N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 50 Search: Posts Made By: DamnDatsun
Forum: N54 11-07-2020, 03:38 PM
Replies: 27
Views: 6,462
Posted By DamnDatsun
Back from the dead. Any info on what components...

Back from the dead. Any info on what components were used to create that bleeder line?
Forum: N54 08-23-2020, 04:22 PM
Replies: 1
Views: 465
Posted By DamnDatsun
Yes, it will perform normal

Yes, it will perform normal
Forum: N54 06-30-2020, 03:45 AM
Replies: 1,059
Views: 355,371
Posted By DamnDatsun
I'm having the exact same issue. Have you found a...

I'm having the exact same issue. Have you found a remedy?
Forum: N54 06-16-2020, 03:58 AM
Replies: 9
Views: 822
Posted By DamnDatsun
No, he is custom tuned by Wedge.

No, he is custom tuned by Wedge.
Forum: N54 06-15-2020, 09:59 AM
Replies: 5
Views: 644
Posted By DamnDatsun
I believe you can put the white sub connector...

I believe you can put the white sub connector back to stock and set menu 4-4.
Forum: Support & Log Review 03-29-2020, 12:26 PM
Replies: 4
Views: 342
Posted By DamnDatsun
Just checked don't logs, sure enough WGDC is at 0.

Just checked don't logs, sure enough WGDC is at 0.
Forum: Support & Log Review 03-29-2020, 09:50 AM
Replies: 4
Views: 342
Posted By DamnDatsun
I'm fighting the same issue recently. I'm hoping...

I'm fighting the same issue recently. I'm hoping my problem is either a hole in a wg line or maybe a fitting leaking.

I was making 17psi on a 14.5 spring. But now I'm hitting 22psi ��
Forum: N54 01-31-2020, 07:17 PM
Replies: 3,092
Views: 1,036,090
Posted By DamnDatsun
Beta firmware constantly freezes on my note 10+...

Beta firmware constantly freezes on my note 10+ running Android 10 .
Forum: N54 12-30-2019, 04:56 PM
Replies: 18
Views: 5,925
Posted By DamnDatsun
Ive seen a bunch of people talking about turning...

Ive seen a bunch of people talking about turning the ignition on (without starting the engine) and letting the o2's "warm up" for 45-60 seconds, THEN starting the engine. A bit inconvenient, but...
Forum: N54 10-12-2019, 03:52 PM
Replies: 0
Views: 1,008
Posted By DamnDatsun
Launch control device?

http://magnusmotorsports.com/wp-content/uploads/2013/04/new-launch-valve-2.jpg
https://www.maperformance.com/products/map-hydraulic-launch-control-device-for-manual-transmission-vehicles

I'm...
Forum: Support & Log Review 09-14-2019, 01:05 PM
Replies: 1
Views: 359
Posted By DamnDatsun
JB4 - 2 Step / No Lift Shift DIY...

JB4 - 2 Step / No Lift Shift DIY (https://www.1addicts.com/forums/showthread.php?t=966430)
Forum: N54 09-07-2019, 04:54 PM
Replies: 518
Views: 177,437
Posted By DamnDatsun
I had David do an e50 tune when I had stock twins...

I had David do an e50 tune when I had stock twins and it was the best thing I did to my car.

Now I'm having him tune my 6466 single turbo conversion. I was slightly worried I went too large in my...
Forum: Support & Log Review 08-22-2019, 08:13 AM
Replies: 14
Views: 841
Posted By DamnDatsun
Thumbs up I'm definitely open to any suggestions you have...

I'm definitely open to any suggestions you have for map 3.
Forum: Support & Log Review 08-21-2019, 06:15 PM
Replies: 14
Views: 841
Posted By DamnDatsun
That adjustment got me up to 22.6psi in map 4....

That adjustment got me up to 22.6psi in map 4. But my high pressure fuel pump dipped to 9 so I think I'll step back to map 3. Thanks again for all of your help!

I attached a map 4 log.
Forum: Support & Log Review 08-20-2019, 03:38 PM
Replies: 14
Views: 841
Posted By DamnDatsun
With FF set to 100, I was able to pretty much...

With FF set to 100, I was able to pretty much reach Target of 20psi on map3.

I switched to map4 to see if there new FF setting would let me reach that target psi also. Unfortunately no. I'm...
Forum: Support & Log Review 08-19-2019, 03:18 PM
Replies: 14
Views: 841
Posted By DamnDatsun
Map 3 with dwp and db adjusted. Side note,...

Map 3 with dwp and db adjusted.

Side note, I've done the Mac solenoid test suggested by y Terry on a YouTube video I found. Car ignition on but not started, Mac solenoid clicks at part throttle...
Forum: Support & Log Review 08-18-2019, 04:13 PM
Replies: 14
Views: 841
Posted By DamnDatsun
My jb4 settings

My jb4 settings
Forum: General Tech Support, Tuning Advice, Logs, and Help Me Posts 08-17-2019, 04:55 PM
Replies: 23
Views: 4,472
Posted By DamnDatsun
X2. I'm literally having the same issues with the...

X2. I'm literally having the same issues with the Mac solenoid. Clicking at haha throttle, but not at full throttle. Can't seem to hit map 3 Target
Forum: Support & Log Review 08-17-2019, 04:47 PM
Replies: 14
Views: 841
Posted By DamnDatsun
Duty bias @ 50

Duty bias @ 50
Forum: Support & Log Review 08-15-2019, 03:03 PM
Replies: 14
Views: 841
Posted By DamnDatsun
I used the jb4 single turbo the map. Non e85 I...

I used the jb4 single turbo the map. Non e85
I attached a map 3 CSV file.
Forum: N54 08-14-2019, 05:45 PM
Replies: 3,092
Views: 1,036,090
Posted By DamnDatsun
I just installed a 6466 precision turbo on my...

I just installed a 6466 precision turbo on my n54. I got the kit used, so I'm not sure on the waste gate spring psi.

Map1 shows about 16psi. When I switched to map 2, boost spiked at ~17 psi. So,...
Forum: Support & Log Review 08-14-2019, 03:48 PM
Replies: 14
Views: 841
Posted By DamnDatsun
6466 single turbo logs+ question.

I just installed a 6466 precision turbo on my n54. I got the kit used, so I'm not sure on the waste gate spring psi.

Map1 shows about 16psi. When I switched to map 2, boost spiked at ~17 psi. So,...
Forum: N54 06-27-2019, 11:22 AM
Replies: 33
Views: 6,171
Posted By DamnDatsun
Did you use boost by gear in the jb4? Love your...

Did you use boost by gear in the jb4? Love your videos.
Forum: N54 06-25-2019, 06:26 AM
Replies: 11,666
Views: 5,725,649
Posted By DamnDatsun
Try lowering menu 10 a few hundred rpm.

Try lowering menu 10 a few hundred rpm.
Forum: Support & Log Review 04-05-2019, 11:08 AM
Replies: 0
Views: 305
Posted By DamnDatsun
Custom BEF not map 6?

When using a custom BEF map6, do the other maps do anything other than change the boost target?
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2020, N54tech.com