N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 36 Search: Posts Made By: davidrbixby
Forum: N54 02-23-2017, 04:35 PM
Replies: 45
Views: 17,406
Posted By davidrbixby
Hey Steve, other than track days my stage 2 gives...

Hey Steve, other than track days my stage 2 gives me all I need. For track use, what about running the Port Injection with my Pure High Flow turbos, Fuel-it stage 2 and port injection triggered by...
Forum: N54 11-07-2015, 10:22 PM
Replies: 795
Views: 187,125
Posted By davidrbixby
G5

Terry, is this in the G5 already or does it need this upgrade for anti-lag?
Forum: N54 05-13-2015, 08:26 AM
Replies: 311
Views: 84,706
Posted By davidrbixby
The heat issue can be mitigated by using a...

The heat issue can be mitigated by using a combination of Cerakote ceramic paints on the inside and outside of the new *****. Cerakote on just the outside will decrease Temps significantly. At lower...
Forum: N54 04-14-2014, 12:47 PM
Replies: 9
Views: 2,892
Posted By davidrbixby
I run mine in South Florida summer heat at...

I run mine in South Florida summer heat at Homestead. Recommend mixing 30-50% distilled water into the meth injection, I have dual oil coolers and the BMS N54 Oil Thermostat bypass. Makes a huge...
Forum: N54 03-18-2014, 10:04 AM
Replies: 24
Views: 8,843
Posted By davidrbixby
Does anyone have any updates on the transmissions?

Does anyone have any updates on the transmissions?
Forum: N54 02-25-2014, 06:10 PM
Replies: 24
Views: 8,843
Posted By davidrbixby
Terry, Is your 1AT the same as my 08 335i AT...

Terry,

Is your 1AT the same as my 08 335i AT - GA6HP19Z

What upgrades is Level 10 going to do?
Forum: DIY Modification 02-17-2014, 08:19 AM
Replies: 132
Views: 86,947
Posted By davidrbixby
What gauge of Oil and Gasoline resistant wire is...

What gauge of Oil and Gasoline resistant wire is required?
Forum: N54 02-13-2014, 12:09 PM
Replies: 2,930
Views: 664,848
Posted By davidrbixby
On the low end <3,000 rpm how does the top mount...

On the low end <3,000 rpm how does the top mount setup compare to the RB's in spool and response? For road racing I really need that out of the corner quick spool up but would love more power in the...
Forum: N54 10-03-2012, 11:18 AM
Replies: 215
Views: 90,672
Posted By davidrbixby
Anyone getting 2ABD error codes with this sensor?

Anyone getting 2ABD error codes with this sensor?

Installed it this morning and cars idles very rough, then shots off. Only in Map 8 will it idle correctly.

N20 Part # 13627843531 + Terry's...
Forum: N54 09-23-2012, 06:52 PM
Replies: 215
Views: 90,672
Posted By davidrbixby
What is the part # for the actual 3.5 N20 TMAP...

What is the part # for the actual 3.5 N20 TMAP Sensor
Forum: N54 08-02-2012, 08:32 AM
Replies: 344
Views: 152,437
Posted By davidrbixby
Also wanted to ask Terry if there is a fuel flow...

Also wanted to ask Terry if there is a fuel flow sensor/gauge you recommend to measure meth flow.
Forum: N54 08-02-2012, 08:08 AM
Replies: 344
Views: 152,437
Posted By davidrbixby
Hey Terry. Installing RBs next week (finally) and...

Hey Terry. Installing RBs next week (finally) and the G5 going in today. Currently have dual CM10s off singe solenoid but have an extra solenoid (and pump as well). Also have the new CM12s if needed...
Forum: N54 06-15-2012, 12:39 PM
Replies: 11,443
Views: 4,493,256
Posted By davidrbixby
@Vroom, Not the issue....I have a 40 row and 16...

@Vroom, Not the issue....I have a 40 row and 16 row dual oil cooler setup. Looking for flow rates to see how quickly oil and water flow round trip above 6000 rpm, and then to see if I need to add...
Forum: N54 06-15-2012, 08:53 AM
Replies: 11,443
Views: 4,493,256
Posted By davidrbixby
Anyone know the max oil and water flow rates at...

Anyone know the max oil and water flow rates at over 6000 rpm? Trying to decide if I need to add more capacity or cooling to both for South Florida summer track days. Running RBs at 18.5 psi.
Forum: N54 03-23-2012, 06:39 AM
Replies: 3,621
Views: 757,338
Posted By davidrbixby
Rob, if you start the thread with just bullets of...

Rob, if you start the thread with just bullets of major steps, things to be careful & watch out for, I'll contribute from my install and bet we can get this flushed out within a month.
Forum: N54 02-29-2012, 05:25 PM
Replies: 3,621
Views: 757,338
Posted By davidrbixby
Rob, for road racing is MOTUL 300V 15W-50...

Rob, for road racing is MOTUL 300V 15W-50 Competition Race Oil fine for the RBs?
Forum: N54 02-03-2012, 05:43 PM
Replies: 3,621
Views: 757,338
Posted By davidrbixby
Anyone else in So Fla have the RB Turbos? I'm...

Anyone else in So Fla have the RB Turbos? I'm have mine and am getting ready to install.
Forum: N54 12-22-2011, 09:27 PM
Replies: 3,621
Views: 757,338
Posted By davidrbixby
With the RB Turbos and the JB4, is the 15ohm...

With the RB Turbos and the JB4, is the 15ohm change required to get to 19-20psi?
Forum: N54 12-16-2011, 08:20 PM
Replies: 3,621
Views: 757,338
Posted By davidrbixby
Anyone have time estimate for install by either...

Anyone have time estimate for install by either dropping or rotating engine? Any contacts, details much appreciated.
Forum: N54 10-27-2011, 10:12 AM
Replies: 11,443
Views: 4,493,256
Posted By davidrbixby
Are there any threads on tuning divertor valves?

Are there any threads on tuning divertor valves?
Forum: N54 10-27-2011, 09:18 AM
Replies: 11,443
Views: 4,493,256
Posted By davidrbixby
I went with the Fla. Chapter of PBOC (porsche BMW...

I went with the Fla. Chapter of PBOC (porsche BMW owners club). We had drivers Ed (novice-advancd), solo, and super solo sessions. Hooked on Driving has similar events and classes.
Forum: N54 10-27-2011, 07:15 AM
Replies: 11,443
Views: 4,493,256
Posted By davidrbixby
Hey Terry, lots of props on the way the JB4 and...

Hey Terry, lots of props on the way the JB4 and Meth kit ran at Daytona this weekend. Still in drivers Ed class with instructor but on 2nd of 7 track sessions I hit 138 in the middle line of the...
Forum: N54 10-18-2011, 05:37 PM
Replies: 11,443
Views: 4,493,256
Posted By davidrbixby
Terry, getting prepped for my RB Install in the...

Terry, getting prepped for my RB Install in the next few weeks. What is the benefit of using a flash tune in conjunction with the JB4 in Map 3 or 6? Anything in particular the tuner should focus on?...
Forum: N54 09-17-2011, 11:34 AM
Replies: 11,443
Views: 4,493,256
Posted By davidrbixby
That would be great if you guys do. New Tablet...

That would be great if you guys do. New Tablet PCs coming out that can easily be secured for data logging whie racing.

JB4 setup shocked a few people at Sebring last weekend. Ate up an M3 and M5...
Forum: N54 09-17-2011, 10:55 AM
Replies: 11,443
Views: 4,493,256
Posted By davidrbixby
Terry, is there any DataLogging software/hw combo...

Terry, is there any DataLogging software/hw combo that can gather JB4 specific info? I'm road racing at Homestead and Daytona next month and would like to log each 25-30min track period.
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2018, N54tech.com