N54Tech.com - International Turbo Racing Discussion

N54Tech.com - International Turbo Racing Discussion (https://www.n54tech.com/forums/index.php)
-   Support & Log Review (https://www.n54tech.com/forums/forumdisplay.php?f=44)
-   -   JB4 Kicking out of Map 3 (https://www.n54tech.com/forums/showthread.php?t=58139)

FuelTuner 05-23-2019 11:03 AM

JB4 Kicking out of Map 3
 
1 Attachment(s)
Hey everyone,
Whats the parameters that dictate Map 3 kicking out into failsafe condition ?
I have the genaric map 3 settings , except boost cut set to 20 psi
2008 N54 335i
Pure Turbos
JB4 Meth
Intake / ********* , Exhaust , BOV, Intercooler, newplugs
MHD BEF ( pump gas usa )
JB4 meth w/ twin nozzles 70/30 mix
91 oct

I personally dont see anything in the log that would show an issue .... but again I do not know what ultimately causes the map to swap over to map 4 . I did not put this car together , install any parts . So I am assuming that the meth system is funtioning correctly as it shows flow and the system was purged and working .
Car was smoke tested intake and exhaust .
Log is attached.
Boost failsafe 20 psi
Default wg position 60
PID gain 25
Auto shift boost redux 60
FF WG adapt 72
Open Loop 70
Meth safe mode 0
Meth trigger mode 0
Max boost 1st 12
Max boost 2nd 0
Max boost 3rd 0

Dave @ BMS/Fuel-It! 05-24-2019 12:35 AM

Quote:

Originally Posted by FuelTuner (Post )
Hey everyone,
Whats the parameters that dictate Map 3 kicking out into failsafe condition ?
I have the genaric map 3 settings , except boost cut set to 20 psi
2008 N54 335i
Pure Turbos
JB4 Meth
Intake / ********* , Exhaust , BOV, Intercooler, newplugs
MHD BEF ( pump gas usa )
JB4 meth w/ twin nozzles 70/30 mix
91 oct

I personally dont see anything in the log that would show an issue .... but again I do not know what ultimately causes the map to swap over to map 4 . I did not put this car together , install any parts . So I am assuming that the meth system is funtioning correctly as it shows flow and the system was purged and working .
Car was smoke tested intake and exhaust .
Log is attached.
Boost failsafe 20 psi
Default wg position 60
PID gain 25
Auto shift boost redux 60
FF WG adapt 72
Open Loop 70
Meth safe mode 0
Meth trigger mode 0
Max boost 1st 12
Max boost 2nd 0
Max boost 3rd 0

Your throwing safety 1- boost safety

Yours is set to 18- bump that up to 19 or 20- SAVE & relog


All times are GMT -7. The time now is 10:27 PM.


Copyright 2007 - 2018, N54tech.com