N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 22 of 22 Search: Posts Made By: 335si
Forum: N54 10-23-2013, 12:30 PM
Replies: 11,554
Views: 4,865,216
Posted By 335si
http://www.ecstuning.com/BMW-E92-335i-N54_3.0L/Eng...

http://www.ecstuning.com/BMW-E92-335i-N54_3.0L/Engine/Fuel/ES37459/
Part number: 16147163296

I definitely recommend doing both at the same time. I wish I would have done this! I'm just glad it's...
Forum: N54 10-23-2013, 10:33 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
Terry - Logs of 27.5 and the latest race flash...

Terry - Logs of 27.5 and the latest race flash sent to you via email.
Forum: N54 10-23-2013, 10:16 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
Well I have been having LP fuel issues for a few...

Well I have been having LP fuel issues for a few weeks. Logs were showing 30-40psi at WOT!

First I replaced the LPFP and relogged. Logs only showed and increase of about 5-10psi across the board....
Forum: N54 10-23-2013, 07:53 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
I thought that the LP should be in the upper...

I thought that the LP should be in the upper 60-70psi range under wide open throttle?
Forum: N54 07-26-2012, 06:49 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
Well, if you don't want to be without the tune...

Well, if you don't want to be without the tune for 2-3 weeks then I would go for the G5. I am loving the G5 right now, but I went from the 18ohm to the G5, so I really couldn't tell you how the 15ohm...
Forum: N54 07-25-2012, 06:56 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
Do you have the PnP harness or are you pin out? I...

Do you have the PnP harness or are you pin out? I have the PnP and do not have any experience with doing it via the pin out method. Therefore, I would contact Terry via email for some help.
Forum: N54 07-24-2012, 10:57 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
I was lost too and just kept reading it over and...

I was lost too and just kept reading it over and over and I think it sank in. However, the wording may be a little confusing for the less tech savy people like myself. Maybe this will help.

male...
Forum: N54 07-23-2012, 10:29 PM
Replies: 11,554
Views: 4,865,216
Posted By 335si
So should we reload the previous firmware then? I...

So should we reload the previous firmware then? I believe it was 7/1/12 correct?
Forum: N54 07-23-2012, 08:43 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
Yea I noticed this. However, I am running the FSB...

Yea I noticed this. However, I am running the FSB meth controller and I believe the correct setting is 60 if you are running the FSB.
Forum: N54 07-22-2012, 02:57 PM
Replies: 11,554
Views: 4,865,216
Posted By 335si
yep

yep
Forum: N54 07-22-2012, 11:27 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
Ha just noticed my meth flow scaling was set to...

Ha just noticed my meth flow scaling was set to the incorrect value. I am running the FSB so I set this to 60. Also, noticed my boost limit safety was set really low as well, so I set this to 19.
...
Forum: N54 07-22-2012, 09:50 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
For example, under the JB4 G4 board at 5000rpm it...

For example, under the JB4 G4 board at 5000rpm it states an afr of 55 in the default settings in the "JB4 N54 info" post. Are you saying to adjust this setting to 33?
Forum: N54 07-21-2012, 09:54 PM
Replies: 11,554
Views: 4,865,216
Posted By 335si
No I did not adjust any of the settings. What...

No I did not adjust any of the settings. What settings should I have adjusted?
Forum: N54 07-20-2012, 10:12 PM
Replies: 11,554
Views: 4,865,216
Posted By 335si
Went to the track and the conditions were awful....

Went to the track and the conditions were awful. Over 90 degrees. DA in the range of 2500 ft. I wasn't able to log as my computer was dead...Will get some logs tomorrow.

Ran best trap of 112.9mph...
Forum: N54 07-20-2012, 06:30 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
I am not expecting drastically different results...

I am not expecting drastically different results since I am on stock snails, but would think my trap would pick up 1mph due to less taper at redline due to coming from an 18ohm board, no? I will be...
Forum: N54 07-19-2012, 01:24 PM
Replies: 11,554
Views: 4,865,216
Posted By 335si
I received my G5 board today. I will be...

I received my G5 board today. I will be installing it tonight and may do a drag pass tomorrow!
Forum: N54 04-16-2012, 10:19 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
Sorry. I missed that...Doh!

Sorry. I missed that...Doh!
Forum: N54 04-16-2012, 08:12 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
Terry or anyone else running meth who has meth...

Terry or anyone else running meth who has meth flow on the oil temp gauge. Is max meth flow supposed to swing past the 340 degree mark now? Before I updated my firmware, the meth flow would max out...
Forum: N54 02-29-2012, 12:14 PM
Replies: 11,554
Views: 4,865,216
Posted By 335si
My car has been plagued with the wastegate...

My car has been plagued with the wastegate rattler forever. I have had the software updated, actuators replaced and finally the turbines replaced under warranty to no avail. The wastegates still...
Forum: N54 08-15-2011, 10:30 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
I would prefer it at 80-90% as with a manual i...

I would prefer it at 80-90% as with a manual i always trigger it with my downshifts....
Forum: N54 12-17-2010, 08:28 AM
Replies: 11,554
Views: 4,865,216
Posted By 335si
Loving the shift lights and may test out the gear...

Loving the shift lights and may test out the gear dependent boost tonight at the track!
Forum: N54 11-19-2010, 12:33 PM
Replies: 11,554
Views: 4,865,216
Posted By 335si
I hate you AT guys ;) Snapping halfshafts will be...

I hate you AT guys ;) Snapping halfshafts will be the new trend.
Search took 0.00 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2018, N54tech.com