N54Tech.com - International Turbo Racing Discussion

N54Tech.com - International Turbo Racing Discussion (https://www.n54tech.com/forums/index.php)
-   N55 (https://www.n54tech.com/forums/forumdisplay.php?f=16)
-   -   JB4 F10 535i N55 PWG (https://www.n54tech.com/forums/showthread.php?t=55380)

naoaki 10-07-2018 04:21 PM

JB4 F10 535i N55 PWG
 
Hey, guys I have installed jb4 PWG for F10 535i. The condition of the engine is bad and you can not control BC. Of course I followed the installation procedure. As I was investigating, this JB 4 should have a red power line, but it is not. I mailed to BMS support but it seems like a holiday on Sunday and I have no reply. Can anyone give me a complete picture of F10 535i jb4 PWG type A wiring? I am very confused. Thank you in advance for all the responses.

Payam @ BMS 10-08-2018 07:54 AM

Quote:

Originally Posted by naoaki (Post )
Hey, guys I have installed jb4 PWG for F10 535i. The condition of the engine is bad and you can not control BC. Of course I followed the installation procedure. As I was investigating, this JB 4 should have a red power line, but it is not. I mailed to BMS support but it seems like a holiday on Sunday and I have no reply. Can anyone give me a complete picture of F10 535i jb4 PWG type A wiring? I am very confused. Thank you in advance for all the responses.

You more than likely have V2 if you have no power wire which is actually better.

BC controls need to be enabled on the 5 series. FUD Bit 1 needs to be enabled.


All times are GMT -7. The time now is 01:19 PM.


Copyright 2007 - 2020, N54tech.com