N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 94 Search: Posts Made By: mattgu40
Forum: Support & Log Review 09-17-2021, 02:10 AM
Replies: 4
Views: 480
Posted By mattgu40
what does 4 meth trigger do ?

what does 4 meth trigger do ?
Forum: N54 05-30-2021, 12:00 AM
Replies: 6
Views: 802
Posted By mattgu40
+1 never had a single issue, been 4 years and...

+1
never had a single issue, been 4 years and still incredibly helpful
Forum: N54 05-21-2021, 04:35 AM
Replies: 1
Views: 642
Posted By mattgu40
Just buy Db9 connector with pins off amazon. ...

Just buy Db9 connector with pins off amazon.
...
Forum: N54 05-15-2021, 01:27 AM
Replies: 0
Views: 623
Posted By mattgu40
Port injection o'ring Size

Hi all,

Port injection injectors came on and off a couple times. anyone got a link or size for the top and bottom orings.

running Phoenix racing manifold with Meth
Forum: N54 04-04-2021, 09:04 AM
Replies: 1,095
Views: 442,185
Posted By mattgu40
Finally got it to work bit 4 ( enable beta...

Finally got it to work bit 4 ( enable beta antilag) in user adjustment have to be turned off. Very loud and satisfying
Forum: N54 01-18-2021, 07:13 AM
Replies: 1,095
Views: 442,185
Posted By mattgu40
Same boat here, Bought new 2step relay new usb...

Same boat here, Bought new 2step relay new usb cable and new antilag chip. reviewed the wiring 100 times changed ground location... antilag sort of
work but 2step wont engage.
Forum: N54 12-11-2020, 04:20 PM
Replies: 1,095
Views: 442,185
Posted By mattgu40
Not sure my 2step relay is working as menu 8 is...

Not sure my 2step relay is working as menu 8 is not doing anything / not activating. Changed relay doublechecked everything.
Tried it with MHD rev limiter/ launch control...
3.4k rpm 14psi
5200...
Forum: N54 08-09-2020, 02:48 AM
Replies: 6
Views: 1,141
Posted By mattgu40
got to the bottom of this ? Same issues...

got to the bottom of this ?

Same issues here Nothing work since PI
Forum: N54 08-05-2020, 12:24 AM
Replies: 3
Views: 963
Posted By mattgu40
If you are planning to PI meth 550 is more than...

If you are planning to PI meth 550 is more than suffisent IMO
Forum: Support & Log Review 05-23-2020, 11:07 PM
Replies: 1
Views: 605
Posted By mattgu40
165k km GC 1.0 meth PI

for review car feels great.
20 000km on vargas GC 1.0
100%meth PI + pump gas.
Jb4 + custom BEF. PR coils .22 gap plugs

Why are trims bottoming out ? Too much meth? Should i run lower...
Forum: Support & Log Review 02-25-2020, 07:15 PM
Replies: 49
Views: 4,352
Posted By mattgu40
Toughts ?

Toughts ?
Forum: Support & Log Review 02-20-2020, 11:33 AM
Replies: 49
Views: 4,352
Posted By mattgu40
Would like some more info too 26 psi trims 0-8 ...

Would like some more info too 26 psi trims 0-8 too much meth ?..
port injection meth
Forum: N54 02-13-2020, 10:24 PM
Replies: 1,095
Views: 442,185
Posted By mattgu40
Same would like some detailed installation...

Same would like some detailed installation instruction as it all changed 100 times
Forum: N54 01-18-2020, 06:28 AM
Replies: 1,095
Views: 442,185
Posted By mattgu40
Will do so once weather allow then report here. ...

Will do so once weather allow then report here.

Thank you
Forum: N54 01-16-2020, 01:25 AM
Replies: 1,095
Views: 442,185
Posted By mattgu40
do i need to physically remove the relay for this...

do i need to physically remove the relay for this ?
Forum: N54 01-15-2020, 09:59 AM
Replies: 1,095
Views: 442,185
Posted By mattgu40
here is a recentish WOT pull, and 2 antilag/...

here is a recentish WOT pull, and 2 antilag/ 2step attempt a while back all i got for now.

BMS Pi controller Meth PI, PR coil...
Forum: N54 01-13-2020, 12:07 AM
Replies: 1,095
Views: 442,185
Posted By mattgu40
Anyone had issues with antilag/2step and...

Anyone had issues with antilag/2step and aftermarket coil setup ?
i think my PR coils are what causing the issues.

when attempting rolling antilag with volume down and full throttle cause the car...
Forum: N54 12-05-2019, 02:23 AM
Replies: 265
Views: 152,933
Posted By mattgu40
Everything been running good for a while now,...

Everything been running good for a while now, appart from 2step/antilag and NLS

Looking at option for the best way to integrate an additional nozzle in the charge pipe to reduce IAT at sensor.
...
Forum: N54 11-18-2019, 07:34 PM
Replies: 48
Views: 5,413
Posted By mattgu40
Exhaust leak or ***** vibrating on something /...

Exhaust leak or ***** vibrating on something / together.

Maybe the mid cats are in bad shape. Could add resonators
Forum: Support & Log Review 10-10-2019, 04:41 AM
Replies: 4
Views: 824
Posted By mattgu40
Having the same issue here IJE0S. Clutch...

Having the same issue here IJE0S.

Clutch pedal input verified and working
switch to a older firmware and 2 step work

newest firmware with BEF tables changed for antilag
- 2step alone no rev...
Forum: Support & Log Review 08-21-2019, 06:34 AM
Replies: 2
Views: 1,007
Posted By mattgu40
Did you removed the metal disc holding the bolt ?

Did you removed the metal disc holding the bolt ?
Forum: Support & Log Review 08-13-2019, 10:51 AM
Replies: 7
Views: 884
Posted By mattgu40
Got refused the dyno as he seen the xdrive tag . ...

Got refused the dyno as he seen the xdrive tag . Got xdelete but he said if something goes wrong. Suggested tu pull front driveshaft in parking lot he still declined.

Hope the knock tables are...
Forum: Support & Log Review 08-12-2019, 03:00 PM
Replies: 7
Views: 884
Posted By mattgu40
Any way to fix the problems without changing the...

Any way to fix the problems without changing the custum tune as he is away
Forum: Support & Log Review 08-12-2019, 11:56 AM
Replies: 7
Views: 884
Posted By mattgu40
Dyno tomorrow Log Review

Hi there.

going on the dyno tomorrow morning and would like some fine tuning and advices before. will post after

JB4+ Custom BEF
Pump+ meth port injection 550cc
Fbo
VTT GC 1 with inlet and...
Forum: JB4 Mobile 07-03-2019, 04:26 AM
Replies: 18
Views: 7,369
Posted By mattgu40
Good to know, i would like to retain Bluetooth...

Good to know, i would like to retain Bluetooth functions will see if i can tap a usb wire directly into the bluetooth adapter if really stuck and nothing work
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2020, N54tech.com