N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 18 of 18 Search: Posts Made By: joebarteam74
Forum: JB4 Mobile 09-23-2021, 01:24 PM
Replies: 2
Views: 610
Posted By joebarteam74
And knock ?

ah then how to see the Knock with the LOGs of the JB4?
Forum: JB4 Mobile 09-23-2021, 11:48 AM
Replies: 2
Views: 610
Posted By joebarteam74
LOG MHD and JB4 ?

Hello

I wanted to know if it is possible to do a LOG with MHD and to use the map6 of the JB4 at the same time?

the obd port will therefore be disconnected from the JB4

thank you
Forum: B58, B48 09-22-2021, 10:49 AM
Replies: 6
Views: 840
Posted By joebarteam74
LOG MAP6 TTE580

here after reparametrage of map 6.

tell me if there are any points to correct?

thank you
joel
Forum: Support & Log Review 09-22-2021, 10:36 AM
Replies: 164
Views: 168,711
Posted By joebarteam74
MAP 6 TTE580 engine B58

hi terry

I have followed your explanation .. and I thank you ..

I therefore wanted to improve the turbo pressure and give it more stability compared to a map of a preparer with my turbo hybrid...
Forum: B58, B48 09-21-2021, 11:58 AM
Replies: 6
Views: 840
Posted By joebarteam74
JB4 MAP 6

Hi

you will find two LOG one before modification of the PWM and one after having rectified

I've disabled wastegate adaption and hard coded FF.

on the other hand after having matched the...
Forum: B58, B48 09-20-2021, 10:31 PM
Replies: 6
Views: 840
Posted By joebarteam74
JB4 + mhd paramètres

Hello,

yes I know it's voluntary ... so I'm going to do that.

simple question if the boost is at 0 psi on the map 6 JB4 does it work for the hpfp fuel open loop and boost safety correction...
Forum: B58, B48 09-20-2021, 06:10 AM
Replies: 6
Views: 840
Posted By joebarteam74
JB4 + MHD Flash custom

Hello Terry,


I would need your analysis on the LOG if attached.
I sometimes have pumping effects and also sometimes I have HPFP pressure cuts.

pureboost has redone a map to limit the turbo...
Forum: B58, B48 09-19-2021, 01:43 AM
Replies: 1
Views: 776
Posted By joebarteam74
MHD custom tune + JB4 MAP 6 control boost

Hello :)

so i'm surprised no one answers the question?

I will carry out tests to confirm the settings soon and will send you LOGs.

now if someone is able to advise me on adjustments in order...
Forum: B58, B48 09-11-2021, 10:58 PM
Replies: 1
Views: 776
Posted By joebarteam74
custom Map TTE580 + map6 JB4

Hello,

I have a turbo Hybrid the TTE580 and a Map customize by pureboost in germany.

I am not far from 580 ch but sometimes on the gear ratio of 5 and 6 em I have overboost I exceed 30psi.
...
Forum: B58, B48 05-21-2021, 01:58 PM
Replies: 5
Views: 896
Posted By joebarteam74
Log

I no longer have jb4 to connect because I have installed my mhd wifi box.

I am thinking of putting it back in place to order the wastegate precisely in addition to the MHD flash.

I can in case...
Forum: B58, B48 05-20-2021, 10:30 AM
Replies: 5
Views: 896
Posted By joebarteam74
Hi ok :)

Hi ok :)
Forum: B58, B48 05-19-2021, 09:46 PM
Replies: 5
Views: 896
Posted By joebarteam74
MAP 6 and EWG

Hi

I noticed that with an ethanol map above E40 the turbo pressure measured in the manifold drops after 5000trmin to the red zone of 7000trmin.
see log with a map in E60 made by jordan ..

I...
Forum: B58, B48 05-14-2021, 01:24 PM
Replies: 1
Views: 653
Posted By joebarteam74
[QUOTE=joebarteam74;686933]Hi all, for a...

[QUOTE=joebarteam74;686933]Hi all,

for a while I noticed that I had a lack of power at high speed.

however the car works well no fault or other.

I made a log and we can see that the pressure...
Forum: B58, B48 05-14-2021, 01:22 PM
Replies: 1
Views: 653
Posted By joebarteam74
turbo pressure dropping MHD

Hi all,

for a while I noticed that I had a lack of power at high speed.

however the car works well no fault or other.

I made a log and we can see that the pressure moves away from the target...
Forum: B58, B48 09-13-2020, 01:09 AM
Replies: 0
Views: 1,425
Posted By joebarteam74
JB4+MHD M140i

hello

I set up the jb4 for which works with the MHD FLash

which is the option parameter bit 6.

on the other hand I have installed a flash stage 1 of MHD ron 93.

I read that we can load...
Forum: B58, B48 08-21-2020, 10:45 PM
Replies: 3
Views: 1,481
Posted By joebarteam74
Forum: B58, B48 08-21-2020, 10:35 PM
Replies: 3
Views: 1,481
Posted By joebarteam74
M140i MAP 3 Shell 100 Powerchips

OK fine

I have already made a log with my car in map 3 is with gasoline with octane.

only I do not dare to accelerate too hard in case, I prefer to warn than to heal even if I am told that the...
Forum: B58, B48 08-20-2020, 09:13 PM
Replies: 3
Views: 1,481
Posted By joebarteam74
M140i Europe fuel Octane 100

Hello
I have two questions the first concerning the MAP3, I have gasoline with 100 octane shell from our Swiss neighbor, my configuration and original except the cotton air filter in the air box, Do...
Search took 0.00 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright © 2007 - 2020, N54tech.com