. I think I'm going to get the BMS flat intake thing for $199. It'll give me the hood and manifold clearance margins I need and...
Forum: N55 04-18-2019, 06:39 PM
Replies: 2
Views: 396
Posted By blackhat75
stock intake restrictiveness?

Heylo,
How restrictive is the OEM intake piping leading to the turbo up and over the N55 engine? I currently have the Injen system but recently, I'm running into issues with space(PI manifold,...
Forum: N54 04-11-2019, 04:52 AM
Replies: 25
Views: 1,181
Posted By blackhat75
:facepalm: Save your time and money and upgrade...

:facepalm:
Save your time and money and upgrade the turbos already...stop beating a dead horse, there's no more.
Forum: N55 04-08-2019, 12:24 PM
Replies: 480
Views: 129,120
Posted By blackhat75
Well that about exhaust's my ideas. As far as...

Well that about exhaust's my ideas. As far as answering your original question; whether meth safety:3 and meth trigger:1 are correct, I don't think those apply to PI but since your FSB is still...
Forum: N55 04-08-2019, 11:10 AM
Replies: 480
Views: 129,120
Posted By blackhat75
So your pump that's feeding meth to everything is...

So your pump that's feeding meth to everything is turning on but no meth is coming out?

Can you see your request(FuelEN) and response(Meth) traces in your log graph?

Meth scaling set to 100?
...
Forum: N55 04-08-2019, 10:20 AM
Replies: 480
Views: 129,120
Posted By blackhat75
So you have the JB4 connected to both BMS PI...

So you have the JB4 connected to both BMS PI controller and FSB. PI controller is suppose to fire your port injectors and the FSB is wired to only spray a single CM3 in CP? What's turning on you...
Forum: N54 04-07-2019, 09:35 AM
Replies: 19
Views: 739
Posted By blackhat75
Where's OP? :popcorn:popcorn:popcorn We wan't...

Where's OP?
:popcorn:popcorn:popcorn
We wan't updates, pictures, videos!!!
Forum: N54 04-07-2019, 09:27 AM
Replies: 25
Views: 1,181
Posted By blackhat75
Don't you have to hold down the left volume-down...

Don't you have to hold down the left volume-down button while heating tires in the burnout box to bypass the 2-step? I thought I ready Terry mentioning this...
Forum: Support & Log Review 04-06-2019, 07:51 PM
Replies: 14
Views: 386
Posted By blackhat75
I'm getting more comfortable making a run,...

I'm getting more comfortable making a run, inspecting it, saving, uploading, etc. in order to get some much needed advice.

I think, after trying a few setting adjustments, I've got the PI sorted...
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2018, N54tech.com