N54Tech.com - International Turbo Racing Discussion

N54Tech.com - International Turbo Racing Discussion (https://www.n54tech.com/forums/index.php)
-   N20, N26 (https://www.n54tech.com/forums/forumdisplay.php?f=5)
-   -   PWG but getting EWG errors after engine swap (https://www.n54tech.com/forums/showthread.php?t=63308)

MikeW 09-13-2020 08:01 PM

PWG but getting EWG errors after engine swap
 
I've replaced an old N20 with a new one- old one had a pneumatic waste-gate and the newer engine was wired for an electronic one. DME is from the old engine.

Since the new engine didn't come with a turbo i had to swap the old turbo in (PWG).

Is it possible to code out the EWG? Right now i'm getting errors related to undervoltage/sensors at the wastegate- the 5 pin plug or whatever is just hanging there since there's nothing for it to plug into.

No other issues post replacement, drove it home in the 'limited power' mode no problem.
Is this something I'd have to do with modded firmware?


All times are GMT -7. The time now is 05:11 AM.


Copyright 2007 - 2020, N54tech.com