N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 62 Search: Posts Made By: temperamental
Forum: N54 10-06-2021, 11:25 AM
Replies: 18
Views: 473
Posted By temperamental
Not much to add to what was said or asked...

Not much to add to what was said or asked already. AFRs in Bank 2 in the second log looks terrible... Pity timing was not activated in all cylinders. The Lpfp was also starting to tank towards the...
Forum: N54 10-06-2021, 07:00 AM
Replies: 18
Views: 473
Posted By temperamental
Any csv logs

Any csv logs
Forum: N54 10-04-2021, 01:25 PM
Replies: 714
Views: 361,158
Posted By temperamental
@the beast The T9 version is good so far....

@the beast
The T9 version is good so far. Exhaust is still louder then hex 32_15 but i am getting used to it. On map 6 i had to put in my own boost targets and FB & DBs. Dialing in PI is next on my...
Forum: N54 10-04-2021, 01:17 PM
Replies: 32
Views: 3,842
Posted By temperamental
You will have to email burgertuning or fuelit...

You will have to email burgertuning or fuelit directly for guidance on the Mercedes model. This guide is specifically for the N54. Sorry.
Forum: N54 09-14-2021, 12:05 PM
Replies: 1,440
Views: 676,117
Posted By temperamental
The pi controller in the pic does have a yellow...

The pi controller in the pic does have a yellow trigger wire....but the connections dont look right and the connection to the relay needs attention.
Forum: N54 08-15-2021, 04:47 AM
Replies: 714
Views: 361,158
Posted By temperamental
Activating Bit 6 takes advantage of the latest...

Activating Bit 6 takes advantage of the latest firmware 32/16 and since you on very old firmware 32/9 i doubt it will benefit you.

Talk to your custom tuner but consider updating your firmware and...
Forum: N54 08-15-2021, 12:19 AM
Replies: 714
Views: 361,158
Posted By temperamental
The answer is yes....bit 6 must be...

The answer is yes....bit 6 must be on/activated.... So that the Jb4 can recognise you running a backend flash.

But as The Beast has mentioned to you in annother thread, it depends on how your...
Forum: N54 08-09-2021, 10:34 AM
Replies: 6
Views: 407
Posted By temperamental
In your pic: Sensor 4 = Bank 1 Sensor 5 =...

In your pic:
Sensor 4 = Bank 1
Sensor 5 = Bank 2

Those are the rear Lambda sensors (Post *** or Behind ***)

Front Lambda sensors also referred to as Pre-*** are numbers 1 & 2
Forum: N54 07-26-2021, 02:27 PM
Replies: 32
Views: 3,842
Posted By temperamental
I read your previous posts. I think you may be...

I read your previous posts. I think you may be running the Fuelit blutooth kit where you van view your ethanol content in the Fuelit or Jb4 app which is not what this thread is about.

This thread...
Forum: N54 07-26-2021, 02:02 PM
Replies: 32
Views: 3,842
Posted By temperamental
You need to request the specific FF Backend Flash...

You need to request the specific FF Backend Flash from terry for stock turbos then activate Bit 6 and you good to go.
Forum: N54 07-26-2021, 10:46 AM
Replies: 32
Views: 3,842
Posted By temperamental
Excellent. Choose a Jb4 map of your choice...

Excellent.
Choose a Jb4 map of your choice based on your mods.

I use map5 daily and a map6 as a fun map. Read about the new jb4 hybrid mapping here: JB4 N54 Hybrid Turbo Setup Directions - Page...
Forum: N54 07-11-2021, 12:35 PM
Replies: 714
Views: 361,158
Posted By temperamental
My map 5 and map 7 fuel and duty bias settings...

My map 5 and map 7 fuel and duty bias settings looked like the attached screenshot.
Forum: N54 07-11-2021, 12:25 PM
Replies: 714
Views: 361,158
Posted By temperamental
FB, DB and user settings that were out of whack.

FB, DB and user settings that were out of whack.
Forum: N54 07-11-2021, 09:59 AM
Replies: 714
Views: 361,158
Posted By temperamental
Terrys suggestion to save settings for each map...

Terrys suggestion to save settings for each map (5,6,7,8) solved my issue. Thank you.:burnrubber:
Forum: N54 07-09-2021, 07:05 AM
Replies: 714
Views: 361,158
Posted By temperamental
Will try that @Stevae

Will try that @Stevae
Forum: N54 07-08-2021, 08:36 AM
Replies: 3
Views: 430
Posted By temperamental
Read the Eseries N54 and Hybrid turbos stickys'....

Read the Eseries N54 and Hybrid turbos stickys'. Last pages. Quite a few users experiencing that disappearing act.
Forum: N54 07-07-2021, 08:43 AM
Replies: 714
Views: 361,158
Posted By temperamental
Settings still changing on 32/16/T6 Map 6...

Settings still changing on 32/16/T6

Map 6 settings and FB settings remain as in pic even after changing, saving, resaving. Blinkers in the dash go on confirming the save but the settings changed...
Forum: N54 07-04-2021, 11:39 AM
Replies: 714
Views: 361,158
Posted By temperamental
Will give it a try as well.

Will give it a try as well.
Forum: N54 06-28-2021, 01:14 PM
Replies: 3
Views: 408
Posted By temperamental
See the attach image. The index #11 is circled in...

See the attach image. The index #11 is circled in red.
Forum: N54 06-28-2021, 01:09 PM
Replies: 3
Views: 408
Posted By temperamental
The index number is indicated on the extreme top...

The index number is indicated on the extreme top right of the injector. The latest is #12
Your numbers on the right are not clear.

Your numbers on the left looks like:
676
237

Are used to...
Forum: N54 06-28-2021, 07:04 AM
Replies: 32
Views: 3,842
Posted By temperamental
:burnrubber: Okay.

:burnrubber: Okay.
Forum: N54 06-28-2021, 04:48 AM
Replies: 32
Views: 3,842
Posted By temperamental
Excellent. Glad it was straightforward. Keen to...

Excellent. Glad it was straightforward. Keen to get your feedback on the new Jb firmware hex 32/16/T6
Forum: N54 06-10-2021, 11:05 AM
Replies: 714
Views: 361,158
Posted By temperamental
I experience the same issues as per the above...

I experience the same issues as per the above posters. My exhaust is unusually loud as well on the new firmware.
Decided to revert to the older firmware until issues are resolved.
Forum: N54 05-10-2021, 08:37 PM
Replies: 32
Views: 3,842
Posted By temperamental
Remove the wire (white/purple stripe wire) and...

Remove the wire (white/purple stripe wire) and put some tape at the end and tuck it aside.
Forum: N54 04-16-2021, 11:07 AM
Replies: 32
Views: 3,842
Posted By temperamental
So glad it worked out. :burnrubber:

So glad it worked out. :burnrubber:
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2020, N54tech.com