N54Tech.com - International Turbo Racing Discussion
Go Back   N54Tech.com - International Turbo Racing Discussion > Search Forums
Reload this Page Search Results
Showing results 1 to 25 of 87 Search: Posts Made By: mattgu40
Forum: N54 08-09-2020, 02:48 AM
Replies: 6
Views: 603
Posted By mattgu40
got to the bottom of this ? Same issues...

got to the bottom of this ?

Same issues here Nothing work since PI
Forum: N54 08-05-2020, 12:24 AM
Replies: 3
Views: 485
Posted By mattgu40
If you are planning to PI meth 550 is more than...

If you are planning to PI meth 550 is more than suffisent IMO
Forum: Support & Log Review 05-23-2020, 11:07 PM
Replies: 1
Views: 168
Posted By mattgu40
165k km GC 1.0 meth PI

for review car feels great.
20 000km on vargas GC 1.0
100%meth PI + pump gas.
Jb4 + custom BEF. PR coils .22 gap plugs

Why are trims bottoming out ? Too much meth? Should i run lower...
Forum: Support & Log Review 02-25-2020, 07:15 PM
Replies: 46
Views: 2,131
Posted By mattgu40
Toughts ?

Toughts ?
Forum: Support & Log Review 02-20-2020, 11:33 AM
Replies: 46
Views: 2,131
Posted By mattgu40
Would like some more info too 26 psi trims 0-8 ...

Would like some more info too 26 psi trims 0-8 too much meth ?..
port injection meth
Forum: N54 02-13-2020, 10:24 PM
Replies: 1,054
Views: 348,284
Posted By mattgu40
Same would like some detailed installation...

Same would like some detailed installation instruction as it all changed 100 times
Forum: N54 01-18-2020, 06:28 AM
Replies: 1,054
Views: 348,284
Posted By mattgu40
Will do so once weather allow then report here. ...

Will do so once weather allow then report here.

Thank you
Forum: N54 01-16-2020, 01:25 AM
Replies: 1,054
Views: 348,284
Posted By mattgu40
do i need to physically remove the relay for this...

do i need to physically remove the relay for this ?
Forum: N54 01-15-2020, 09:59 AM
Replies: 1,054
Views: 348,284
Posted By mattgu40
here is a recentish WOT pull, and 2 antilag/...

here is a recentish WOT pull, and 2 antilag/ 2step attempt a while back all i got for now.

BMS Pi controller Meth PI, PR coil...
Forum: N54 01-13-2020, 12:07 AM
Replies: 1,054
Views: 348,284
Posted By mattgu40
Anyone had issues with antilag/2step and...

Anyone had issues with antilag/2step and aftermarket coil setup ?
i think my PR coils are what causing the issues.

when attempting rolling antilag with volume down and full throttle cause the car...
Forum: N54 12-05-2019, 02:23 AM
Replies: 260
Views: 93,097
Posted By mattgu40
Everything been running good for a while now,...

Everything been running good for a while now, appart from 2step/antilag and NLS

Looking at option for the best way to integrate an additional nozzle in the charge pipe to reduce IAT at sensor.
...
Forum: N54 11-18-2019, 07:34 PM
Replies: 48
Views: 3,130
Posted By mattgu40
Exhaust leak or ***** vibrating on something /...

Exhaust leak or ***** vibrating on something / together.

Maybe the mid cats are in bad shape. Could add resonators
Forum: Support & Log Review 10-10-2019, 04:41 AM
Replies: 4
Views: 441
Posted By mattgu40
Having the same issue here IJE0S. Clutch...

Having the same issue here IJE0S.

Clutch pedal input verified and working
switch to a older firmware and 2 step work

newest firmware with BEF tables changed for antilag
- 2step alone no rev...
Forum: Support & Log Review 08-21-2019, 06:34 AM
Replies: 2
Views: 564
Posted By mattgu40
Did you removed the metal disc holding the bolt ?

Did you removed the metal disc holding the bolt ?
Forum: Support & Log Review 08-13-2019, 10:51 AM
Replies: 7
Views: 491
Posted By mattgu40
Got refused the dyno as he seen the xdrive tag . ...

Got refused the dyno as he seen the xdrive tag . Got xdelete but he said if something goes wrong. Suggested tu pull front driveshaft in parking lot he still declined.

Hope the knock tables are...
Forum: Support & Log Review 08-12-2019, 03:00 PM
Replies: 7
Views: 491
Posted By mattgu40
Any way to fix the problems without changing the...

Any way to fix the problems without changing the custum tune as he is away
Forum: Support & Log Review 08-12-2019, 11:56 AM
Replies: 7
Views: 491
Posted By mattgu40
Dyno tomorrow Log Review

Hi there.

going on the dyno tomorrow morning and would like some fine tuning and advices before. will post after

JB4+ Custom BEF
Pump+ meth port injection 550cc
Fbo
VTT GC 1 with inlet and...
Forum: JB4 Mobile 07-03-2019, 04:26 AM
Replies: 18
Views: 5,629
Posted By mattgu40
Good to know, i would like to retain Bluetooth...

Good to know, i would like to retain Bluetooth functions will see if i can tap a usb wire directly into the bluetooth adapter if really stuck and nothing work
Forum: JB4 Mobile 06-28-2019, 03:56 AM
Replies: 18
Views: 5,629
Posted By mattgu40
last resort is mirror link phone to screen once...

last resort is mirror link phone to screen once connected to JB4.
Forum: JB4 Mobile 06-27-2019, 09:35 AM
Replies: 18
Views: 5,629
Posted By mattgu40
and i have discarded my data cable, nice

and i have discarded my data cable, nice
Forum: JB4 Mobile 06-27-2019, 03:03 AM
Replies: 18
Views: 5,629
Posted By mattgu40
Cant wait to find out if my 10.25 inch display...

Cant wait to find out if my 10.25 inch display will be JB4 compatible through bluetooth.
i would be terribly dissapointed if not

here are the specs
e92
*Snapdragon 625 (MSM8953)n- 8 core, A53,...
Forum: N54 04-08-2019, 01:21 PM
Replies: 138
Views: 27,597
Posted By mattgu40
Anyone had clearance issue between cyl 1 runner...

Anyone had clearance issue between cyl 1 runner and filter housing bolt
Forum: N54 03-01-2019, 12:19 AM
Replies: 260
Views: 93,097
Posted By mattgu40
Interesting setup if it works im tempted to do...

Interesting setup if it works im tempted to do the exact same,

cant find info on the pressure sensor, is it a E9x n55 LPFP sensor ?
Forum: N54 02-19-2019, 06:33 AM
Replies: 260
Views: 93,097
Posted By mattgu40
Im i the only one who dont get any meth flow on...

Im i the only one who dont get any meth flow on map 3 and 5. Meth remain at 0 in logs.

Works good on map 1, 2, 7.

Any ways around it

also, 2step and and antilag are not working. anything...
Forum: N54 02-14-2019, 01:08 PM
Replies: 8
Views: 1,207
Posted By mattgu40
yes there is a 1 way clutch on our alternators. ...

yes there is a 1 way clutch on our alternators.

something to do with load management, engine speed and engine shut off.

mine had a bit of axial play on the bearing itself. loud audible click...
Search took 0.01 seconds.

 
Forum Jump



vBulletin Skin developed by: vBStyles.com
Copyright 2007 - 2020, N54tech.com