JB4tech.com - International Turbo Tuning Discussion
Go Back   JB4tech.com - International Turbo Tuning Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 100 Search: Posts Made By: George @ BMS
Forum: VW/Audi Group 05-25-2022, 04:02 AM
Replies: 1,038
Views: 337,604
Posted By George @ BMS
Next step will be to contact...

Next step will be to contact support@jb4connectkit.com and they can assist.
Forum: VW/Audi Group 05-24-2022, 05:33 PM
Replies: 1,038
Views: 337,604
Posted By George @ BMS
Disconnecting or not manually will not effect the...

Disconnecting or not manually will not effect the range of the bluetooth module. Some phone covers make connection worse. Also try point the actual device towards the inside of the cabin.
Forum: VW/Audi Group 05-23-2022, 09:48 AM
Replies: 1,134
Views: 489,879
Posted By George @ BMS
Unfortunately this cannot be done with the JB4.

Unfortunately this cannot be done with the JB4.
Forum: VW/Audi Group 05-23-2022, 06:00 AM
Replies: 1,038
Views: 337,604
Posted By George @ BMS
On this model and 93 map 3 is the recommended...

On this model and 93 map 3 is the recommended map. With logs in cooler weather most cars can run map 4 as well. We need to see logs of this though to make sure all is good. When logging the JB4 logs...
Forum: VW/Audi Group 05-18-2022, 12:32 PM
Replies: 241
Views: 127,367
Posted By George @ BMS
I sent you a email.

I sent you a email.
Forum: VW/Audi Group 05-17-2022, 04:08 AM
Replies: 1,414
Views: 491,555
Posted By George @ BMS
Trims are high but as long as AFR is stable its...

Trims are high but as long as AFR is stable its not a concern.
Forum: VW/Audi Group 05-17-2022, 04:07 AM
Replies: 1
Views: 262
Posted By George @ BMS
As per emails if its having a issue in map 0...

As per emails if its having a issue in map 0 which is stock you chasing a boost leak.
Forum: VW/Audi Group 05-09-2022, 12:19 PM
Replies: 1,414
Views: 491,555
Posted By George @ BMS
We will look into when time allows. The AFR...

We will look into when time allows. The AFR safety is over sensitive on this firmware version and when the car is in max spool mode and the ECU runs it lean the JB4 does the autoswitch.
Forum: VW/Audi Group 05-08-2022, 08:56 AM
Replies: 1,414
Views: 491,555
Posted By George @ BMS
See what your Last safety value is. This value...

See what your Last safety value is. This value changes when the safety is used and shows last stored safety. Sometimes if LC is held for long its usually a lean trigger in first or second.
Forum: VW/Audi Group 05-07-2022, 08:30 AM
Replies: 1,134
Views: 489,879
Posted By George @ BMS
I dont. I am battling to get a car for testing....

I dont. I am battling to get a car for testing. On 500 odd cars where delivered in South Africa so they are hard to come by. Tuning wise nothing will change we will just add the ability to use boost...
Forum: VW/Audi Group 05-03-2022, 06:25 PM
Replies: 1,414
Views: 491,555
Posted By George @ BMS
On 93 you can use map 3.

On 93 you can use map 3.
Forum: VW/Audi Group 04-26-2022, 04:27 PM
Replies: 1,414
Views: 491,555
Posted By George @ BMS
We recommend you only use up to E30 mix without...

We recommend you only use up to E30 mix without the fuel plug connected. We dont include the chips on the board anymore neither so down the line if it gets sold to a B9 guy he cannot use the fuel...
Forum: VW/Audi Group 04-26-2022, 01:00 PM
Replies: 1,134
Views: 489,879
Posted By George @ BMS
If the unit has shipped settings no changes...

If the unit has shipped settings no changes needed.
Forum: VW/Audi Group 04-26-2022, 10:15 AM
Replies: 1,414
Views: 491,555
Posted By George @ BMS
If you have a set of plugs that one is brown and...

If you have a set of plugs that one is brown and one black that is the BCM connection and its a Rev2.
Forum: VW/Audi Group 04-26-2022, 08:03 AM
Replies: 1,134
Views: 489,879
Posted By George @ BMS
Due to the 95ron available there map 1 is the...

Due to the 95ron available there map 1 is the recommended map. The maps are more based on octane than hardware mods.
Forum: VW/Audi Group 04-26-2022, 06:36 AM
Replies: 1,038
Views: 337,604
Posted By George @ BMS
Yes. If you have the fuel plug and BCM connected...

Yes. If you have the fuel plug and BCM connected its not recommended to be driven without OBD so you can just unplug outside the test place.
Forum: VW/Audi Group 04-24-2022, 10:25 AM
Replies: 1,134
Views: 489,879
Posted By George @ BMS
For this model leave the FOL value at 45. You...

For this model leave the FOL value at 45.
You can lean out the AFR by lowering the fuel bias. Try make the values 20 from 4000 to 7000 and it will lean it out.
Forum: VW/Audi Group 04-24-2022, 10:24 AM
Replies: 1,414
Views: 491,555
Posted By George @ BMS
This is typically a issue with the OBD cable....

This is typically a issue with the OBD cable. Double check both ends are connected.
Forum: VW/Audi Group 04-24-2022, 10:23 AM
Replies: 1
Views: 525
Posted By George @ BMS
Usually if it does not load the firmware the unit...

Usually if it does not load the firmware the unit is bricked especially if idle etc is not good.
A replacement master chip can be found here, get the VW in the drop down menu:...
Forum: VW/Audi Group 04-15-2022, 01:39 PM
Replies: 1,134
Views: 489,879
Posted By George @ BMS
It shouldnt go over 15 when above 4500rpm. IF in...

It shouldnt go over 15 when above 4500rpm. IF in doubt email me the logs.
Forum: VW/Audi Group 04-15-2022, 09:16 AM
Replies: 1,134
Views: 489,879
Posted By George @ BMS
On spool up and peak boost the car will run...

On spool up and peak boost the car will run leaner and then enrich. It does this as its in max spool mode to get the boost up as quick as possible.
When looking at AFR you dont want to to run lean...
Forum: VW/Audi Group 04-15-2022, 08:32 AM
Replies: 1,134
Views: 489,879
Posted By George @ BMS
They are hidden maps. You can see the values by...

They are hidden maps. You can see the values by viewing the target value in logs.

Below are the settings we start with when going higher than map 3.

1500 0
2000 2
2500 3
3000 3
3500 3.5...
Forum: VW/Audi Group 04-15-2022, 05:42 AM
Replies: 1,134
Views: 489,879
Posted By George @ BMS
There are two ways to do it. If the value at...

There are two ways to do it.
If the value at 1500rpm is below 10 its additive which means it will add over the ECU request. If its over 10 it will target that as absolute boost pressure.
Forum: VW/Audi Group 04-15-2022, 05:40 AM
Replies: 1,414
Views: 491,555
Posted By George @ BMS
Sorry missed this. Yes, similar to Group 7 but...

Sorry missed this. Yes, similar to Group 7 but with different firmware.
The Group 7 do not have the chip set that solved the no boost issues for the RS3 though.
Forum: VW/Audi Group 04-14-2022, 10:58 AM
Replies: 1,134
Views: 489,879
Posted By George @ BMS
Run up to map 3 and then shoot over some logs to...

Run up to map 3 and then shoot over some logs to george@burgertuning.com and we can work it up further.
Search took 0.02 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2022, JB4tech.com