N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 36 Search: Posts Made By: Domino_86
Forum: N54 03-04-2021, 09:50 PM
Replies: 16
Views: 5,718
Posted By Domino_86
To be honest, it sounded like you needed a new...

To be honest, it sounded like you needed a new valve cover as they do degrade over time. I went the plugged head port route and ran external pcv and I have absolutely no complaints. I dont knowcthe...
Forum: N54 11-02-2019, 10:22 AM
Replies: 69
Views: 12,341
Posted By Domino_86
Great ideas always coming from the geniuses at...

Great ideas always coming from the geniuses at BMS. I appreciate all that you guys do. Following...
Forum: N54 09-06-2019, 04:42 AM
Replies: 19
Views: 6,118
Posted By Domino_86
Check your IC piping and dawnpeep. That would...

Check your IC piping and dawnpeep. That would indicate a leaking turbo as well
Forum: N54 09-06-2019, 04:27 AM
Replies: 16
Views: 5,718
Posted By Domino_86
Omar at Vader Solutions sells a PCV block off...

Omar at Vader Solutions sells a PCV block off which I assume does the same thing. I could be wrong, but I didn't take that route due to the fact that (I think) it doesn't seal as well as tapping the...
Forum: N54 09-03-2019, 04:11 PM
Replies: 16
Views: 5,718
Posted By Domino_86
I was running 17 psi for about 2 or 3 years and...

I was running 17 psi for about 2 or 3 years and blew out a rear main seal because of it. My VCG and OPG went around the same time if not earlier. I plugged the head ports as well as changed the VC...
Forum: Support & Log Review 05-24-2019, 07:56 PM
Replies: 9
Views: 2,308
Posted By Domino_86
You will need to plug the head ports. My rear...

You will need to plug the head ports. My rear main seal pushed itself out rubbing the flywheel. And I'm pretty sure the pressure ruined my oil pan gasket as well. What I have done to fix the prob is...
Forum: N54 04-30-2019, 09:44 AM
Replies: 11,735
Views: 6,162,504
Posted By Domino_86
The answer is yes. I had asked that question on...

The answer is yes. I had asked that question on one of the forums before.
Forum: N54 04-19-2019, 10:05 AM
Replies: 86
Views: 21,113
Posted By Domino_86
Having the BMS OCC (boost side) and inlets (VRSF)...

Having the BMS OCC (boost side) and inlets (VRSF) with BMS cones is a tight, funky fit. I got tired of pulling the cone just to get to the OCC. With stock inlets it wasn't an issue. Maybe I should've...
Forum: N54 03-11-2019, 05:54 PM
Replies: 3
Views: 1,057
Posted By Domino_86
Sounds good. Change your oil as well. No need for...

Sounds good. Change your oil as well. No need for spun bearings.
Forum: N54 03-09-2019, 03:26 PM
Replies: 3
Views: 1,057
Posted By Domino_86
That's definitely leaky injectors. You need index...

That's definitely leaky injectors. You need index 12s. As fas as the coolant loss, if not external then replace oil cooler gasket and oil filter housing gasket. Replace VC and gasket if you haven't...
Forum: Support & Log Review 02-02-2019, 04:13 PM
Replies: 50
Views: 3,003
Posted By Domino_86
Do you run the latest JB4 firmware?

Do you run the latest JB4 firmware?
Forum: N54 12-31-2018, 11:30 PM
Replies: 35
Views: 7,181
Posted By Domino_86
:lol

:lol
Forum: N54 12-05-2018, 12:39 AM
Replies: 4,035
Views: 1,817,007
Posted By Domino_86
For IJE0S, what is the new gc2 bin file? Vargas?...

For IJE0S, what is the new gc2 bin file? Vargas? If so, will it work for mmps3? Also what is pump_3? The newest pump revision is assume. For a temporary hybrid bin on pump, would it be best to stick...
Forum: N54 11-06-2018, 02:44 PM
Replies: 10
Views: 1,682
Posted By Domino_86
5 at minimum. When you rev, the numbers should go...

5 at minimum. When you rev, the numbers should go up.
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 08-09-2018, 04:34 PM
Replies: 4
Views: 1,120
Posted By Domino_86
Just checking back in. The TCU reset worked! Idk...

Just checking back in. The TCU reset worked! Idk why I didn't think of that first. Thanks again and God Bless.
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 08-03-2018, 03:50 AM
Replies: 4
Views: 1,120
Posted By Domino_86
Yes it was shifting fine before. The only reason...

Yes it was shifting fine before. The only reason i had it drained/filter changed was for preventative maintenance and my rear main seal needed to be changed. The fluid used was the redline D4. I have...
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 08-02-2018, 05:01 PM
Replies: 4
Views: 1,120
Posted By Domino_86
4th gear issues

08 335 sedan, 124xxx miles, Alpina flash. I just recently got my transmission serviced. Now when i give the car moderate throttle the car has issues hesitating from 4th to 5th. Sometimes depending on...
Forum: N54 07-24-2018, 09:11 PM
Replies: 9
Views: 2,429
Posted By Domino_86
Correct me if I'm wrong, but i personally think...

Correct me if I'm wrong, but i personally think the plug is a no go. If the head ports are not plugged then the boost pressure will more than likely go into those ports. Now if you have a pcv plug on...
Forum: N54 11-01-2017, 07:41 PM
Replies: 80
Views: 10,483
Posted By Domino_86
Hook it up with that extra large tho! N54 POWA

Hook it up with that extra large tho! N54 POWA
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 10-24-2017, 08:14 PM
Replies: 3
Log
Views: 1,061
Posted By Domino_86
That's what I thought. As far as the timing goes...

That's what I thought. As far as the timing goes would a custom bef help that?
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 10-24-2017, 06:24 PM
Replies: 3
Log
Views: 1,061
Posted By Domino_86
Log

Hello. I just did a 40 mph third gear pull. Everything seems okay but I'd rather let a professional look at it. I kept having fuel trim issues and bank 1 was always rich. Since then I changed the...
Forum: N54 09-25-2017, 04:36 PM
Replies: 6
Views: 15,994
Posted By Domino_86
Yes. just follow ShocknAwe's directions and...

Yes. just follow ShocknAwe's directions and you'll be fine. The algorithm is way better than menu 10 settings. Matter of fact, when you're done applying the algorithm set menu 10 back to default. It...
Forum: N54 07-17-2017, 08:35 AM
Replies: 11,735
Views: 6,162,504
Posted By Domino_86
I set my menu 10 to 5k. I see no point in any...

I set my menu 10 to 5k. I see no point in any other setting unless you want lag and the algorithm
Forum: N54 07-08-2017, 04:52 PM
Replies: 11,735
Views: 6,162,504
Posted By Domino_86
Cool Terry. Just wanted to let you know that the waste...

Terry. Just wanted to let you know that the waste gate algorithm is the truth! Thank god no more rattle, and it seems like it gives the car a deeper exhaust note. I would think that algorithm would...
Forum: N54 07-05-2017, 07:07 PM
Replies: 11,735
Views: 6,162,504
Posted By Domino_86
+1 My SES light stays on with the c*t less down...

+1 My SES light stays on with the c*t less down p*pes detected.
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2020, N54tech.com