N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 58 Search: Posts Made By: tks535i
Forum: N54 Yesterday, 07:37 AM
Replies: 10
Views: 145
Posted By tks535i
I would say go with the 335is clutch especially...

I would say go with the 335is clutch especially for the price. I believe I read somewhere that LUK is the OEM brand.
Forum: N54 Yesterday, 04:06 AM
Replies: 10
Views: 145
Posted By tks535i
I know the pressure plate is different. The...

I know the pressure plate is different. The fingers are a lot thicker for a stronger clamping force. I do not know if the disk is different or not though. I have heard the 335is clutch is good for up...
Forum: N54 10-21-2019, 08:15 AM
Replies: 10
Views: 145
Posted By tks535i
335is clutch is stronger than spec stage 2. Its...

335is clutch is stronger than spec stage 2. Its close to the spec stage 2+. For the price just go with that and a dual mass flywheel. FCP euro has a LUK kit for $340
Forum: N54 10-21-2019, 06:23 AM
Replies: 10
Views: 145
Posted By tks535i
More experienced people should chime in but from...

More experienced people should chime in but from my research. The 335is (550i is the same part #) clutch should be plenty strong for you and can use a dual mass flywheel. How many miles on your car?...
Forum: Support & Log Review 10-11-2019, 09:59 AM
Replies: 6
Views: 101
Posted By tks535i
I changed it to 8psi and it didnt inject until...

I changed it to 8psi and it didnt inject until the oil warms up. And my gauge finally started working. Idk what its issue was.

FYI I couldnt get in the 12s due to clutch slippage. So thats my...
Forum: Support & Log Review 10-09-2019, 10:01 AM
Replies: 6
Views: 101
Posted By tks535i
I am using BMS Pump USA BEF. I was driving for...

I am using BMS Pump USA BEF. I was driving for about 30 mins before these runs. That enough time?

I put it at 10psi because I didnt want to inject until car warms up and JB4 is active. Is that...
Forum: Support & Log Review 10-08-2019, 05:39 PM
Replies: 6
Views: 101
Posted By tks535i
Log review after WMI install

Just got WMI installed. Using 50/50 meth to water mixture single CM10 nozzle. These runs were on 93 octane no E85. Seems to be running well but timing is still going low. Want to make sure everything...
Forum: N54 10-03-2019, 04:08 AM
Replies: 9
Views: 1,336
Posted By tks535i
I didnt notice a difference but my DVs didnt leak...

I didnt notice a difference but my DVs didnt leak like yours. I went with CP and BOV so I can install WMI.

Couple more things you should know about the relocation. I had to trim the original...
Forum: N54 10-02-2019, 07:14 AM
Replies: 9
Views: 1,336
Posted By tks535i
I just got my BMS pipe and tial BOV install...

I just got my BMS pipe and tial BOV install finished last night! I had to move the power steering reservoir about 3 inches forward and 2 inches outward. I made a simple bracket with 1/8" steel plate....
Forum: N54 09-23-2019, 06:45 AM
Replies: 9
Views: 1,336
Posted By tks535i
After sucking the fluid out of the reservoir I...

After sucking the fluid out of the reservoir I found out there is some sort of valve system in it so swapping the smaller reservoir is out of question. I am currently working on a relocation bracket...
Forum: N54 09-20-2019, 04:19 AM
Replies: 9
Views: 1,336
Posted By tks535i
BMS Charge Pipe Install in E60 with Dynamic Drive

So I got a BMS charge pipe with Tial BOV but the dynamic drive fluid reservoir on my E60 seems to be in the way. Anyone have any suggestion on how I can get this installed? Why is the dynamic drive...
Forum: Support & Log Review 09-09-2019, 10:31 AM
Replies: 21
Views: 417
Posted By tks535i
You are right sorry for confusion, but for $340...

You are right sorry for confusion, but for $340 aint bad.
Forum: Support & Log Review 09-09-2019, 09:31 AM
Replies: 21
Views: 417
Posted By tks535i
https://www.fcpeuro.com/products/bmw-clutch-kit-lu...

https://www.fcpeuro.com/products/bmw-clutch-kit-luk-oem-21207531556?ads_cmpid=352576039&ads_adid=22972407319&ads_matchtype=&ads_network=g&ads_creative=85218275839&utm_term=&ads_targetid=pla-6367999210...
Forum: Support & Log Review 09-09-2019, 04:06 AM
Replies: 21
Views: 417
Posted By tks535i
Yea I know what you are saying but if a $1400...

Yea I know what you are saying but if a $1400 clutch vs a $226 one is going to be my power limit I will be ok with that.
Forum: Support & Log Review 09-08-2019, 07:36 AM
Replies: 21
Views: 417
Posted By tks535i
Lol little bit of overkill and a lot of $$$. I am...

Lol little bit of overkill and a lot of $$$. I am reading about using the 335is/550i clutch and will probably go with that. FCP has a kit for $226.
Forum: Support & Log Review 09-06-2019, 10:48 AM
Replies: 21
Views: 417
Posted By tks535i
Tire traction is not that much of a issue with...

Tire traction is not that much of a issue with the 285 wide summer tires and electronic limited slip on a sticky well taken care of dragstrip. Clutch is whats giving up though. Know of any stronger...
Forum: Support & Log Review 09-06-2019, 04:05 AM
Replies: 21
Views: 417
Posted By tks535i
Best 1/4 mile time I got was 13.226 @ 107.6mph....

Best 1/4 mile time I got was 13.226 @ 107.6mph. Everything was going great until I decided to turn off reduced 1st gear boost. Once I did that my clutch slipped....
Forum: Support & Log Review 09-04-2019, 07:03 AM
Replies: 21
Views: 417
Posted By tks535i
Next tank I am going to fill up with just 93 and...

Next tank I am going to fill up with just 93 and see how it goes. What do you think my next upgrade should be? WMI, fuel pump or inlets?
Forum: Support & Log Review 09-03-2019, 05:29 PM
Replies: 21
Views: 417
Posted By tks535i
E40 in the tank this time, new logs to be checked...

E40 in the tank this time, new logs to be checked out please. Thinking about running at the drag strip in a couple days. Defiantly want to be sure I am healthy before I go.
Forum: Support & Log Review 08-30-2019, 03:55 AM
Replies: 21
Views: 417
Posted By tks535i
I installed my new plugs but didn't get a chance...

I installed my new plugs but didn't get a chance to do another log. Defiantly helped some. Attaching a picture of my old plugs. They had about 10k miles on them. Wanted to know if they look typical...
Forum: Support & Log Review 08-28-2019, 08:27 AM
Replies: 21
Views: 417
Posted By tks535i
The closest true E85 is a good 30mins from me....

The closest true E85 is a good 30mins from me. Everything else at Speedways are the 51% min ethanol. They use it for leftovers in the trucks. They can dump 87 in there which can be lower octane than...
Forum: Support & Log Review 08-28-2019, 04:11 AM
Replies: 31
Views: 656
Posted By tks535i
You post it here. Add an attachment of the CSV...

You post it here. Add an attachment of the CSV file.
Forum: Support & Log Review 08-28-2019, 04:09 AM
Replies: 21
Views: 417
Posted By tks535i
Thanks for checking it out Terry! I will get...

Thanks for checking it out Terry! I will get those plugs installed asap. I really wish I could run on just 93 octane. Good E85 can be hard to find around me. Is my timing typical for what I have...
Forum: Support & Log Review 08-27-2019, 05:57 PM
Replies: 21
Views: 417
Posted By tks535i
Log review

Fuel is around E30 mix. First two logs are in map 5 last two are map 1.

I installed a VRSF 7inch FMIC. Not doing as well as I thought it would, IAT getting up in 120s, and it doesnt seem to be...
Forum: Market Place - For Sale / Trade / Wanted 08-06-2019, 09:12 AM
Replies: 0
Views: 140
Posted By tks535i
WTB 7" VRSF FMIC mounting brackets for E60

Does anyone have any brackets? I asked VRSF if I can buy just the brackets but they are saying they won't sell it separate from the cooler.
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2019, N54tech.com