Log review map6 22psi
 

thanks

Pure stage 2 turbo
Dorch stage 2 HPFP
Fuel it stage 2 LPFP
VRSF intercooler
VRSF down pipe
Burger filter
FTP piping inlet boost pipe etc
Burger charge pipe
E85 fuel

You are maxing trims for most of all the pull. Timing starts to get pretty sporadic in 4th gear as well. Are you on straight E85?

yes straight E85. we adjusted some things to correct. here is one map

DME dropped with the log, and would be more flash related. What flash is your car currently running? Please provide some additional logs to see if it's a trend or if it was just a hiccup.

running ps2 e85 map. heres a couple logs from my dyno session today

heres todays dyno
 

503HP and 560Tq

Map 6 looks pretty normal. A little left in the turbo but there a couple timing corrections...not bad though.

new plugs gapped to .20 and new coil packs. what do you think the timing issue might be?

Pretty normal. Have you checked your local suppliers ethanol content recently?

no, or should i get a analyzer from fuel it?

Its always best to know and monitor your ethanol content as it can vary greatly.

how does it connect to the JB4? can you send me link

You'll need to purchase the flex fuel kit and then you'll connect the white signal wire to pin location 16 on the JB4's DB25 connector and enable bit 1 under the WMI/E85 options.

https://rz2n4uvipxrtakmu-54960062603...hassis-n55-bmw

but i have a blue wire connected there for the EWG kit in that pin

Then you can connect it to pin location 3 and enable bit 0.