N54Tech.com - International Turbo Racing Discussion

N54Tech.com - International Turbo Racing Discussion (https://www.n54tech.com/forums/index.php)
-   N20, N26 (https://www.n54tech.com/forums/forumdisplay.php?f=5)
-   -   PWG jb4 on X1 (https://www.n54tech.com/forums/showthread.php?t=60284)

G0chestg0ch 11-25-2019 05:29 AM

PWG jb4 on X1
 
Hi,

Just by mistake I bought pwg jb4, not the one I actually needed.
Is it possible to flash another (x1 compatible) firmware and make it work with my car?

Terry @ BMS 11-27-2019 08:58 PM

Yes the X1 can use either system.

G0chestg0ch 11-28-2019 08:40 AM

Quote:

Originally Posted by Terry @ BMS (Post )
Yes the X1 can use either system.

Hi Terry,
Thanks for attention.

So, Can I directly install my pwg jb4 on X1 or I need flash it or buy another cabling?

Terry @ BMS 11-29-2019 02:53 PM

Try installing it and lets see what happens, and go from there. :)

G0chestg0ch 12-06-2019 08:25 AM

4 Attachment(s)
Hi,

I have successfully connected the jb4 to the map and tmap sensors, to the fuel rail connector, brown CAN wire to the red bundle, green CAN wire to the blue wire bundle and the black wire to the chassis ground.
The green and brown CAN wires i took from the jb4's obd2 connector, because my jb4 has not dedicated brown and green wires.
On the other side of the engine I could not find a connector for Pneumatic westgate solenoid.
Now I have two questions:
1. Have I connected the brown and green wires correctly?
2. Can you indicate the location of pwg solenoid connector?

btw,
I tried to test the jb4's, but nothing happened when I put the volume down and next song buttons together with turned on ignition :(

Terry @ BMS 12-07-2019 01:32 PM

I can't see where the green or brown wires are connected. They attach in the ECU box area, not to OBDII.

Also without a JB4 CSV log can't see what firmware you have loaded.


All times are GMT -7. The time now is 11:13 PM.


Copyright 2007 - 2020, N54tech.com