JB4tech.com - International Turbo Tuning Discussion
Register Search Today's Posts Mark Forums Read
Go Back   JB4tech.com - International Turbo Tuning Discussion > Search Forums
Reload this Page Search Results
Page 1 of 2 1 2
Showing results 1 to 25 of 30 Search: Posts Made By: F10M5RD
Forum: //M 06-24-2018, 11:30 AM
Replies: 26
Views: 8,099
Posted By F10M5RD
Should i set PID to 22 as well?

Should i set PID to 22 as well?
Forum: //M 06-24-2018, 10:44 AM
Replies: 26
Views: 8,099
Posted By F10M5RD
thanks

Here you go!

All suggestions welcome in order to improve performance and hopefully come close to your 6.5sec 60-130. YES BCM is installed. If I log on Map4 (my bef - OTS stage 2 BM3) boost hits...
Forum: //M 06-24-2018, 09:28 AM
Replies: 26
Views: 8,099
Posted By F10M5RD
Ohhh, so let me get this straight. If My boost by...

Ohhh, so let me get this straight. If My boost by gear is set to hit 23-26psi from 4000-4500rpm, then its going to pretty much ignore the "limit boost in third gear to 24psi" function?

So, maybe I...
Forum: //M 06-23-2018, 03:16 PM
Replies: 26
Views: 8,099
Posted By F10M5RD
is there a possibility that my BM3 OTS2 Stage 2...

is there a possibility that my BM3 OTS2 Stage 2 back-end flash is overwriting my "max boost 3rd gear = 24psi," causing the car to ignore that command an still boost up to 26 psi in third gear?
...
Forum: //M 06-23-2018, 08:45 AM
Replies: 26
Views: 8,099
Posted By F10M5RD
So I did a few runs

Here is one of the logs. Best run on draggy was 6.85 sec 60-130 flooring it at around 46mph. Sometimes i get wheel spin and I just abort. Twice I didnt. However the run was invalid due to a -1.3%...
Forum: //M 06-22-2018, 04:40 PM
Replies: 26
Views: 8,099
Posted By F10M5RD
Here you go! I have BM3 OTS Stage 2 as BEF.

Here you go! I have BM3 OTS Stage 2 as BEF.
Forum: //M 06-22-2018, 04:25 PM
Replies: 26
Views: 8,099
Posted By F10M5RD
Hey Terry quick comment: So my car has been...

Hey Terry quick comment:

So my car has been turned off all day. Just left the office, turned it on as I was leaving work, went into map 6 and set 3rd gear boost limit to 24. Tapped save and off...
Forum: //M 06-22-2018, 02:26 PM
Replies: 26
Views: 8,099
Posted By F10M5RD
great... im going to try to achieve close to...

great... im going to try to achieve close to those results tomorrow morning. Although our temps down here are in the 80s-90s. Best time so far is 7.06 60-130 with cm7 nozzles running full meth and...
Forum: //M 06-22-2018, 07:00 AM
Replies: 26
Views: 8,099
Posted By F10M5RD
this is awesome

Terry, what tire pressure were you using to achieve these results with stock OEM tires?

thanks
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 06-03-2018, 07:44 AM
Replies: 13
Views: 2,623
Posted By F10M5RD
Did a few quick pulls nothing crazy on map 8...

Did a few quick pulls nothing crazy on map 8 boost additive 20. No pulse. Shows 0 in log.

Take a look at thhis

https://m.youtube.com/watch?v=QEVBAqfNGpY
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 06-03-2018, 06:21 AM
Replies: 13
Views: 2,623
Posted By F10M5RD
I have fsb v2. So you are telling me use map 8...

I have fsb v2. So you are telling me use map 8 and go into wmi tab and select put in value of 20 in boost aditive?
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 06-02-2018, 04:02 PM
Replies: 13
Views: 2,623
Posted By F10M5RD
by the way, now the meth stays at 0. At least on...

by the way, now the meth stays at 0. At least on my previous log before I updated firmware, We were doing 7-9 in the meth column. temps were going into 113 but that could just have been the time of...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 06-02-2018, 03:55 PM
Replies: 13
Views: 2,623
Posted By F10M5RD
So here is what I Did

Before I had a JB4, I had a flash and meth installed with an external trigger that was activated at 16psi of boost. I also had manual ON/OFF button under my steering column where I can MANUALLY turn...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 06-01-2018, 01:42 PM
Replies: 13
Views: 2,623
Posted By F10M5RD
Thanks Terry. Can I continue using these...

Thanks Terry. Can I continue using these settings on Map 6 to log and just switch FUD to 0? Does everythign else look ok to inject meth on Map 6? This is a low boost/93 Oct map so I dont have to...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 05-31-2018, 06:46 PM
Replies: 13
Views: 2,623
Posted By F10M5RD
thanks guys, yes, Blue wire and Orange wire are...

thanks guys, yes, Blue wire and Orange wire are correct. Did a few pulls in 3rd and 4th gear, map 6. Ive tried Map 8, and just today I tried Map 6 with the following settings.

Attached...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 05-26-2018, 02:13 PM
Replies: 13
Views: 2,623
Posted By F10M5RD
Jb4 not injecting meth

So i finally got my meth hooked up so that jb4 controls it progressively. Installer hooked everything up. We tested the Prime button using the wmi tab in the jb4 app and all works great. However,...
Forum: //M 05-11-2018, 08:13 PM
Replies: 4
Views: 1,927
Posted By F10M5RD
Thank you for asking. My meth is kicking in 100...

Thank you for asking. My meth is kicking in 100 percent at 16psi. That is a systemi had on before i insfalled jb4+bcm.

I will have it connected so that jb4 controls meth tomorrow. By the way i...
Forum: //M 05-11-2018, 04:27 PM
Replies: 4
Views: 1,927
Posted By F10M5RD
Thank you. ******* ********* 100 percent...

Thank you.

******* *********
100 percent meth injection dual cm7 nozzles
Drop in k&n filters
Ssp clutches
Bm3 running bef stage 2 22psi.
Custom axle back exhaust
Forum: //M 05-11-2018, 02:56 PM
Replies: 4
Views: 1,927
Posted By F10M5RD
What are map7 specs for F10 M5

Can anyone chime in as to what the specs for map 7 are. I am referring to boost by gear values, duty bias, fuel bias, boost safety and boost limits in gears 1-2-3?

The reason i ask is because i...
Forum: //M 05-03-2018, 02:29 PM
Replies: 18
Views: 3,712
Posted By F10M5RD
I am currently running the OTS 93 oct stage 2...

I am currently running the OTS 93 oct stage 2 flash. I have ******* ** and meth. The car runs extremely strong and smooth. Night and day difference from stock. Stock log on jb4 for me was...
Forum: //M 05-02-2018, 04:17 AM
Replies: 18
Views: 3,712
Posted By F10M5RD
So, finally got BootMod3 - and loaded OTS Tune

Finally took the plunge and got myself Bootmod3. Loaded the free OTS/BEF that comes with the license. Just loaded it yesterday, and Have not really done several pulls for car to adapt. But here...
Forum: //M 04-30-2018, 05:18 PM
Replies: 18
Views: 3,712
Posted By F10M5RD
THANKS TErry. I briefly tried map 2. Mini pull....

THANKS TErry. I briefly tried map 2. Mini pull. That was suicidal. Afr in the 17s. I will bl post that shortly.
Forum: //M 04-30-2018, 06:31 AM
Replies: 18
Views: 3,712
Posted By F10M5RD
Ok, so, did 3 pulls in 3rd Gear. 3rd Gear...

Ok, so, did 3 pulls in 3rd Gear.

3rd Gear Map 4 - no meth
3rd Gear Map 4 - Meth
3rd Gear Map 1 - Meth

Terry, you know best... But I think I need a BEF. My car is a 2013 production I think...
Forum: //M 04-29-2018, 01:10 PM
Replies: 18
Views: 3,712
Posted By F10M5RD
So did some wastegate tests using ista and both...

So did some wastegate tests using ista and both finally closed normally. This was a good sign. Went for a drive and boy is she back. Wheels are finally spinning at wot first gear.

I will post a...
Forum: //M 04-29-2018, 07:06 AM
Replies: 18
Views: 3,712
Posted By F10M5RD
Quick update. Changed vacuum lines that go to...

Quick update. Changed vacuum lines that go to both wastegates. Also replaced both turbo boost converters. Reinstalling intercooler as we speak. Then techs will run ista tests on...
Search took 0.00 seconds.
Page 1 of 2 1 2

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright © 2007 - 2022, JB4tech.com

Contact Us - JB4tech.com - Archive - Top