N54Tech.com - International Turbo Racing Discussion
Register Search Today's Posts Mark Forums Read
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 25 Search: Posts Made By: Streetpro
Forum: Support & Log Review 01-13-2020, 03:49 AM
Replies: 39
Views: 1,358
Posted By Streetpro
I was fighting this one some time ago, thinking I...

I was fighting this one some time ago, thinking I have bad o-rings on cooler lines, changed them twice just to discover the above... there was no clearly visible source as the oil was creeping over...
Forum: N54 11-06-2019, 06:13 AM
Replies: 14
Views: 8,178
Posted By Streetpro
That is what I did... using Vette C7 rear oil...

That is what I did... using Vette C7 rear oil cooler inlets (just the opposite way)... works fine...
Forum: Support & Log Review 10-08-2019, 12:22 AM
Replies: 8
Views: 904
Posted By Streetpro
Well, I think I have a fair mechanical/engine...

Well, I think I have a fair mechanical/engine knowledge (I know a lot of people think this way :-) ) to foresee that knock sensor is not the culprit of this issue... they fail very seldom but since...
Forum: Support & Log Review 10-07-2019, 01:50 AM
Replies: 8
Views: 904
Posted By Streetpro
Ok, the fault is coming on again in even shorter...

Ok, the fault is coming on again in even shorter periods after start-up from cold (30-50km), once I stop and restart it does not come back even for a long run (let say 500km). Strange, I will replace...
Forum: DIY Modification 10-07-2019, 01:47 AM
Replies: 14
Views: 6,550
Posted By Streetpro
The problem is not the sound but the fact that wg...

The problem is not the sound but the fact that wg is not closing properly due to a wobble in that respective wg shaft. So yes, up to a certain moment this could be a fix but in a long run you need to...
Forum: N54 07-22-2019, 12:09 AM
Replies: 105
Views: 18,894
Posted By Streetpro
AT oil heats up by itself very quickly no matter...

AT oil heats up by itself very quickly no matter of heat exchanger... the purpose of that heat exchanger is really to combat high temps, not the low ones...
Forum: N54 07-01-2019, 04:50 AM
Replies: 105
Views: 18,894
Posted By Streetpro
Sorry, vent as for ventilator or fan/blower if...

Sorry, vent as for ventilator or fan/blower if you like... anything to force feed air through the core at idle/low speed (bellow 30 or so, after that incoming air does the job).
Plus to have a...
Forum: DIY Modification 06-27-2019, 02:33 AM
Replies: 0
Views: 5,475
Posted By Streetpro
Hood vents e92 - Vette C7

1 - get some rear air inlets from Corvette C7 (lot of guys replace them with modded/carbon parts)... Ebay?
2 - do careful measurements, try to place it up front as possible (otherwise it will hit...
Forum: N54 06-27-2019, 02:17 AM
Replies: 105
Views: 18,894
Posted By Streetpro
Stock heat exchanger cools oil just after it...

Stock heat exchanger cools oil just after it reaches 200 degs by opening the passage in the water leg - T-stat is controlling the water, there is no T-stat in the oil line...
Otherwise the oil...
Forum: Wheels and Tires 06-24-2019, 05:40 AM
Replies: 1
Views: 5,988
Posted By Streetpro
Just to conclude for anyone going the same road> ...

Just to conclude for anyone going the same road>
Ultraleggeras 8x and 9x18 et40 are just fine, no need to add spacers (only for looks, technically it clears/works fine), GY Eagle F1 Assymetric 3 (RF...
Forum: N54 06-24-2019, 05:32 AM
Replies: 105
Views: 18,894
Posted By Streetpro
T-stat doesn't cost $250 but it is surely you who...

T-stat doesn't cost $250 but it is surely you who decide the price of the complete kit...
Forum: Suspension and Brakes 05-19-2019, 11:53 PM
Replies: 6
Views: 2,803
Posted By Streetpro
I have just exchanged the rear shocks (Sachs)...

I have just exchanged the rear shocks (Sachs) with all the related bushings etc + rear sway bar (stock was 13mm, now it is M3 22,5mm irrc) and M3 supporting frame silentblocks...
Well, the result is...
Forum: N54 05-14-2019, 01:59 AM
Replies: 36
Views: 14,827
Posted By Streetpro
I have swapped from 2.93 to 3.15 (M52) and from...

I have swapped from 2.93 to 3.15 (M52) and from 3.15 to 3.23 (S50)... in both cases it was a positive and let say a decent way of speeding a car a bit... however both are old and NA engines...
I am...
Forum: Wheels and Tires 03-18-2019, 08:06 AM
Replies: 1
Views: 5,988
Posted By Streetpro
OZ Ultraleggera R18 on e92

After a rather long chase for low weight wheels I've kind of stumbled across a staggered set of 8x18 et40 + 9x18 et40 OZ Ultraleggera in mat black.
What shims should I run front (15mm)-rear...
Forum: N54 03-13-2019, 01:09 AM
Replies: 4
Views: 766
Posted By Streetpro
Yeah... cause you need two and then you are left...

Yeah... cause you need two and then you are left with only one out of the 3-pack hence the chance that you could actually duplicate is quite high...
Forum: N54 03-08-2019, 06:09 AM
Replies: 17
Views: 1,507
Posted By Streetpro
Having an air leak especially in an FI engine is...

Having an air leak especially in an FI engine is not good...
Forum: Support & Log Review 02-18-2019, 02:24 AM
Replies: 8
Views: 904
Posted By Streetpro
Update - 900km trip with a new ping sensors (they...

Update - 900km trip with a new ping sensors (they come in two already) laying comfortably in an oem paper box scared the **** out my N54 (I guess) and no fault resurfaced so far :-) Maybe it is...
Forum: Off-Topic Discussions 02-12-2019, 03:28 AM
Replies: 7
Views: 4,247
Posted By Streetpro
Any Borat not jokes? My n54 has no leaks... ...

Any Borat not jokes?

My n54 has no leaks...
.
.
.
not!
Forum: N54 02-12-2019, 02:02 AM
Replies: 3
Views: 736
Posted By Streetpro
It is tight but is doable, it is two person job,...

It is tight but is doable, it is two person job, one from above, other under, you know the scene :-) irc I had to angle it somehow and pry the AT cooler a bit out of the way to let that plastic...
Forum: Support & Log Review 02-11-2019, 05:56 AM
Replies: 10
Views: 689
Posted By Streetpro
I had a similar issue while car was responding...

I had a similar issue while car was responding with a delay or rather not building the boost right of the line and it turned out to be vanos solenoid related... and it was not giving any codes at the...
Forum: Support & Log Review 02-11-2019, 01:08 AM
Replies: 8
Views: 904
Posted By Streetpro
The fault comes around in between 2200-2400 rpm...

The fault comes around in between 2200-2400 rpm (steady driving on a highway, cc on), I find it rather low rpm (plus no load while cruising at 120km/h) for any knock to occur, not?
voltage knock...
Forum: DIY Modification 02-07-2019, 03:56 AM
Replies: 4
Views: 2,743
Posted By Streetpro
That PS reservoir has a built-in filter therefore...

That PS reservoir has a built-in filter therefore you might want to incorporate this in your idea too. Just make sure you have a double wall between those two and you should be fine regarding the...
Forum: DIY Modification 02-07-2019, 03:36 AM
Replies: 17
Views: 12,058
Posted By Streetpro
The more you take them out, the more likely you...

The more you take them out, the more likely you will experience why Bmw prescribes to change that teflon lining that seals the injector in head.
Not to mention that under that pressure the...
Forum: Suspension and Brakes 02-06-2019, 05:48 AM
Replies: 1
Views: 2,317
Posted By Streetpro
I have just replaced front M3 arms on 335iA coupe...

I have just replaced front M3 arms on 335iA coupe 06 (160k miles) and it has transformed the whole car... before I had felt the weight and the car was kind of reluctant to dive into curve but now it...
Forum: Support & Log Review 02-06-2019, 05:29 AM
Replies: 8
Views: 904
Posted By Streetpro
Detonation sensor error - after a long drive

Hi all,
I have 06 335iA (rather high mileage - 260k km/160k miles) and I had replaced recently both turbos (oem, old ones were fine, just as I had them and I was doing other stuff), all gaskets,...
Search took 0.00 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright © 2007 - 2020, N54tech.com

Contact Us - N54Tech.com - Archive - Top